اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدProgressive amorphization of GeSbTe phase-change material under electron beam irradiation
107
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Fast and reversible phase transitions in chalcogenide phase-change materials (PCMs), in particular, Ge-Sb-Te compounds, are not only of fundamental interests, but also make PCMs based random access memory (PRAM) a leading candidate for non-volatile memory and neuromorphic computing devices. To RESET the memory cell, crystalline Ge-Sb-Te has to undergo phase transitions firstly to a liquid state and then to an amorphous state, corresponding to an abrupt change in electrical resistance. In this work, we demonstrate a progressive amorphization process in GeSb2Te4 thin films under electron beam irradiation on transmission electron microscope (TEM). Melting is shown to be completely absent by the in situ TEM experiments. The progressive amorphization process resembles closely the cumulative crystallization process that accompanies a continuous change in electrical resistance. Our work suggests that if displacement forces can be implemented properly, it should be possible to emulate symmetric neuronal dynamics by using PCMs.
قيم البحث
اقرأ أيضاً
Phase change memories (PCM) is an emerging type of non-volatile memory that has shown a strong presence in the data-storage market. This technology has recently attracted significant research interest in the development of non-Von Neumann computing a
rchitectures such as in-memory and neuromorphic computing. Research in these areas has been primarily motivated by the scalability potential of phase change materials and their compatibility with industrial nanofabrication processes. In this work, we are presenting our development of crossbar phase change memory arrays through the electrodeposition of GeSbTe (GST). We show that GST can be electrodeposited in microfabricated TiN crossbar arrays using a scalable process. Our phase switching test of the electrodeposited materials have shown that a SET/RESET resistance ratio of 2-3 orders of magnitude is achievable with a switching endurance of around 80 cycles. These results represent the first phase switching of electrodeposited GeSbTe in microfabricated crossbar arrays. Our work paves the way towards developing large memory arrays involving electrodeposited materials for passive selectors and phase switching devices. It also opens opportunities for developing a variety of different electronic devices using electrodeposited materials.
Here, we report a study on the radiation resistance enhancement of Gd2Zr2O7 nanograin ceramics, in which amorphization, cell volume expansion and multi-stage helium (He) bubble formation are investigated and discussed. Gd2Zr2O7 ceramics with a series
of grain sizes (55-221 nm) were synthesized and irradiated by 190 keV He ion beam up to a fluence of 5x10^17 ions/cm2. Both the degree of post irradiation cell volume expansion and the amorphization fraction appear to be size dependent. As the average grain size evolves from 55 to 221 nm, the degree of post irradiation cell volume expansion increases from 0.56 to 1.02 %, and the amorphization fraction increases from 6.8 to 11.1 %. Additionally, the threshold He concentrations (at. %) of bubbles at different formation stages and locations, including (1) bubbles at grain boundary, (2) bubble-chains and (3) ribbon-like bubbles within the grain, are all found to be much higher in the nanograin ceramic (55 nm) compared with that of the submicron sample (221 nm). We conclude that grain boundary plays a critical role in minimizing the structural defects, and inhibiting the multi-stage He bubble formation process.
The authors report micro-Raman investigation of changes in the single and bilayer graphene crystal lattice induced by the low and medium energy electron-beam irradiation (5 and 20 keV). It was found that the radiation exposures results in appearance
of the strong disorder D band around 1345 1/cm indicating damage to the lattice. The D and G peak evolution with the increasing radiation dose follows the amorphization trajectory, which suggests graphenes transformation to the nanocrystalline, and then to amorphous form. The results have important implications for graphene characterization and device fabrication, which rely on the electron microscopy and focused ion beam processing.
Oxygen is widely used to tune the performance of chalcogenide phase-change materials in the usage of phase-Change random access memory (PCRAM) which is considered as the most promising next-generation non-volatile memory. However, the microscopic rol
e of oxygen in the write-erase process, i.e., the reversible phase transition between crystalline and amorphous state of phase-change materials is not clear yet. Using oxygen doped GeTe as an example, this work unravels the role of oxygen at the atomic scale by means of ab initio total energy calculations and ab initio molecular dynamics simulations. Our main finding is that after the amorphization and the subsequent re-crystallization process simulated by ab initio molecular dynamics, oxygen will drag one Ge atom out of its lattice site and both atoms stay in the interstitial region near the Te vacancy that was originally occupied by the oxygen, forming a dumbbell-like defect (O-VTe-Ge), which is in sharp contrast to the results of ab initio total energy calculations at 0 K showing that the oxygen prefers to substitute Te in crystalline GeTe. This specific defect configuration is found to be responsible for the slower crystallization speed and hence the improved data retention of oxygen doped GeTe as reported in recent experimental work. Moreover, we find that the oxygen will increase the effective mass of the carrier and thus increases the resistivity of GeTe. Our results unravel the microscopic mechanism of the oxygen-doping optimization of phase-change material GeTe, and the present reported mechanism can be applied to other oxygen doped ternary chalcogenide phase-change materials.
GeTe is a prototypical phase change material of high interest for applications in optical and electronic non-volatile memories. We present an interatomic potential for the bulk phases of GeTe, which is created using a neural network (NN) representati
on of the potential-energy surface obtained from reference calculations based on density functional theory. It is demonstrated that the NN potential provides a close to ab initio quality description of a number of properties of liquid, crystalline and amorphous GeTe. The availability of a reliable classical potential allows addressing a number of issues of interest for the technological applications of phase change materials, which are presently beyond the capability of first principles molecular dynamics simulations.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
