اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدA controllable superconducting electromechanical oscillator with a suspended membrane
78
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We fabricate a microscale electromechanical system, in which a suspended superconducting membrane, treated as a mechanical oscillator, capacitively couples to a superconducting microwave resonator. As the microwave driving power increases, nonmonotonic dependence of the resonance frequency of the mechanical oscillator on the driving power has been observed. We also demonstrate the optical switching of the resonance frequency of the mechanical oscillator. Theoretical models for qualitative understanding of our experimental observations are presented. Our experiment may pave the way for the application of a mechanical oscillator with its resonance frequency controlled by the electromagnetic and/or optical fields, such as a microwave-optical interface and a controllable element in a superqubit-mechanical oscillator hybrid system.
قيم البحث
اقرأ أيضاً
We study spin transport through a suspended Cu channel by an electrical non-local 4-terminal measurement for future spin mechanics applications. A magnetoresistance due to spin transport through the suspended Cu channel is observed, and its magnitude
is comparable to that of a conventional fixed Cu lateral spin valve. The spin diffusion length in the suspended Cu channel is estimated to be 340 nm at room temperature from the spin signal dependence on the distance between the ferromagnetic injector and detector electrodes. This value is found to be slightly shorter than in a fixed Cu. The decrease in the spin diffusion length in the suspended Cu channel is attributed to an increase in spin scattering originating from naturally oxidized Cu at the bottom of the Cu channel.
Sympathetic cooling with ultracold atoms and atomic ions enables ultralow temperatures in systems where direct laser or evaporative cooling is not possible. It has so far been limited to the cooling of other microscopic particles, with masses up to $
90$ times larger than that of the coolant atom. Here we use ultracold atoms to sympathetically cool the vibrations of a Si$_3$N$_4$ nanomembrane, whose mass exceeds that of the atomic ensemble by a factor of $10^{10}$. The coupling of atomic and membrane vibrations is mediated by laser light over a macroscopic distance and enhanced by placing the membrane in an optical cavity. We observe cooling of the membrane vibrations from room temperature to $650pm 230$ mK, exploiting the large atom-membrane cooperativity of our hybrid optomechanical system. Our scheme enables ground-state cooling and quantum control of low-frequency oscillators such as nanomembranes or levitated nanoparticles, in a regime where purely optomechanical techniques cannot reach the ground state.
We implement a cavity opto-electromechanical system integrating electrical actuation capabilities of nanoelectromechanical devices with ultrasensitive mechanical transduction achieved via intra-cavity optomechanical coupling. Electrical gradient forc
es as large as 0.40 microN are realized, with simultaneous mechanical transduction sensitivity of 1.5 X 10^-18 m/rtHz representing a three orders of magnitude improvement over any nanoelectromechanical system to date. Opto-electromechanical feedback cooling is demonstrated, exhibiting strong squashing of the in-loop transduction signal. Out-of-loop transduction provides accurate temperature calibration even in the critical paradigm where measurement backaction induces opto-mechanical correlations.
Hybrid systems consisting of a quantum emitter coupled to a mechanical oscillator are receiving increasing attention for fundamental science and potential applications in quantum technologies. In contrast to most of the presented works, in which the
oscillator eigenfrequencies are irreversibly determined by the fabrication process, we present here a simple approach to obtain frequency-tunable mechanical resonators based on suspended nanomembranes. The method relies on a micromachined piezoelectric actuator, which we use both to drive resonant oscillations of a suspended Ga(Al)As membrane with embedded quantum dots and to fine tune their mechanical eigenfrequencies. Specifically, we excite oscillations with frequencies of at least 60 MHz by applying an AC voltage to the actuator and tune the eigenfrequencies by at least 25 times their linewidth by continuously varying the elastic stress state in the membranes through a DC voltage. The light emitted by optically excited quantum dots is used as sensitive local strain gauge to monitor the oscillation frequency and amplitude. We expect that our method has the potential to be applicable to other optomechanical systems based on dielectric and semiconductor membranes possibly operating in the quantum regime.
We study the quantum dynamics of the cavity optomechanical system formed by a Fabry-Perot cavity with a thin vibrating membrane at its center. We first derive the general multimode Hamiltonian describing the radiation pressure interaction between the
cavity modes and the vibrational modes of the membrane. We then restrict the analysis to the standard case of a single cavity mode interacting with a single mechanical resonator and we determine to what extent optical absorption by the membrane hinder reaching a quantum regime for the cavity-membrane system. We show that membrane absorption does not pose serious limitations and that one can simultaneously achieve ground state cooling of a vibrational mode of the membrane and stationary optomechanical entanglement with state-of-the-art apparatuses.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
