اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدSpin inversion in graphene spin valves by gate-tunable magnetic proximity effect at one-dimensional contacts
189
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Graphene has remarkable opportunities for spintronics due to its high mobility and long spin diffusion length, especially when encapsulated in hexagonal boron nitride (h-BN). Here, for the first time, we demonstrate gate-tunable spin transport in such encapsulated graphene-based spin valves with one-dimensional (1D) ferromagnetic edge contacts. An electrostatic backgate tunes the Fermi level of graphene to probe different energy levels of the spin-polarized density of states (DOS) of the 1D ferromagnetic contact, which interact through a magnetic proximity effect (MPE) that induces ferromagnetism in graphene. In contrast to conventional spin valves, where switching between high- and low-resistance configuration requires magnetization reversal by an applied magnetic field or a high-density spin-polarized current, we provide an alternative path with the gate-controlled spin inversion in graphene. The resulting tunable MPE employing a simple ferromagnetic metal holds promise for spintronic devices and to realize exotic topological states, from quantum spin Hall and quantum anomalous Hall effects, to Majorana fermions and skyrmions.
قيم البحث
اقرأ أيضاً
Spin orbit coupling (SOC) is the key to realizing time-reversal invariant topological phases of matter. Famously, SOC was predicted by Kane and Mele to stabilize a quantum spin Hall insulator; however, the weak intrinsic SOC in monolayer graphene has
precluded experimental observation. Here, we exploit a layer-selective proximity effect---achieved via van der Waals contact to a semiconducting transition metal dichalcogenide--to engineer Kane-Mele SOC in ultra-clean textit{bilayer} graphene. Using high-resolution capacitance measurements to probe the bulk electronic compressibility, we find that SOC leads to the formation of a distinct incompressible, gapped phase at charge neutrality. The experimental data agrees quantitatively with a simple theoretical model in which the new phase results from SOC-driven band inversion. In contrast to Kane-Mele SOC in monolayer graphene, the inverted phase is not expected to be a time reversal invariant topological insulator, despite being separated from conventional band insulators by electric field tuned phase transitions where crystal symmetry mandates that the bulk gap must close. Electrical transport measurements, conspicuously, reveal that the inverted phase has a conductivity $sim e^2/h$, which is suppressed by exceptionally small in-plane magnetic fields. The high conductivity and anomalous magnetoresistance are consistent with theoretical models that predict helical edge states within the inversted phase, that are protected from backscattering by an emergent spin symmetry that remains robust even for large Rashba SOC. Our results pave the way for proximity engineering of strong topological insulators as well as correlated quantum phases in the strong spin-orbit regime in graphene heterostructures.
An in situ measurement of spin transport in a graphene nonlocal spin valve is used to quantify the spin current absorbed by a small (250 nm $times$ 750 nm) metallic island. The experiment allows for successive depositions of either Fe or Cu without b
reaking vacuum, so that the thickness of the island is the only parameter that is varied. Furthermore, by measuring the effect of the island using separate contacts for injection and detection, we isolate the effect of spin absorption from any change in the spin injection and detection mechanisms. As inferred from the thickness dependence, the effective spin current $j_e = frac{2e}{hbar} j_s$ absorbed by Fe is as large as $10^8$ A/m$^2$. The maximum value of $j_e$ is limited by the resistance-area product of the graphene/Fe interface, which is as small as 3 $Omegamu$m$^2$. The spin current absorbed by the same thickness of Cu is smaller than for Fe, as expected given the longer spin diffusion length and larger spin resistance of Cu compared to Fe. These results allow for a quantitative assessment of the prospects for achieving spin transfer torque switching of a nanomagnet using a graphene-based nonlocal spin valve.
We report an efficient technique to induce gate-tunable two-dimensional superlattices in graphene by the combined action of a back gate and a few-layer graphene patterned bottom gate complementary to existing methods. The patterned gates in our appro
ach can be easily fabricated and implemented in van der Waals stacking procedures allowing flexible use of superlattices with arbitrary geometry. In transport measurements on a superlattice with lattice constant $a=40$ nm well pronounced satellite Dirac points and signatures of the Hofstadter butterfly including a non-monotonic quantum Hall response are observed. Furthermore, the experimental results are accurately reproduced in transport simulations and show good agreement with features in the calculated band structure. Overall, we present a comprehensive picture of graphene-based superlattices, featuring a broad range of miniband effects, both in experiment and in theoretical modeling. The presented technique is suitable for studying more advanced geometries which are not accessible by other methods.
Spin-orbit coupling in graphene can be increased far beyond its intrinsic value by proximity coupling to a transition metal dichalcogenide. In bilayer graphene, this effect was predicted to depend on the occupancy of both graphene layers, rendering i
t gate-tunable by an out-of-plane electric field. We experimentally confirm this prediction by studying magnetotransport in a dual-gated WSe$_2$/bilayer graphene heterostructure. Weak antilocalization, which is characteristic for phase-coherent transport in diffusive samples with spin-orbit interaction, can be strongly enhanced or suppressed at constant carrier density, depending on the polarity of the electric field. From the spin-orbit scattering times extracted from the fits, we calculate the corresponding Rashba and intrinsic spin-orbit parameters. They show a strong dependence on the transverse electric field, which is well described by a gate-dependent layer polarization of bilayer graphene.
We demonstrate a flip-chip device for performing low-temperature acoustoelectric measurements on exfoliated two-dimensional materials. With this device, we study gate-tunable acoustoelectric transport in an exfoliated monolayer graphene device, measu
ring the voltage created as high-frequency surface acoustic waves dynamically drive the graphene charge carriers, the density of which we simultaneously control with a silicon back-gate. We demonstrate ambipolar dependence of the acoustoelectric signal, as expected from the sign of the graphene charge carriers. We observe a marked reduction in the magnitude of the acoustoelectric signal over a well-defined range of density in the vicinity of charge neutrality, which we attribute to a spatially heterogeneous charge-disorder landscape not directly revealed by conventional transport measurements.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
