اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدModulation of spin conversion in a 1.5 nm-thick Pd film by ionic gating
133
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Gate-induced modulation of the spin-orbit interaction (SOI) in a 1.5 nm-thick Pd thin film grown on a ferrimagnetic insulator was investigated. Efficient charge accumulation by ionic gating enables a substantial upshift in the Fermi level of the Pd film, which was corroborated by suppression of the resistivity in the Pd. Electromotive forces arising from the inverse spin Hall effect in Pd under spin pumping were substantially modulated by the gating, in consequence of the modulation of the spin Hall conductivity of Pd as in an ultrathin Pt film. The same experiment using a thin Cu film, for which the band structure is largely different from Pd and Pt and its SOI is quite small, provides further results supporting our claim. The results obtained help in developing a holistic understanding of the gate-tunable SOI in solids and confirm a previous explanation of the significant modulation of the spin Hall conductivity in an ultrathin Pt film by gating.
قيم البحث
اقرأ أيضاً
Electric gating can strongly modulate a wide variety of physical properties in semiconductors and insulators, such as significant changes of conductivity in silicon, appearance of superconductivity in SrTiO3, the paramagnet-ferromagnet transition in
(In,Mn)As and so on. The key to such modulation is charge accumulation in solids. Thus, it has been believed that such modulation is out of reach for conventional metals where the number of carriers is too large. However, success in tuning the Curie temperature of ultrathin cobalt gave hope of finally achieving such degree of control even in metallic materials. Here, we show reversible modulation of up to two orders of magnitude of the inverse spin Hall effect - a phenomenon that governs interconversion between spin and charge currents - in ultrathin platinum. Spin-to-charge conversion enables the generation and use of electric and spin currents in the same device, which is crucial for the future of spintronics and electronics.
To explore the further possibilities of nanometer-thick ferromagnetic films (ultrathin ferromagnetic films), we investigated the ferromagnetic resonance (FMR) of 1 nm-thick Co film. Whilst an FMR signal was not observed for the Co film grown on a SiO
2 substrate, the insertion of a 3 nm-thick amorphous Ta buffer layer beneath the Co enabled the detection of a salient FMR signal, which was attributed to the smooth surface of the amorphous Ta. This result implies the excitation of FMR in an ultrathin ferromagnetic film, which can pave the way to controlling magnons in ultrathin ferromagnetic films.
Liquid phase epitaxy of an 18 nm thick Yttrium Iron garnet (YIG) film is achieved. Its magnetic properties are investigated in the 100 -- 400 K temperature range, as well as the influence of a 3 nm thick Pt overlayer on them. The saturation magnetiza
tion and the magnetocrystalline cubic anisotropy of the bare YIG film behave similarly to bulk YIG. A damping parameter of only a few $10^{-4}$ is measured, together with a low inhomogeneous contribution to the ferromagnetic resonance linewidth. The magnetic relaxation increases upon decreasing temperature, which can be partly ascribed to impurity relaxation mechanisms. While it does not change its cubic anisotropy, the Pt capping strongly affects the uniaxial perpendicular anisotropy of the YIG film, in particular at low temperatures. The interfacial coupling in the YIG/Pt heterostructure is also revealed by an increase of the linewidth, which substantially grows by lowering the temperature.
Following the recent success of monolithically integrated Perovskite/Si tandem solar cells, great interest has been raised in searching for alternative wide bandgap top-cell materials with prospects of a fully earth-abundant, stable and efficient tan
dem solar cell. Thin film chalcogenides (TFCs) such as the Cu2ZnSnS4 (CZTS) could be suitable top-cell materials. However, TFCs have the disadvantage that generally at least one high temperature step (>500 C) is needed during the synthesis, which could contaminate the Si bottom cell. Here, we systematically investigate the monolithic integration of CZTS on a Si bottom solar cell. A thermally resilient double-sided Tunnel Oxide Passivated Contact (TOPCon) structure is used as bottom cell. A thin (<25 nm) TiN layer between the top and bottom cells, doubles as diffusion barrier and recombination layer. We show that TiN successfully mitigates in-diffusion of CZTS elements into the c-Si bulk during the high temperature sulfurization process, and find no evidence of electrically active deep Si bulk defects in samples protected by just 10 nm TiN. Post-process minority carrier lifetime in Si exceeded 1.5 ,s. i.e., a promising implied open-circuit voltage (i-Voc) of 715 mV after the high temperature sulfurization. Based on these results, we demonstrate a first proof-of-concept two-terminal CZTS/Si tandem device with an efficiency of 1.1% and a Voc of 900 mV. A general implication of this study is that the growth of complex semiconductors on Si using high temperature steps is technically feasible, and can potentially lead to efficient monolithically integrated two-terminal tandem solar cells.
Ionic liquid gating can markedly modulate the materials carrier density so as to induce metallization, superconductivity, and quantum phase transitions. One of the main issues is whether the mechanism of ionic liquid gating is an electrostatic field
effect or an electrochemical effect, especially for oxide materials. Recent observation of the suppression of the ionic liquid gate-induced metallization in the presence of oxygen for oxide materials suggests the electrochemical effect. However, in more general scenarios, the role of oxygen in ionic liquid gating effect is still unclear. Here, we perform the ionic liquid gating experiments on a non-oxide material: two-dimensional ferromagnetic Cr2Ge2Te6. Our results demonstrate that despite the large increase of the gate leakage current in the presence of oxygen, the oxygen does not affect the ionic liquid gating effect (< 5 % difference), which suggests the electrostatic field effect as the mechanism on non-oxide materials. Moreover, our results show that the ionic liquid gating is more effective on the modulation of the channel resistances compared to the back gating across the 300 nm thick SiO2.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
