اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدSelf consistent kinetic simulations of SPT and HEMP thrusters including the near-field plume region
111
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
The Particle-in-Cell (PIC) method was used to study two different ion thruster concepts - Stationary Plasma Thrusters (SPT) and High Efficiency Multistage Plasma Thrusters (HEMP-T), in particular the plasma properties in the discharge chamber due to the different magnetic field configurations. Special attention was paid to the simulation of plasma particle fluxes on the thrusters channel surfaces. In both cases, PIC proved itself as a powerful tool, delivering important insight into the basic physics of the different thruster concepts. The simulations demonstrated that the new HEMP thruster concept allows for a high thermal efficiency due to both minimal energy dissipation and high acceleration efficiency. In the HEMP thruster the plasma contact to the wall is limited only to very small areas of the magnetic field cusps, which results in much smaller ion energy flux to the thruster channel surface as compared to SPT. The erosion yields for dielectric discharge channel walls of SPT and HEMP thrusters were calculated with the binary collision code SDTrimSP. For SPT, an erosion rate on the level of 1 mm of sputtered material per hour was observed. For HEMP, thruster simulations have shown that there is no erosion inside the dielectric discharge channel.
قيم البحث
اقرأ أيضاً
This paper discusses the capture of an ion beam in a magnetized plasma of an Electron Cyclotron Resonance Ion Source based Charge Breeder, as modelled by numerical simulations. As a relevant step forward with respect to previous works, here the captu
re is modeled by considering a plasma structure determined in a self-consisent way. The plasmoid-halo structure of the ECR plasma - that is consisting of a dense core (the plasmoid) surrounded by a rarefied halo - is further confirmed by the self-consistent calculations, having also some fine structures affected by the electromagnetic field distribution and by the magnetostatic field profile. The capture of Rb1+ ions has been investigated in details, vs. various plasma parameters, and then compared to experimental results.
Bichromatic extreme-ultraviolet pulses from a seeded free-electron laser enable us to measure photoelectron angular distribution (PAD) as a function of the relative phase between the different wavelength components. The time-dependent multiconfigurat
ion self-consistent-field (TD-MCSCF) methods are powerful multielectron computation methods to accurately simulate such photoionization dynamics from the first principles. Here we propose a method to evaluate the amplitude and phase of each ionization path, which completely determines the photoionization processes, using TD-MCSCF simulation results. The idea is to exploit the capability of TD-MCSCF to calculate the partial wave amplitudes specified by the azimuthal and magnetic angular momenta (l,m) and the m-resolved PAD. The phases of the ionization paths as well as the amplitudes of the paths resulting in the same (l,m) are obtained through global fitting of the expression of the asymmetry parameters to the calculated m-resolved PAD, which depends on the relative phase of the bichromatic field. We apply the present method to ionization of Ne by combined fundamental and second-harmonic XUV pulses, demonstrating that the extracted amplitudes and phases excellently reproduce the asymmetry parameters.
Turbulent dynamics in the scrape-off layer (SOL) of magnetic fusion devices is intermittent with large fluctuations in density and pressure. Therefore, a model is required that allows perturbations of similar or even larger magnitude to the time-aver
aged background value. The fluid-turbulence code GRILLIX is extended to such a global model, which consistently accounts for large variation in plasma parameters. Derived from the drift reduced Braginskii equations, the new GRILLIX model includes electromagnetic and electron-thermal dynamics, retains global parametric dependencies and the Boussinesq approximation is not applied. The penalisation technique is combined with the flux-coordinate independent (FCI) approach [F. Hariri and M. Ottaviani, Comput.Phys.Commun. 184:2419, (2013); A. Stegmeir et al., Comput.Phys.Commun. 198:139, (2016)], which allows to study realistic diverted geometries with X-point(s) and general boundary contours. We characterise results from turbulence simulations and investigate the effect of geometry by comparing simulations in circular geometry with toroidal limiter against realistic diverted geometry at otherwise comparable parameters. Turbulence is found to be intermittent with relative fluctuation levels of up to 40% showing that a global description is indeed important. At the same time via direct comparison, we find that the Boussinesq approximation has only a small quantitative impact in a turbulent environment. In comparison to circular geometry the fluctuations are reduced in diverted geometry, which is related to a different zonal flow structure. Moreover, the fluctuation level has a more complex spatial distribution in diverted geometry. Due to local magnetic shear, which differs fundamentally in circular and diverted geometry, turbulent structures become strongly distorted in the perpendicular direction and are eventually damped away towards the X-point.
The understanding of the halo current properties during disruptions is key to design and operate large scale tokamaks in view of the large thermal and electromagnetic loads that they entail. For the first time, we present a fully self-consistent mode
l for halo current simulations including neutral particles and sheath boundary conditions. The model is used to simulate Vertical Displacement Events (VDEs) occurring in the COMPASS tokamak. Recent COMPASS experiments have shown that the parallel halo current density at the plasma-wall interface is limited by the ion saturation current during VDE-induced disruptions. We show that usual MHD boundary conditions can lead to the violation of this physical limit and we implement this current density limitation through a boundary condition for the electrostatic potential. Sheath boundary conditions for the density, the heat flux, the parallel velocity and a realistic parameter choice (e.g. Spitzer $eta$ and Spitzer-Harm $chi_parallel$ values) extend present VDE simulations beyond the state of the art. Experimental measurements of the current density, temperature and heat flux profiles at the COMPASS divertor are compared with the results obtained from axisymmetric simulations. Since the ion saturation current density ($J_{sat}$) is shown to be essential to determine the halo current profile, parametric scans are performed to study its dependence on different quantities such as the plasma resistivity and the particle and heat diffusion coefficients. In this respect, the plasma resistivity in the halo region broadens significantly the $J_{sat}$ profile, increasing the halo width at a similar total halo current.
This paper develops two non-inductive steady state scenarios for larger size configuration of China Fusion Engineering Test Reactor (CFETR) with integrated modeling simulations. A self-consistent core-pedestal coupled workflow for CFETR is developed
under integrated modeling framework OMFIT, which allows more accurate evaluation of CFETR performance. The workflow integrates equilibrium code EFIT, transport codes ONETWO and TGYRO, and pedestal code EPED. A fully non-inductive baseline phase I scenario is developed with the workflow, which satisfies the minimum goal of Fusion Nuclear Science Facility. Compared with previous work, which proves the larger size and higher toroidal field CFETR configuration than has the advantages of reducing heating and current drive requirements, lowering divertor and wall power loads, allowing higher bootstrap current fraction and better confinement. A fully non-inductive high-performance phase II scenario is developed, which explores the alpha-particle dominated self-heating regime. Phase II scenario achieves the target of fusion power Pfus>1GW and fusion gain Qfus>20, and it largely reduces auxiliary heating and current drive power. Moreover, the large neutron production of phase II increases the energy generation power and tritium breeding rate.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
