اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدHow cold can you get in space? Quantum Physics at cryogenic temperatures in space
103
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Although it is often believed that the coldness of space is ideally suited for performing measurements at cryogenic temperatures, this must be regarded with caution for two reasons: Firstly, the sensitive instrument must be completely shielded from the strong solar radiation and therefore, e.g. either be placed inside a satellite or externally on the satellites shaded side. Secondly, any platform hosting such an experiment in space generally provides an environment close to room temperature for the accommodated equipment. To obtain cryogenic temperatures without active cooling, one must isolate the instrument from radiative and conductive heat exchange with the platform as well as possible. We investigate the limits of this passive cooling method in the context of a recently proposed experiment to observe the decoherence of quantum superpositions of massive objects. The analyses and conclusions are applicable to a host of similar experimental designs requiring a cryogenic environment in space.
قيم البحث
اقرأ أيضاً
Conversion of vacuum fluctuations into real particles was first predicted by L. Parker considering an expanding universe, followed in S. Hawkings work on black hole radiation. Since their experimental observation is challenging, analogue systems have
gained attention in the verification of this concept. Here we propose an experimental set-up consisting of two adjacent piezoelectric semiconducting layers, one of them carrying dynamic quantum dots (DQDs), and the other being p-doped with an attached gate on top, which introduces a space-dependent layer conductivity. The propagation of surface acoustic waves (SAWs) on the latter layer is governed by a wave equation with an effective metric. In the frame of the DQDs, this space- and time-dependent metric possesses a sonic horizon for SAWs and resembles that of a two dimensional non-rotating and uncharged black hole to some extent. The non-thermal steady state of the DQD spin indicates particle creation in form of piezophonons.
GW190412 is the first observation of a black hole binary with definitively unequal masses. GW190412s mass asymmetry, along with the measured positive effective inspiral spin, allowed for inference of a component black hole spin: the primary black hol
e in the system was found to have a dimensionless spin magnitude between 0.17 and 0.59 (90% credible range). We investigate how the choice of priors for the spin magnitudes and tilts of the component black holes affect the robustness of parameter estimates for GW190412, and report Bayes factors across a suite of prior assumptions. Depending on the waveform family used to describe the signal, we find either marginal to moderate (2:1-6:1) or strong ($gtrsim$ 20:1) support for the primary black hole being spinning compared to cases where only the secondary is allowed to have spin. We show how these choices influence parameter estimates, and find the asymmetric masses and positive effective inspiral spin of GW190412 to be qualitatively, but not quantitatively, robust to prior assumptions. Our results highlight the importance of both considering astrophysically motivated or population-based priors in interpreting observations and considering their relative support from the data.
We present a concise derivation of geometric optics in the presence of axionic fields in a curved space-time. Whenever light can be described via geometric optics (the eikonal approximation), the only difference to the situation without axionic field
is the phenomenon of achromatic birefringence. Consequently, redshift of light and distance estimates based on propagating light rays, as well as shear and magnification due to gravitational lensing are not affected by the interaction of light with an axionic field.
The quantum bits (qubits) on which superconducting quantum computers are based have energy scales corresponding to photons with GHz frequencies. The energy of photons in the gigahertz domain is too low to allow transmission through the noisy room-tem
perature environment, where the signal would be lost in thermal noise. Optical photons, on the other hand, have much higher energies, and signals can be detected using highly efficient single-photon detectors. Transduction from microwave to optical frequencies is therefore a potential enabling technology for quantum devices. However, in such a device the optical pump can be a source of thermal noise and thus degrade the fidelity; the similarity of input microwave state to the output optical state. In order to investigate the magnitude of this effect we model the sub-Kelvin thermal behavior of an electro-optic transducer based on a lithium niobate whispering gallery mode resonator. We find that there is an optimum power level for a continuous pump, whilst pulsed operation of the pump increases the fidelity of the conversion.
Recent developments in space technology like micro-propulsion systems for drag-free control, thermal shielding, ultra-stable laser sources and stable optical cavities set an ideal platform for quantum optomechanical experiments with optically trapped
dielectric spheres. Here, we will provide an overview of the results of recent studies aiming at the realization of the space mission MAQRO to test the foundations of quantum physics in a parameter regime orders of magnitude beyond existing experiments. In particular, we will discuss DECIDE, which is an experiment to prepare and then study a Schrodinger-cat-type state, where a dielectric nanosphere of around 100nm radius is prepared in a superposition of being in two clearly distinct positions at the same time. This superposition leads to double-slit-type interference, and the visibility of the interference pattern will be compared to the predictions of quantum theory. This approach allows for testing for possible deviations from quantum theory as our test objects approach macroscopic dimensions. With DECIDE, it will be possible to distinctly test several prominent theoretical models that predict such deviations, for example: the Diosi-Pensrose model, the continuous-spontaneous-localization model of Ghirardi, Rimini, Weber and Pearle, and the model of Karolyhazy.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
