اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدNonpolar resistive memory switching with all four possible resistive switching modes in amorphous ternary rare earth LaHoO3 thin films
137
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We studied the resistive memory switching in pulsed laser deposited amorphous LaHoO3 (LHO) thin films for non-volatile resistive random access memory (RRAM) applications. Nonpolar resistive switching (RS) was achieved in PtLHOPt memory cells with all four possible RS modes ( positive unipolar, positive bipolar, negative unipolar, and negative bipolar) having high RON and ROFF ratios (in the range of 104 to 105) and non-overlapping switching voltages (set voltage, VON 3.6 to 4.2 V and reset voltage, VOFF 1.3 to 1.6 V) with a small variation of about 5 to 8 percent. X ray photoelectron spectroscopic studies together with temperature dependent switching characteristics revealed the formation of metallic holmium (Ho) and oxygen vacancies (VO) constituted conductive nanofilaments (CNFs) in the low resistance state (LRS). Detailed analysis of current versus voltage characteristics further corroborated the formation of CNFs based on metal like (Ohmic) conduction in LRS. Simmons Schottky emission was found to be the dominant charge transport mechanism in the high resistance state.
قيم البحث
اقرأ أيضاً
BiFeO3 thin films have been deposited on Pt/sapphire and Pt/Ti/SiO2/Si substrates with pulsed laser deposition using the same growth conditions, respectively. Au was sputtered as the top electrode. The microscopic structure of the thin film varies by
changing the underlying substrate. Thin films on Pt/sapphire are not resistively switchable due to the formation of Schottky contacts at both the top and the bottom interface. However, thin films on Pt/Ti/SiO2/Si exhibit an obvious resistive switching behavior under forward bias. The conduction mechanisms in BiFeO3 thin films on Pt/sapphire and Pt/Ti/SiO2/Si substrates are discussed to understand the different resistive switching behaviors.
Films produced by assembling bare gold clusters well beyond the electrical percolation threshold show a resistive switching behavior whose investigation has started only recently. Here we address the challenge to charaterize the resistance of a nanog
ranular film starting from limited information on the structure at the microscopic scale by the means of Bruggemans approach to multicomponent media, within the framework of Effective Medium Approximations. The approach is used to build a model that proves that the observed resistive switching can be explained by thermally regulated local structural rearrangements.
The increasing demand for high-density data storage leads to an increasing interest in novel memory concepts with high scalability and the opportunity of storing multiple bits in one cell. A promising candidate is the redox-based resistive switch rep
ositing the information in form of different resistance states. For reliable programming, the underlying physical parameters need to be understood. We reveal that the programmable resistance states are linked to internal series resistances and the fundamental nonlinear switching kinetics. The switching kinetics of Ta$_{2}$O$_{5}$-based cells was investigated in a wide range over 15 orders of magnitude from 250 ps to 10$^{5}$ s. We found strong evidence for a switching speed of 10 ps which is consistent with analog electronic circuit simulations. On all time scales, multi-bit data storage capabilities were demonstrated. The elucidated link between fundamental material properties and multi-bit data storage paves the way for designing resistive switches for memory and neuromorphic applications.
Electrical characteristics of a Co/TiO_x/Co resistive memory device, fabricated by two different methods are reported. In addition to crystalline TiO_2 layers fabricated via conventional atomic layer deposition (ALD), an alternative method has been e
xamined, where TiO_x nanoparticle layers were fabricated via sol-gel. The different devices have shown different hysteresis loops with a unique crossing point for the sol-gel devices. A simple qualitative model is introduced to describe the different current-voltage behaviours by suggesting only one active metal-oxide interface for the ALD devices and two active metal-oxide interfaces for the sol-gel devices. Furthermore, we show that the resistive switching behaviour could be easily tuned by proper interface engineering and that despite having a similar active material, different fabrication methods can lead to dissimilar resistive switching properties.
The development prospects of memristive elements for non-volatile memory with use of the metal-dielectric-metal sandwich structures with a thin oxide layer are due to the possibility of reliable forming the sustained functional states with quantized
resistance. In the paper we study the properties of fabricated memristors based on the non-stoichiometric $ZrO_2$ nanotubes in different resistive switching modes. Anodic oxidation of the $Zr$ foil has been used to synthesize a zirconia layer of $1.7$ $mu$$m$ thickness, consisting of an ordered array of vertically oriented nanotubes with outer diameter of 75 nm. $Zr/ZrO_2/Au$ sandwich structures have been fabricated by mask magnetron deposition. The effects of resistive switching in the $Zr/ZrO_2/Au$ memristors in unipolar and bipolar modes have been investigated. The resistance ratios $geq3cdot10^4$ between high-resistance (HRS) and low-resistance (LRS) states have been evaluated. It has been founded the conductivity of LRS is quantized in a wide range with minimum value of $0.5G_0=38.74$ $mu$$S$ due to the formation of quantum conductors based on oxygen vacancies ($V_O$). Resistive switching mechanisms of $Zr/ZrO_2/Au$ memristors with allowing for migration of $V_O$ in an applied electric field have been proposed. It has been shown that the ohmic type and space charge limited conductivities are realized in the LRS and HRS, correspondingly. We present the results which can be used for development of effective memristors based on functional $Zr/ZrO_2/Au$ nanolayered structure with multiple resistive states and high resistance ratio.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
