ﻻ يوجد ملخص باللغة العربية
Great achievements in last five years, such as record-efficient amorphous/crystalline silicon heterojunction (SHJ) solar cells and cutting-edge perovskite/SHJ tandem solar cells, place hydrogenated amorphous silicon (a-Si:H) at the forefront of emerging photovoltaics. Due to the extremely low doping efficiency of trivalent boron (B) in amorphous tetravalent silicon, light harvesting of aforementioned devices are limited by their fill factors (FF), which is a direct metric of the charge carrier transport. It is challenging but crucial to develop highly conductive doped a-Si:H for minimizing the FF losses. Here we report intensive light soaking can efficiently boost the dark conductance of B-doped a-Si:H thin films, which is an abnormal Staebler-Wronski effect. By implementing this abnormal effect to SHJ solar cells, we achieve a certificated power conversion efficiency (PCE) of 25.18% (26.05% on designated area) with FF of 85.42% on a 244.63-cm2 wafer. This PCE is one of the highest reported values for total-area top/rear contact silicon solar cells. The FF reaches 98.30 per cent of its Shockley-Queisser limit.
We study polarization independent improved light trapping in commercial thin film hydrogenated amorphous silicon (a-Si:H) solar photovoltaic cells using a three-dimensional silver array of multi-resonant nano-disk structures embedded in a silicon nit
In $e$-beam evaporated amorphous silicon ($a$-Si), the densities of two-level systems (TLS), $n_{0}$ and $overline{P}$, determined from specific heat $C$ and internal friction $Q^{-1}$ measurements, respectively, have been shown to vary by over three
Amorphous molybdenum silicide compounds have attracted significant interest for potential device applications, particularly in single-photon detector. In this work, the temperature-dependent resistance and magneto-resistance behaviors were measured t
We report a high Responsivity broad band photo-detector working in the wavelength range 400 nm to 1100 nm in a horizontal array of Si microlines (line width ~1 micron) fabricated on a Silicon-on-Insulator (SOI) wafer. The array was made using a combi
Silicon heterojunction (SHJ) solar cells represent a promising technological approach towards higher photovoltaics efficiencies and lower fabrication cost. While the device physics of SHJ solar cells have been studied extensively in the past, the way