اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدPrecision Measurement of Energy and Position Resolutions of the BTeV Electromagnetic Calorimeter Prototype
64
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
The energy dependence of the energy and position resolutions of the electromagnetic calorimeter prototype made of lead tungstate crystals produced in Bogoroditsk (Russia) and Shanghai (China) is presented. These measurementswere carried out at the Protvino accelerator using a 1 to 45 GeV electron beam. The crystals were coupled to photomultiplier tubes. The dependence of energy and position resolutions on different factors as well as the measured electromagnetic shower lateral profile are presented.
قيم البحث
اقرأ أيضاً
We report a two-detector measurement of the propagation speed of neutrinos over a baseline of 734 km. The measurement was made with the NuMI beam at Fermilab between the near and far MINOS detectors. The fractional difference between the neutrino spe
ed and the speed of light is determined to be $(v/c-1) = (1.0 pm 1.1) times 10^{-6}$, consistent with relativistic neutrinos.
We present results on the reconstruction of electromagnetic (EM) activity from photons produced in charged current $ u_{mu}$ interactions with final state $pi^0$s. We employ a fully-automated reconstruction chain capable of identifying EM showers of
$mathcal{O}$(100) MeV energy, relying on a combination of traditional reconstruction techniques together with novel machine-learning approaches. These studies demonstrate good energy resolution, and good agreement between data and simulation, relying on the reconstructed invariant $pi^0$ mass and other photon distributions for validation. The reconstruction techniques developed are applied to a selection of $ u_{mu} + {rm Ar} rightarrow mu + pi^0 + X$ candidate events to demonstrate the potential for calorimetric separation of photons from electrons and reconstruction of $pi^0$ kinematics.
In this paper we discuss briefly the correlation between fake missing transverse energy and jets pointing to crack regions in the ATLAS calorimeters.
ORKA is a proposed experiment to measure the K+ -> pi+nunubar branching ratio with 5% precision using the Fermilab Main Injector high-intensity proton source. The detector design is based on the BNL E787/E949 experiments, which detected seven K+ -> p
i+nunubar candidate events. ORKA is expected to acheive two orders of magnitude improvement in sensitivity relative to the BNL experiments as a result of enhancements to the beam line and the detector acceptance. Precise measurement of the K+ -> pi+nunubar branching ratio with the same level of uncertainty as the well-understood Standard Model prediction allows for sensitivity to new physics at and beyond the LHC mass scale. Detector R&D, simulation-based optimization of the experiment design, and preparation of the experiment location are underway.
The silicon pixel vertex detector is a key element of the BTeV spectrometer. Sensors bump-bonded to prototype front-end devices were tested in a high energy pion beam at Fermilab. The spatial resolution and occupancies as a function of the pion incid
ent angle were measured for various sensor-readout combinations. The data are compared with predictions from our Monte Carlo simulation and very good agreement is found.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
