اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدOn The Critical Reynolds Number For Transition From Laminar To Turbulent Flow
128
0
0.0
(
0
)
تأليف
K. T. Trinh
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
In this visualisation, the transition from laminar to turbulent flow is characterised by the intermittent ejection of wall fluid into the outer stream. The normalised thickness of the viscous flow layer reaches an asymptotic value but the physical thickness drops exponentially after transition. The critical transition pipe Reynolds number can be obtained simply by equating it with the asymptotic value of the normalised thickness of viscous flow layer. Key words: Transition, critical stability Reynolds number, critical transition Reynolds number, non-Newtonian pipe flow
قيم البحث
اقرأ أيضاً
A new approach to turbulence simulation, based on a combination of large-eddy simulation (LES) for the whole flow and an array of non-space-filling quasi-direct numerical simulations (QDNS), which sample the response of near-wall turbulence to large-
scale forcing, is proposed and evaluated. The technique overcomes some of the cost limitations of turbulence simulation, since the main flow is treated with a coarse-grid LES, with the equivalent of wall functions supplied by the near-wall sampled QDNS. Two cases are tested, at friction Reynolds number Re$_tau$=4200 and 20,000. The total grid node count for the first case is less than half a million and less than two million for the second case, with the calculations only requiring a desktop computer. A good agreement with published DNS is found at Re$_tau$=4200, both in terms of the mean velocity profile and the streamwise velocity fluctuation statistics, which correctly show a substantial increase in near-wall turbulence levels due to a modulation of near-wall streaks by large-scale structures. The trend continues at Re$_tau$=20,000, in agreement with experiment, which represents one of the major achievements of the new approach. A number of detailed aspects of the model, including numerical resolution, LES-QDNS coupling strategy and sub-grid model are explored. A low level of grid sensitivity is demonstrated for both the QDNS and LES aspects. Since the method does not assume a law of the wall, it can in principle be applied to flows that are out of equilibrium.
Emulsions are omnipresent in the food industry, health care, and chemical synthesis. In this Letter the dynamics of meta-stable oil-water emulsions in highly turbulent ($10^{11}leqtext{Ta}leq 3times 10^{13}$) Taylor--Couette flow, far from equilibriu
m, is investigated. By varying the oil-in-water void fraction, catastrophic phase inversion between oil-in-water and water-in-oil emulsions can be triggered, changing the morphology, including droplet sizes, and rheological properties of the mixture, dramatically. The manifestation of these different states is exemplified by combining global torque measurements and local in-situ laser induced fluorescence (LIF) microscopy imaging. Despite the turbulent state of the flow and the dynamic equilibrium of the oil-water mixture, the global torque response of the system is found to be as if the fluid were Newtonian, and the effective viscosity of the mixture was found to be several times bigger or smaller than either of its constituents.
This paper presents a flame-height correlation for laminar to transition-to-turbulent regime diffusion flames. Flame-height measurements are obtained by means of numerical and experimental studies in which three high definition cameras were employed
to take frontal, lateral and 45{deg} angled images simultaneously. The images were analysed using an image-processing algorithm to determine the flame-height through indirect measurement. To locate an overall chemical-flame-length, numerical simulations were conducted with the unsteady Reynolds-Averaged Navier-Stokes technique. The eddy-dissipation model was also implemented to calculate chemical reaction rate. The experiments show that this proposed correlation has an adjustment variation of luminous flame-height for the laminar regime of 16.9%, which indicates that, without the use of the intermittent buoyant flame-height correlation, it globally best represents the flame-height in this regime. For the laminar and transition-to-turbulence regime the adjustment variations are 5.54% compared to the most accepted flame-height correlations, thus providing an acceptably good fitting. The numerical results show that the proposed range for the chemical-flame-length is located between the luminous and flickering flame zone compared to the experimental flame images. These results agree with the chemical length zone reported in the literature. Therefore, the correlation can be used for laminar and transition-to-turbulent combustion regimes.
Plane Couette flow presents a regular oblique turbulent-laminar pattern over a wide range of Reynolds numbers R between the globally stable base flow profile at low R<R_g and a uniformly turbulent regime at sufficiently large R>R_t. The numerical sim
ulations that we have performed on a pattern displaying a wavelength modulation show a relaxation of that modulation in agreement with what one would expect from a standard approach in terms of dissipative structures in extended geometry though the structuration develops on a turbulent background. Some consequences are discussed.
The interaction between turbulent axisymmetric wakes plays an important role in many industrial applications, notably in the modelling of wind farms. While the non-equilibrium high Reynolds number scalings present in the wake of axisymmetric plates h
as been shown to modify the averaged streamwise scalings of individual wakes, little attention has been paid to their consequences in terms of wake interactions. We propose an experimental setup that tests the presence of non-equilibrium turbulence using the streamwise variation of velocity fluctuations between two bluff bodies facing a laminar flow. We have studied two different sets of plates (one with regular and another with irregular peripheries) with hot-wire anemometry in a wind tunnel. By acquiring streamwise profiles for different plate separations and identifying the wake interaction length for each separation it is possible to show that the interaction between them is consistent with non-equilibrium scalings. This work also generalises previous studies concerned with the interaction of plane wakes to include axisymmetric wakes. We find that a simple mathematical expression for the wake interaction length based on non-equilibrium turbulence scalings can be used to collapse the streamwise developments of the second, third and fourth moments of the streamwise fluctuating velocity.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
