ترغب بنشر مسار تعليمي؟ اضغط هنا

Substrate Dependent Resistive Switching in Amorphous-HfOx Memristors: An Experimental and Computational Investigation

191   0   0.0 ( 0 )
 نشر من قبل Pradip Basnet
 تاريخ النشر 2019
  مجال البحث فيزياء
والبحث باللغة English




اسأل ChatGPT حول البحث

While two-terminal HfOX (x<2) memristor devices have been studied for ion transport and current evolution, there have been limited reports on the effect of the long-range thermal environment on their performance. In this work, amorphous-HfOX based memristor devices on two different substrates, thin SiO2(280 nm)/Si and glass, with different thermal conductivities in the range from 1.2 to 138 W/m-K were fabricated. Devices on glass substrates exhibit lower reset voltage, wider memory window and, in turn, a higher performance window. In addition, the devices on glass show better endurance than the devices on the SiO2/Si substrate. These devices also show non-volatile multi-level resistances at relatively low operating voltages which is critical for neuromorphic computing applications. A Multiphysics COMSOL computational model is presented that describes the transport of heat, ions and electrons in these structures. The combined experimental and COMSOL simulation results indicate that the long-range thermal environment can have a significant impact on the operation of HfOx-based memristors and that substrates with low thermal conductivity can enhance switching performance.



قيم البحث

اقرأ أيضاً

242 - Yao Shuai , Xin Ou , Chuangui Wu 2012
BiFeO3 thin films have been deposited on Pt/sapphire and Pt/Ti/SiO2/Si substrates with pulsed laser deposition using the same growth conditions, respectively. Au was sputtered as the top electrode. The microscopic structure of the thin film varies by changing the underlying substrate. Thin films on Pt/sapphire are not resistively switchable due to the formation of Schottky contacts at both the top and the bottom interface. However, thin films on Pt/Ti/SiO2/Si exhibit an obvious resistive switching behavior under forward bias. The conduction mechanisms in BiFeO3 thin films on Pt/sapphire and Pt/Ti/SiO2/Si substrates are discussed to understand the different resistive switching behaviors.
We studied the resistive memory switching in pulsed laser deposited amorphous LaHoO3 (LHO) thin films for non-volatile resistive random access memory (RRAM) applications. Nonpolar resistive switching (RS) was achieved in PtLHOPt memory cells with all four possible RS modes ( positive unipolar, positive bipolar, negative unipolar, and negative bipolar) having high RON and ROFF ratios (in the range of 104 to 105) and non-overlapping switching voltages (set voltage, VON 3.6 to 4.2 V and reset voltage, VOFF 1.3 to 1.6 V) with a small variation of about 5 to 8 percent. X ray photoelectron spectroscopic studies together with temperature dependent switching characteristics revealed the formation of metallic holmium (Ho) and oxygen vacancies (VO) constituted conductive nanofilaments (CNFs) in the low resistance state (LRS). Detailed analysis of current versus voltage characteristics further corroborated the formation of CNFs based on metal like (Ohmic) conduction in LRS. Simmons Schottky emission was found to be the dominant charge transport mechanism in the high resistance state.
69 - J. Kim , Y. V. Pershin , M. Yin 2019
It has been suggested that all resistive-switching memory cells are memristors. The latter are hypothetical, ideal devices whose resistance, as originally formulated, depends only on the net charge that traverses them. Recently, an unambiguous test h as been proposed [J. Phys. D: Appl. Phys. {bf 52}, 01LT01 (2019)] to determine whether a given physical system is indeed a memristor or not. Here, we experimentally apply such a test to both in-house fabricated Cu-SiO2 and commercially available electrochemical metallization cells. Our results unambiguously show that electrochemical metallization memory cells are not memristors. Since the particular resistance-switching memories employed in our study share similar features with many other memory cells, our findings refute the claim that all resistance-switching memories are memristors. They also cast doubts on the existence of ideal memristors as actual physical devices that can be fabricated experimentally. Our results then lead us to formulate two memristor impossibility conjectures regarding the impossibility of building a model of physical resistance-switching memories based on the memristor model.
We report on resistive switching of memristive electrochemical metallization devices using 3D kinetic Monte Carlo simulations describing the transport of ions through a solid state electrolyte of an Ag/TiO$_{text{x}}$/Pt thin layer system. The ion tr ansport model is consistently coupled with solvers for the electric field and thermal diffusion. We show that the model is able to describe not only the formation of conducting filaments but also its dissolution. Furthermore, we calculate realistic current-voltage characteristics and resistive switching kinetics. Finally, we discuss in detail the influence of both the electric field and the local heat on the switching processes of the device.
Films produced by assembling bare gold clusters well beyond the electrical percolation threshold show a resistive switching behavior whose investigation has started only recently. Here we address the challenge to charaterize the resistance of a nanog ranular film starting from limited information on the structure at the microscopic scale by the means of Bruggemans approach to multicomponent media, within the framework of Effective Medium Approximations. The approach is used to build a model that proves that the observed resistive switching can be explained by thermally regulated local structural rearrangements.
التعليقات
جاري جلب التعليقات جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
mircosoft-partner

هل ترغب بارسال اشعارات عن اخر التحديثات في شمرا-اكاديميا