اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدTemperature dependence of magnetic anisotropy in bulk and nanoparticles of Pr_0.5Sr_0.5MnO_3
133
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Nanoparticles (size 20, 40 and 60 nm) of Pr_0.5Sr_0.5MnO_3 are prepared by sol-gel technique and their magnetic properties are studied using ferromagnetic resonance and magnetization measurements. A comparison with the properties of the bulk material shows that the ferromagnetic transition at 265 K remains unaffected but the anti-ferromagnetic transition at T_N = 150 K disappears in the nanoparticles. Further, the temperature dependence of magnetic anisotropy shows a complex behavior, being higher in the nanoparticles at high temperatures and lower at lower temperatures in comparison with the bulk.
قيم البحث
اقرأ أيضاً
The temperature dependence of the Mott metal-insulator transition (MIT) is studied with a VO_2-based two-terminal device. When a constant voltage is applied to the device, an abrupt current jump is observed with temperature. With increasing applied v
oltages, the transition temperature of the MIT current jump decreases. We find a monoclinic and electronically correlated metal (MCM) phase between the abrupt current jump and the structural phase transition (SPT). After the transition from insulator to metal, a linear increase in current (or conductivity) is shown with temperature until the current becomes a constant maximum value above T_{SPT}=68^oC. The SPT is confirmed by micro-Raman spectroscopy measurements. Optical microscopy analysis reveals the absence of the local current path in micro scale in the VO_2 device. The current uniformly flows throughout the surface of the VO_2 film when the MIT occurs. This device can be used as a programmable critical temperature sensor.
We measured the temperature dependences of the static magnetization and the spin excitation in a square-lattice multiferroics Ba$_2$MnGe$_2$O$_7$. An anisotropy gap of the observed low energy mode is scaled by electric polarization rather than a powe
r of sublattice moment. Spin nematic interaction in effective spin Hamiltonian, which is equivalent to interaction of electric polarization, is responsible for the easy-axis anisotropy. The nontrivial behavior of the anisotropy gap can be rationalized as change of the hybridized $d$-$p$ orbital with temperature, leading to the temperature dependence of the spin nematic interaction.
The surfaces generated by cleaving non-polar, two-dimensional oxides are often considered to be perfect or ideal. However, single particle spectroscopies on Sr2RuO4, an archetypal non-polar two dimensional oxide, show significant cleavage temperature
dependence. We demonstrate that this is not a consequence of the intrinsic characteristics of the surface: lattice parameters and symmetries, step heights, atom positions, or density of states. Instead, we find a marked increase in the density of defects at the mesoscopic scale with increased cleave temperature. The potential generality of these defects to oxide surfaces may have broad consequences to interfacial control and the interpretation of surface sensitive measurements.
Cerium-based intermetallics are currently attracting much interest as a possible alternative to existing high-performance magnets containing scarce heavy rare-earth elements. However, the intrinsic magnetic properties of Ce in these systems are poorl
y understood due to the difficulty of a quantitative description of the Kondo effect, a many-body phenomenon where conduction electrons screen out the Ce-4f moment. Here, we show that the Ce-4f shell in Ce-Fe intermetallics is partially Kondo screened. The Kondo scale is dramatically enhanced by nitrogen interstitials completely suppressing the Ce-4f contribution to the magnetic anisotropy, in striking contrast to the effect of nitrogenation in isostructural intermetallics containing other rare-earth elements. We determine the full temperature dependence of the Ce-4f single-ion anisotropy and show that even unscreened Ce-4f moments contribute little to the room-temperature intrinsic magnetic hardness. Our study thus establishes fundamental constraints on the potential of cerium-based permanent magnet intermetallics.
Electrical resistivity rho, magnetic susceptibility chi, magnetization M and specific heat measurements are reported on a singlecrystalline sample of CePd5Al2, showing successive antiferromagnetic orderings at T_N1=4.1 K and T_N2=2.9 K. The temperatu
re dependence of T_N1 shows a Kondo metal behavior with large anisotropy, rho_c/rho_a=3.2 at 20 K, and opening of a superzone gap along the tetragona c-direction below T_N1. Both T_N1 and T_N2 gradually increase with applying pressure up to 2.5 GPa. The data of chi(T) and M(B) in the paramagnetic state were analyzed using a crystalline electric field (CEF) model. It led to a Kramers doublet ground state with wave functions consisting primarily of |+-5/2>, whose energy level is isolated from the excited states by 230 and 300 K. This CEF effect gives rise to the large anisotropy in the paramagnetic state. In the ordered state, the uniaxial magnetic anisotropy is manifested as M_c/M_a=20 in B=5 T and at 1.9 K, and chi_c/chi_a=25 in B=0.1 T and at 4 K. This huge uniaxial magnetic anisotropy in the antiferromagnetic states can be interpreted in terms of isotropic magnetic interaction among the Ce^{3+} moments governed by the strong CEF. In powder neutron diffraction experiments, magnetic reflections were observed owing to the antiferromagnetic ordered states below T_N1, however, no additional reflection was found below T_N2.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
