اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدExploring the Band Structure of Wurtzite InAs Nanowires Using Photocurrent Spectroscopy
347
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We use polarized photocurrent spectroscopy in a nanowire device to investigate the band structure of hexagonal Wurtzite InAs. Signatures of optical transitions between four valence bands and two conduction bands are observed which are consistent with the symmetries expected from group theory. The ground state transition energy identified from photocurrent spectra is seen to be consistent with photoluminescence emitted from a cluster of nanowires from the same growth substrate. From the energies of the observed bands we determine the spin orbit and crystal field energies in Wurtzite InAs. This information is essential to the development of crystal phase engineering of this important III-V semiconductor.
قيم البحث
اقرأ أيضاً
Polarization dependent Raman scattering experiments realized on single GaAs nanowires with different percentages of zinc-blende and wurtzite structure are presented. The selection rules for the special case of nanowires are found and discussed. In th
e case of zinc-blende, the transversal optical mode E1(TO) at 267 cm-1 exhibits the highest intensity when the incident and analyzed polarization are parallel to the nanowire axis. This is a consequence of the nanowire geometry and dielectric mismatch with the environment, and in quite good agreement with the Raman selection rules. We also find a consistent splitting of 1 cm-1 of the E1(TO). The transversal optical mode related to the wurtzite structure, E2H, is measured between 254 and 256 cm-1, depending on the wurtzite content. The azymutal dependence of E2H indicates that the mode is excited with the highest efficiency when the incident and analyzed polarization are perpendicular to the nanowire axis, in agreement with the selection rules. The presence of strain between wurtzite and zinc-blende is analyzed by the relative shift of the E1(TO) and E2H modes. Finally, the influence of the surface roughness in the intensity of the longitudinal optical mode on {110} facets is presented.
The electronic properties and nanostructure of InAs nanowires are correlated by creating multiple field effect transistors (FETs) on nanowires grown to have low and high defect density segments. 4.2 K carrier mobilities are ~4X larger in the nominall
y defect-free segments of the wire. We also find that dark field optical intensity is correlated with the mobility, suggesting a simple route for selecting wires with a low defect density. At low temperatures, FETs fabricated on high defect density segments of InAs nanowires showed transport properties consistent with single electron charging, even on devices with low resistance ohmic contacts. The charging energies obtained suggest quantum dot formation at defects in the wires. These results reinforce the importance of controlling the defect density in order to produce high quality electrical and optical devices using InAs nanowires.
Quantum wells in InAs/GaSb heterostructures can be tuned to a topological regime associated with the quantum spin Hall effect, which arises due to an inverted band gap and hybridized electron and hole states. Here, we investigate electron-hole hybrid
ization and the fate of the quantum spin Hall effect in a quasi one-dimensional geometry, realized in a core-shell-shell nanowire with an insulator core and InAs and GaSb shells. We calculate the band structure for an infinitely long nanowire using $mathbf{k cdot p}$ theory within the Kane model and the envelope function approximation, then map the result onto a BHZ model which is used to investigate finite-length wires. Clearly, quantum spin Hall edge states cannot appear in the core-shell-shell nanowires which lack one-dimensional edges, but in the inverted band-gap regime we find that the finite-length wires instead host localized states at the wire ends. These end states are not topologically protected, they are four-fold degenerate and split into two Kramers pairs in the presence of potential disorder along the axial direction. However, there is some remnant of the topological protection of the quantum spin Hall edge states in the sense that the end states are fully robust to (time-reversal preserving) angular disorder, as long as the bulk band gap is not closed.
We report on the heterogeneous nucleation of catalyst-free InAs nanowires on Si (111) substrates by chemical beam epitaxy. We show that nanowire nucleation is enhanced by sputtering the silicon substrate with energetic particles. We argue that partic
le bombardment introduces lattice defects on the silicon surface that serve as preferential nucleation sites. The formation of these nucleation sites can be controlled by the sputtering parameters, allowing the control of nanowire density in a wide range. Nanowire nucleation is accompanied by unwanted parasitic islands, but by careful choice of annealing and growth temperature allows to strongly reduce the relative density of these islands and to realize samples with high nanowire yield.
We report a significant and persistent enhancement of the conductivity in free-standing non intentionnaly doped InAs nanowires upon irradiation in ultra high vacuum. Combining four-point probe transport measurements performed on nanowires with differ
ent surface chemistries, field-effect based measurements and numerical simulations of the electron density, the change of the conductivity is found to be caused by the increase of the surface free carrier concentration. Although an electron beam of a few keV, typically used for the inspection and the processing of materials, propagates through the entire nanowire cross-section, we demonstrate that the nanowire electrical properties are predominantly affected by radiation-induced defects occuring at the nanowire surface and not in the bulk.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
