اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدDensities Probed by Coronal Type III Radio Burst Imaging
109
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We present coronal density profiles derived from low-frequency (80-240 MHz) imaging of three type III solar radio bursts observed at the limb by the Murchison Widefield Array (MWA). Each event is associated with a white light streamer at larger heights and is plausibly associated with thin extreme ultraviolet rays at lower heights. Assuming harmonic plasma emission, we find average electron densities of 1.8 x10^8 cm^-3 down to 0.20 x10^8 cm^-3 at heights of 1.3 to 1.9 solar radii. These values represent roughly 2.4-5.4x enhancements over canonical background levels and are comparable to the highest streamer densities obtained from data at other wavelengths. Assuming fundamental emission instead would increase the densities by a factor of 4. High densities inferred from type III source heights can be explained by assuming that the exciting electron beams travel along overdense fibers or by radio propagation effects that may cause a source to appear at a larger height than the true emission site. We review the arguments for both scenarios in light of recent results. We compare the extent of the quiescent corona to model predictions to estimate the impact of propagation effects, which we conclude can only partially explain the apparent density enhancements. Finally, we use the time- and frequency-varying source positions to estimate electron beam speeds of between 0.24 and 0.60 c.
قيم البحث
اقرأ أيضاً
Type III bursts and hard X-rays are both produced by flare energetic electron beams. The link between both emissions has been investigated in many previous studies, but no statistical studies have compared both coronal and interplanetary type III bur
sts with X-ray flares. Using coronal radio events above 100 MHz exclusively from type III bursts, we revisited long-standing questions: Do all coronal type III bursts have X-ray counterparts. What correlation, if any, occurs between radio and X-ray intensities. What X-ray and radio signatures above 100 MHz occur in connection with interplanetary type III bursts below 14 MHz. We analysed data from 2002 to 2011 starting with coronal type III bursts above 100 MHz. We used RHESSI X-ray data greater than 6 keV to make a list of 321 events that have associated type III bursts and X-ray flares, encompassing at least 28 percent of the initial sample of type III events. We examined the timings, intensities, associated GOES class, and any interplanetary radio signature. For our 321 events, the X-ray emission at 6 keV usually lasted longer than type III burst groups at frequencies greater than 100 MHz. A weak correlation was found between the type III radio flux at frequencies below 327 MHz and the X-ray intensity at 25-50 keV, with an absence of events at high X-ray intensity and low type III radio flux. Interplanetary type III bursts less than 14 MHz were observed for 54 percent of the events, increasing when events were observed with 25-50 keV X-rays. A stronger interplanetary association was present when 25-50 keV count rates were above 250 counts per second or 170 MHz fluxes were greater than 1000 SFU, relating to more energetic electrons above 25 keV and events where magnetic flux tubes extend into the high corona. On average type III bursts increase in flux with decreasing frequency, the rate varies from event to event.
The Type-II solar radio burst recorded on 13 June 2010 by the radio spectrograph of the Hiraiso Solar Observatory was employed to estimate the magnetic-field strength in the solar corona. The burst was characterized by a well pronounced band-splittin
g, which we used to estimate the density jump at the shock and Alfven Mach number using the Rankine-Hugoniot relations. The plasma frequency of the Type-II bursts is converted into height [R] in solar radii using the appropriate density model, then we estimated the shock speed [Vs], coronal Alfven velocity [Va], and the magnetic-field strength at different heights. The relative bandwidth of the band-split is found to be in the range 0.2 -- 0.25, corresponding to the density jump of X = 1.44 -- 1.56, and the Alfven Mach number of MA = 1.35 -- 1.45. The inferred mean shock speed was on the order of V ~ 667 km/s. From the dependencies V(R) and MA(R) we found that Alfven speed slightly decreases at R ~ 1.3 -- 1.5. The magnetic-field strength decreases from a value between 2.7 and 1.7 G at R ~ 1.3 -- 1.5 Rs depending on the coronal-density model employed. We find that our results are in good agreement with the empirical scaling by Dulk and McLean (Solar Phys. 57, 279, 1978) and Gopalswamy et al. (Astrophys. J. 744, 72, 2012). Our result shows that Type-II band splitting method is an important tool for inferring the coronal magnetic field, especially when independent measurements were made from white light observations.
The Sun is an active source of radio emission which is often associated with energetic phenomena such as solar flares and coronal mass ejections (CMEs). At low radio frequencies (<100 MHz), the Sun has not been imaged extensively because of the instr
umental limitations of previous radio telescopes. Here, the combined high spatial, spectral and temporal resolution of the Low Frequency Array (LOFAR) was used to study solar Type III radio bursts at 30-90 MHz and their association with CMEs. The Sun was imaged with 126 simultaneous tied-array beams within 5 solar radii of the solar centre. This method offers benefits over standard interferometric imaging since each beam produces high temporal (83 ms) and spectral resolution (12.5 kHz) dynamic spectra at an array of spatial locations centred on the Sun. LOFARs standard interferometric output is currently limited to one image per second. Over a period of 30 minutes, multiple Type III radio bursts were observed, a number of which were found to be located at high altitudes (4 solar radii from the solar center at 30 MHz) and to have non-radial trajectories. These bursts occurred at altitudes in excess of values predicted by 1D radial electron density models. The non-radial high altitude Type III bursts were found to be associated with the expanding flank of a CME. The CME may have compressed neighbouring streamer plasma producing larger electron densities at high altitudes, while the non-radial burst trajectories can be explained by the deflection of radial magnetic fields as the CME expanded in the low corona.
Simultaneous radio and extreme ultraviolet (EUV)/white-light imaging data are examined for a solar type II radio burst occurring on 2010 March 18 to deduce its source location. Using a bow-shock model, we reconstruct the 3-dimensional EUV wave front
(presumably the type-II emitting shock) based on the imaging data of the two STEREO spacecraft. It is then combined with the Nanc{c}ay radio imaging data to infer the 3-dimensional position of the type II source. It is found that the type II source coincides with the interface between the CME EUV wave front and a nearby coronal ray structure, providing evidence that the type II emission is physically related to the CME-ray interaction. This result, consistent with those of previous studies, is based on simultaneous radio and EUV imaging data for the first time.
We present low-frequency (80-240 MHz) radio imaging of type III solar radio bursts observed by the Murchison Widefield Array (MWA) on 2015/09/21. The source region for each burst splits from one dominant component at higher frequencies into two incre
asingly-separated components at lower frequencies. For channels below ~132 MHz, the two components repetitively diverge at high speeds (0.1-0.4 c) along directions tangent to the limb, with each episode lasting just ~2 s. We argue that both effects result from the strong magnetic field connectivity gradient that the burst-driving electron beams move into. Persistence mapping of extreme ultraviolet (EUV) jets observed by the Solar Dynamics Observatory reveals quasi-separatrix layers (QSLs) associated with coronal null points, including separatrix dome, spine, and curtain structures. Electrons are accelerated at the flare site toward an open QSL, where the beams follow diverging field lines to produce the source splitting, with larger separations at larger heights (lower frequencies). The splitting motion within individual frequency bands is interpreted as a projected time-of-flight effect, whereby electrons traveling along the outer field lines take slightly longer to excite emission at adjacent positions. Given this interpretation, we estimate an average beam speed of 0.2 c. We also qualitatively describe the quiescent corona, noting in particular that a disk-center coronal hole transitions from being dark at higher frequencies to bright at lower frequencies, turning over around 120 MHz. These observations are compared to synthetic images based on the Magnetohydrodynamic Algorithm outside a Sphere (MAS) model, which we use to flux-calibrate the burst data.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
