اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدInfrared-transmittance tunable metal-insulator conversion device with thin-film-transistor-type structure on a glass substrate
114
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Infrared (IR) transmittance tunable metal-insulator conversion was demonstrated on glass substrate by using thermochromic vanadium dioxide (VO2) as the active layer in three-terminal thin-film-transistor-type device with water-infiltrated glass as the gate insulator. Alternative positive/negative gate-voltage applications induce the reversible protonation/deprotonation of VO2 channel, and two-orders of magnitude modulation of sheet-resistance and 49% modulation of IR-transmittance were simultaneously demonstrated at room temperature by the metal-insulator phase conversion of VO2 in a non-volatile manner. The present device is operable by the room-temperature protonation in all-solid-state structure, and thus it will provide a new gateway to future energy-saving technology as advanced smart window.
قيم البحث
اقرأ أيضاً
Growth of perovskite oxide thin films on Si in crystalline form has long been a critical obstacle for the integration of multifunctional oxides into Si-based technologies. In this study, we propose pulsed laser deposition of a crystalline SrTiO3 thin
film on a Si using graphene substrate. The SrTiO3 thin film on graphene has a highly (00l)-oriented crystalline structure which results from the partial epitaxy. Moreover, graphene promotes a sharp interface by highly suppressing the chemical intermixing. The important role of graphene as a 2D substrate and diffusion barrier allows expansion of device applications based on functional complex oxides.
We report a scalable approach to synthesize a large-area (up to 4 mm) thin black phosphorus (BP) film on a flexible substrate. We first deposited a red phosphorus (RP) thin-film on a flexible polyester substrate, followed by its conversion to BP in a
high-pressure multi-anvil cell at room temperature. Raman spectroscopy and transmission electron microscopy measurements confirmed the formation of a nano-crystalline BP thin-film with a thickness of around 40 nm. Optical characterization indicates a bandgap of around 0.28 eV in the converted BP, similar to the bandgap measured in exfoliated thin-films. Thin-film BP transistors exhibit a field-effect mobility of around 0.5 cm2/Vs, which can probably be further enhanced by the optimization of the conversion process at elevated temperatures. Our work opens the avenue for the future demonstration of large-scale, high quality thin-film black phosphorus.
We report herein fabrication and characterization of a thin-film transistor (TFT) using single-crystalline, epitaxial SrTiO3 film, which was grown by a pulsed laser deposition technique followed by the thermal annealing treatment in an oxygen atmosph
ere. Although TFTs on the polycrystalline epitaxial SrTiO3 films (as-deposited) exhibited poor transistor characteristics, the annealed single-crystalline SrTiO3 TFT exhibits transistor characteristics comparable with those of bulk single-crystal SrTiO3 FET: an on/off current ratio >10^5, sub-threshold swing ~2.1 V/decade, and field-effect mobility ~0.8 cm^2/Vs. This demonstrates the effectiveness of the appropriate thermal annealing treatment of epitaxial SrTiO3 films.
In this paper we used Raman spectroscopy to investigate the optical properties of vanadium dioxide (VO2) thin films during the thermally induced insulating to metallic phase transition. We observed a significant difference in transition temperature i
n similar VO2 films grown on quartz and sapphire substrates: the film grown on quartz displayed the phase transition at a lower temperature (Tc=50C) compared a film grown on sapphire (Tc=68C). We also investigated differences in the detected Raman signal for different wavelengths and polarizations of the excitation laser. We found that for either substrate, a longer wavelength (in our case 785 nm) yielded the clearest VO2 Raman spectra, with no polarization dependence.
In-vivo, real-time study of the local and collective cellular biomechanical responses requires the fine and selective manipulation of the cellular environment. One innovative pathway is the use of photoactive bio-substrates such as azobenzene-contain
ing materials (azopolymers), with optically tunable properties. In this work we show an innovative simple method to optically stimulate cells locally, by light-excitation of an azo-polymer derivative bio-substrate. Excited cells exhibit spectacular motility and reversible area shrinkage, which is dependent on the illumination. The photomechanical mechanisms taking place at the substrate and the cell/environment mechanical phenomena require further investigation.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
