اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدCrystal growth, characterization and phase transition of PbCuTe$_2$O$_6$ single crystals
162
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Single crystals of the three-dimensional frustrated magnet and spin liquid candidate compound PbCuTe$_2$O$_6$, were grown using both the Travelling Solvent Floating Zone (TSFZ) and the Top-Seeded Solution Growth (TSSG) techniques. The growth conditions were optimized by investigating the thermal properties. The quality of the crystals was checked by polarized optical microscopy, X-ray Laue and X-ray powder diffraction, and compared to the polycrystalline samples. Excellent quality crystals were obtained by the TSSG method. Magnetic measurements of these crystals revealed a small anisotropy for different crystallographic directions in comparison with the previously reported data. The heat capacity of both single crystal and powder samples reveal a transition anomaly around 1~K. Curiously the position and magnitude of the transition are strongly dependent on the crystallite size and it is almost entirely absent for the smallest crystallites. A structural transition is suggested which accompanies the reported ferroelectric transition, and a scenario whereby it becomes energetically unfavourable in small crystallites is proposed.
قيم البحث
اقرأ أيضاً
Large single crystals of the double-perovskite Ba$_2$ScNbO$_6$ were grown from the melt for the first time. With a lattice parameter at room temperature of 4.11672(1) r{A}, this cubic double-perovskite has an excellent lattice match to BaSnO$_3$, PbZ
r$_{0.9}$Ti$_{0.1}$O$_3$, LaInO$_3$, BiScO$_3$, and other perovskites of contemporary interest. Differential thermal analysis showed that Ba$_2$ScNbO$_6$ melts at 2165$pm$30{deg}C in an inert atmosphere. Competitive grain growth was visualized by energy dispersive Laue mapping. X-ray diffraction rocking curve measurements revealed full width at half maximum values between 21 and 33 arcsec for 002 and 004 reflections. The crystals were sufficiently large to yield (100)-oriented single-crystal substrates with surface areas as large as 10 x 10 mm$^2$.
Terbium titanate (Tb$_2$Ti$_2$O$_7$) is a spin-ice material with remarkable magneto-optical properties. It has a high Verdet constant and is a promising substrate crystal for the epitaxy of quantum materials with the pyrochlore structure. Large singl
e crystals with adequate quality of Tb$_2$Ti$_2$O$_7$ or any pyrochlore are not available so far. Here we report the growth of high-quality bulk crystals using the Czochralski method to pull crystals from the melt. Prior work using the automated Czochralski method has suffered from growth instabilities like diameter fluctuation, foot formation and subsequent spiraling shortly after the seeding stage. In this study, the volumes of the crystals were strongly increased to several cubic centimeters by means of manual growth control, leading to crystal diameters up to 40 mm and crystal lengths up to 10 mm. Rocking curve measurements revealed full width at half maximum values between 28 and 40 for 222 reflections. The specific heat capacity c$_p$ was measured between room temperature and 1573 K by dynamic differential scanning calorimetry and shows the typical slow parabolic rise. In contrast, the thermal conductivity kappa(T) shows a minimum near 700 K and increases at higher temperature T. Optical spectroscopy was performed at room temperature from the ultraviolet to the near infrared region, and additionally in the near infrared region up to 1623 K. The optical transmission properties and the crystal color are interpreted to be influenced by partial oxidation of Tb$^{3+}$ to Tb$^{4+}$.
A comprehensive bulk and surface investigation of high-quality In$_2$O$_3$(001) single crystals is reported. The transparent-yellow, cube-shaped single crystals were grown using the flux method. Inductively coupled plasma mass spectrometry (ICP-MS) r
eveals small residues of Pb, Mg, and Pt in the crystals. Four-point-probe measurements show a resistivity of 2.0 $pm$ 0.5 $times$ 10$^5$ {Omega} cm, which translates into a carrier concentration of $approx$10$^{12}$ cm$^{-3}$. The results from x-ray diffraction (XRD) measurements revise the lattice constant to 10.1150(5) {AA} from the previously accepted value of 10.117 {AA}. Scanning tunneling microscopy (STM) images of a reduced (sputtered/annealed) and oxidized (exposure to atomic oxygen at 300 {deg}C) surface show a step height of 5 {AA}, which indicates a preference for one type of surface termination. The surfaces stay flat without any evidence for macroscopic faceting under any of these preparation conditions. A combination of low-energy ion scattering (LEIS) and atomically resolved STM indicates an indium-terminated surface with small islands of 2.5 {AA} height under reducing conditions, with a surface structure corresponding to a strongly distorted indium lattice. Scanning tunneling spectroscopy (STS) reveals a pronounced surface state at the Fermi level ($E_F$). Photoelectron spectroscopy (PES) shows additional, deep-lying band gap states, which can be removed by exposure of the surface to atomic oxygen. Oxidation also results in a shoulder at the O 1s core level at a higher binding energy, possibly indicative of a surface peroxide species. A downward band bending of 0.4 eV is observed for the reduced surface, while the band bending of the oxidized surface is of the order of 0.1 eV or less.
High-temperature indium flux growth was applied to prepare single crystals of GdRh$_2$Si$_2$ by a modified Bridgman method leading to mm-sized single crystals with a platelet habitus. Specific heat and susceptibility data of GdRh$_2$Si$_2$ exhibit a
pronounced anomaly at $T_N = 107rm ,K$, where the AFM ordering sets in. Magnetic measurements on the single crystals were performed down to $T = 2$,K in external fields from B = 0 - 9,T applied along the $[100]$-, $[110]$- and $[001]$-direction of the tetragonal lattice. The effective magnetic moment determined from a Curie-Weiss fit agrees well with values from literature, and is larger than the theoretically predicted value. Electrical transport data recorded for current flow parallel and perpendicular to the $[001]$-direction show a large anisotropy below $T_N$. The residual resistivity ratio $rm RRR=rho_{300K}/rho_{0}sim 23$ demonstrates that we succeeded in preparing high-quality crystals using high-temperature indium flux-growth.
We report a neutron scattering study of a ferroelectric phase transition in Sr$_{0.61}$Ba$_{0.39}$Nb$_2$O$_6$ (SBN-61). The ferroelectric polarization is along the crystallographic $c$-axis but the transverse acoustic branch propagating along the $<$
1, 1, 0$>$ direction does not show any anomaly associated with the this transition. We find no evidence for a soft transverse optic phonon. We do, however, observe elastic diffuse scattering. The intensity of this scattering increases as the sample is cooled from a temperature well above the phase transition. The susceptibility associated with this diffuse scattering follows well the anomaly of the dielectric permittivity of SBN-61. Below T$_mathrm{c}$ the shape of this scattering is consistent with the scattering expected from ferroelectric domain walls. Our results suggest that despite apparent chemical disorder SBN-61 behaves as a classic order-disorder uniaxial ferroelectric with critical fluctuations in the range $<10^{-11}$ s.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
