اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدThe nature of p-modes and granulation in HD 49933 observed by CoRoT
91
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Context: Recent observations of HD49933 by the space-photometric mission CoRoT provide photometric evidence of solar type oscillations in a star other than our Sun. The first published reduction, analysis, and interpretation of the CoRoT data yielded a spectrum of p-modes with l = 0, 1, and 2. Aims: We present our own analysis of the CoRoT data in an attempt to compare the detected pulsation modes with eigenfrequencies of models that are consistent with the observed luminosity and surface temperature. Methods: We used the Gruberbauer et al. frequency set derived based on a more conservative Bayesian analysis with ignorance priors and fit models from a dense grid of model spectra. We also introduce a Bayesian approach to searching and quantifying the best model fits to the observed oscillation spectra. Results: We identify 26 frequencies as radial and dipolar modes. Our best fitting model has solar composition and coincides within the error box with the spectroscopically determined position of HD49933 in the H-R diagram. We also show that lower-than-solar Z models have a lower probability of matching the observations than the solar metallicity models. To quantify the effect of the deficiencies in modeling the stellar surface layers in our analysis, we compare adiabatic and nonadiabatic model fits and find that the latter reproduces the observed frequencies better.
قيم البحث
اقرأ أيضاً
The oscillations of the solar-like star HD 49933 have been observed thoroughly by CoRot. Two dozens of frequency shifts, which are closely related with the change in magnetic activity, have been measured. To explore the effects of the magnetic activi
ty on the frequency shifts, we calculate frequency shifts for the radial and $l = 1$ p-modes of HD 49933 with the general variational method, which evaluates the shifts using a spatial integral of the product of a kernel and some sources. The theoretical frequency shifts well reproduce the observation. The magnitudes and positions of the sources are determined according to the $chi^2$ criterion. We predict the source that contributes to both $l = 0$ and $l = 1$ modes is located at $0.48 - 0.62$Mm below the stellar surface. In addition, based on the assumption that $A_{0}$ is proportional to the change in the MgII activity index $Delta{i}_{MgII}$, we obtained that the change of MgII index between minimum and maximum of HD 49933 cycle period is about 0.665. The magnitude of the frequency shifts compared to the Sun already told us that HD 49933 is much more active than the Sun, which is further confirmed in this paper. Furthermore, our calculation on the frequency shifts of $l = 1$ modes indicates the variation of turbulent velocity in the stellar convective zone may be an important source for the $l = 1$ shifts.
Solar-like oscillations are stochastically excited by turbulent convection at the surface layers of the stars. We study the role of the surface metal abundance on the efficiency of the stochastic driving in the case of the CoRoT target HD 49933. We c
ompute two 3D hydrodynamical simulations representative -- in effective temperature and gravity -- of the surface layers of the CoRoT target HD 49933, a star that is rather metal poor and significantly hotter compared to the Sun. One 3D simulation has a solar metal abundance and the other has a surface iron-to-hydrogen, [Fe/H], abundance ten times smaller. For each 3D simulation we match an associated global 1D model and we compute the associated acoustic modes using a theoretical model of stochastic excitation validated in the case of the Sun and Alpha Cen A. The rate at which energy is supplied per unit time into the acoustic modes associated with the 3D simulation with [Fe/H]=-1 are found about three times smaller than those associated with the 3D simulation with [Fe/H]=0. As shown here, these differences are related to the fact that low metallicity implies surface layers with a higher mean density. In turn, a higher mean density favors smaller convective velocities and hence less efficient driving of the acoustic modes. Our result shows the importance of taking the surface metal abundance into account in the modeling of the mode driving by turbulent convection. A comparison with observational data is presented in a companion paper using seismic data obtained for the CoRoT target HD 49933.
