اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدExploring the sources of p-mode frequency shifts in the CoRoT target HD 49933
121
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
The oscillations of the solar-like star HD 49933 have been observed thoroughly by CoRot. Two dozens of frequency shifts, which are closely related with the change in magnetic activity, have been measured. To explore the effects of the magnetic activity on the frequency shifts, we calculate frequency shifts for the radial and $l = 1$ p-modes of HD 49933 with the general variational method, which evaluates the shifts using a spatial integral of the product of a kernel and some sources. The theoretical frequency shifts well reproduce the observation. The magnitudes and positions of the sources are determined according to the $chi^2$ criterion. We predict the source that contributes to both $l = 0$ and $l = 1$ modes is located at $0.48 - 0.62$Mm below the stellar surface. In addition, based on the assumption that $A_{0}$ is proportional to the change in the MgII activity index $Delta{i}_{MgII}$, we obtained that the change of MgII index between minimum and maximum of HD 49933 cycle period is about 0.665. The magnitude of the frequency shifts compared to the Sun already told us that HD 49933 is much more active than the Sun, which is further confirmed in this paper. Furthermore, our calculation on the frequency shifts of $l = 1$ modes indicates the variation of turbulent velocity in the stellar convective zone may be an important source for the $l = 1$ shifts.
قيم البحث
اقرأ أيضاً
From the seismic data obtained by CoRoT for the star HD 49933 it is possible, as for the Sun, to constrain models of the excitation of acoustic modes by turbulent convection. We compare a stochastic excitation model described in Paper I (arXiv:0910.4
027) with the asteroseismology data for HD 49933, a star that is rather metal poor and significantly hotter than the Sun. Using the mode linewidths measured by CoRoT for HD 49933 and the theoretical mode excitation rates computed in Paper I, we derive the expected surface velocity amplitudes of the acoustic modes detected in HD 49933. Using a calibrated quasi-adiabatic approximation relating the mode amplitudes in intensity to those in velocity, we derive the expected values of the mode amplitude in intensity. Our amplitude calculations are within 1-sigma error bars of the mode surface velocity spectrum derived with the HARPS spectrograph. The same is found with the mode amplitudes in intensity derived for HD 49933 from the CoRoT data. On the other hand, at high frequency, our calculations significantly depart from the CoRoT and HARPS measurements. We show that assuming a solar metal abundance rather than the actual metal abundance of the star would result in a larger discrepancy with the seismic data. Furthermore, calculations that assume the ``new solar chemical mixture are in better agreement with the seismic data than those that assume the ``old solar chemical mixture. These results validate, in the case of a star significantly hotter than the Sun and Alpha Cen A, the main assumptions in the model of stochastic excitation. However, the discrepancies seen at high frequency highlight some deficiencies of the modelling, whose origin remains to be understood.
Solar-like oscillations are stochastically excited by turbulent convection at the surface layers of the stars. We study the role of the surface metal abundance on the efficiency of the stochastic driving in the case of the CoRoT target HD 49933. We c
ompute two 3D hydrodynamical simulations representative -- in effective temperature and gravity -- of the surface layers of the CoRoT target HD 49933, a star that is rather metal poor and significantly hotter compared to the Sun. One 3D simulation has a solar metal abundance and the other has a surface iron-to-hydrogen, [Fe/H], abundance ten times smaller. For each 3D simulation we match an associated global 1D model and we compute the associated acoustic modes using a theoretical model of stochastic excitation validated in the case of the Sun and Alpha Cen A. The rate at which energy is supplied per unit time into the acoustic modes associated with the 3D simulation with [Fe/H]=-1 are found about three times smaller than those associated with the 3D simulation with [Fe/H]=0. As shown here, these differences are related to the fact that low metallicity implies surface layers with a higher mean density. In turn, a higher mean density favors smaller convective velocities and hence less efficient driving of the acoustic modes. Our result shows the importance of taking the surface metal abundance into account in the modeling of the mode driving by turbulent convection. A comparison with observational data is presented in a companion paper using seismic data obtained for the CoRoT target HD 49933.
The star HD 52265 is a G0V metal-rich exoplanet-host star observed in the seismology field of the CoRoT space telescope from November 2008 to March 2009. The satellite collected 117 days of high-precision photometric data on this star, showing that i
t presents solar-like oscillations. HD 52265 was also observed in spectroscopy with the Narval spectrograph at the same epoch. We characterise HD 52265 using both spectroscopic and seismic data. The fundamental stellar parameters of HD 52265 were derived with the semi-automatic software VWA, and the projected rotational velocity was estimated by fitting synthetic profiles to isolated lines in the observed spectrum. The parameters of the observed p modes were determined with a maximum-likelihood estimation. We performed a global fit of the oscillation spectrum, over about ten radial orders, for degrees l=0 to 2. We also derived the properties of the granulation, and analysed a signature of the rotation induced by the photospheric magnetic activity. Precise determinations of fundamental parameters have been obtained: Teff = 6100 +- 60 K, log g = 4.35 +- 0.09, [M/H] = 0.19 +- 0.05, as well as vsini = 3.6 +0.3 -1.0 km/s. We have measured a mean rotation period P_rot = 12.3 +- 0.15 days, and find a signature of differential rotation. The frequencies of 31 modes are reported in the range 1500-2550 micro-Hz. The large separation exhibits a clear modulation around the mean value <Dnu> = 98.3 +- 0.1 micro-Hz. Mode widths vary with frequency along an S-shape with a clear local maximum around 1800 micro-Hz. We deduce lifetimes ranging between 0.5 and 3 days for these modes. Finally, we find a maximal bolometric amplitude of about 3.96 +- 0.24 ppm for radial modes.
Context: Recent observations of HD49933 by the space-photometric mission CoRoT provide photometric evidence of solar type oscillations in a star other than our Sun. The first published reduction, analysis, and interpretation of the CoRoT data yielded
a spectrum of p-modes with l = 0, 1, and 2. Aims: We present our own analysis of the CoRoT data in an attempt to compare the detected pulsation modes with eigenfrequencies of models that are consistent with the observed luminosity and surface temperature. Methods: We used the Gruberbauer et al. frequency set derived based on a more conservative Bayesian analysis with ignorance priors and fit models from a dense grid of model spectra. We also introduce a Bayesian approach to searching and quantifying the best model fits to the observed oscillation spectra. Results: We identify 26 frequencies as radial and dipolar modes. Our best fitting model has solar composition and coincides within the error box with the spectroscopically determined position of HD49933 in the H-R diagram. We also show that lower-than-solar Z models have a lower probability of matching the observations than the solar metallicity models. To quantify the effect of the deficiencies in modeling the stellar surface layers in our analysis, we compare adiabatic and nonadiabatic model fits and find that the latter reproduces the observed frequencies better.
The satellite CoRoT (Convection, Rotation, and planetary Transits) has provided high-quality data for almost six years. We show here the asteroseismic analysis and modeling of HD169392A, which belongs to a binary system weakly gravitationally bound a
s the distance between the two components is of 4250 AU. The main component, HD169392A, is a G0IV star with a magnitude of 7.50 while the second component is a G0V-G2IV star with a magnitude of 8.98. This analysis focuses on the main component, as the secondary one is too faint to measure any seismic parameters. A complete modeling has been possible thanks to the complementary spectroscopic observations from HARPS, providing Teff=5985+/-60K, log g=3.96+/-0.07, and [Fe/H]=- 0.04+/-0.10.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