The numerous results obtained with asteroseismology thanks to space missions such as CoRoT and Kepler are providing a new insight on stellar evolution. After five years of observations, CoRoT is going on providing high-quality data. We present here t
he analysis of the double star HD169392 complemented by ground-based spectroscopic observations. This work aims at characterizing the fundamental parameters of the two stars, their chemical composition, the acoustic-mode global parameters including their individual frequencies, and their dynamics. We have analysed HARPS observations of the two stars to retrieve their chemical compositions. Several methods have been used and compared to measure the global properties of acoustic modes and their individual frequencies from the photometric data of CoRoT. The new spectroscopic observations and archival astrometric values suggest that HD169392 is a wide binary system weakly bounded. We have obtained the spectroscopic parameters for both components, suggesting the origin from the same cloud. However, only the mode signature of HD169392 A has been measured within the CoRoT data. The signal-to-noise ratio of the modes in HD169392B is too low to allow any confident detection. We were able to extract mode parameters of modes for l=0, 1, 2, and 3. The study of the splittings and inclination angle gives two possible solutions with splittings and inclination angles of 0.4-1.0 muHz and 20-40 degrees for one case and 0.2-0.5 muHz and 55-86 degrees for the other case. The modeling of this star with the Asteroseismic Modeling Portal led to a mass of 1.15+/-0.01 Ms, a radius of 1.88+/-0.02 Rs, and an age of 4.33+/-0.12 Gyr, where the uncertainties are the internal ones.
From the seismic data obtained by CoRoT for the star HD 49933 it is possible, as for the Sun, to constrain models of the excitation of acoustic modes by turbulent convection. We compare a stochastic excitation model described in Paper I (arXiv:0910.4
027) with the asteroseismology data for HD 49933, a star that is rather metal poor and significantly hotter than the Sun. Using the mode linewidths measured by CoRoT for HD 49933 and the theoretical mode excitation rates computed in Paper I, we derive the expected surface velocity amplitudes of the acoustic modes detected in HD 49933. Using a calibrated quasi-adiabatic approximation relating the mode amplitudes in intensity to those in velocity, we derive the expected values of the mode amplitude in intensity. Our amplitude calculations are within 1-sigma error bars of the mode surface velocity spectrum derived with the HARPS spectrograph. The same is found with the mode amplitudes in intensity derived for HD 49933 from the CoRoT data. On the other hand, at high frequency, our calculations significantly depart from the CoRoT and HARPS measurements. We show that assuming a solar metal abundance rather than the actual metal abundance of the star would result in a larger discrepancy with the seismic data. Furthermore, calculations that assume the ``new solar chemical mixture are in better agreement with the seismic data than those that assume the ``old solar chemical mixture. These results validate, in the case of a star significantly hotter than the Sun and Alpha Cen A, the main assumptions in the model of stochastic excitation. However, the discrepancies seen at high frequency highlight some deficiencies of the modelling, whose origin remains to be understood.
The CoRoT short asteroseismic runs give us the opportunity to observe a large variety of late-type stars through their solar-like oscillations. We report the observation and modeling of the F5V star HD 175272. Our aim is to define a method for extrac
ting as much information as possible from a noisy oscillation spectrum. We followed a differential approach that consists of using a well-known star as a reference to characterize another star. We used classical tools such as the envelope autocorrelation function to derive the global seismic parameters of the star. We compared HD 175272 with HD 181420 through a linear approach, because they appear to be asteroseismic twins. The comparison with the reference star enables us to substantially enhance the scientific output for HD 175272. First, we determined its global characteristics through a detailed seismic analysis of HD 181420. Second, with our differential approach, we measured the difference of mass, radius and age between HD 175272 and HD 181420. We have developed a general method able to derive asteroseismic constraints on a star even in case of low-quality data. %This method is based on the comparison to a star with common seismic and classical properties. Seismic data allow accurate measurements of radii and masses differences between the two stars. This method can be applied to stars with interesting properties but low signal-to-noise ratio oscillation spectrum, such as stars hosting an exoplanet or members of a binary system.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
