اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدSculpting of lead sulfide nanoparticles by means of acetic acid and dichloroethane
192
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Colloidal lead sulfide is a versatile material with great opportunities to tune the bandgap by electronic confinement and to adapt the optical and electrical properties to the target application. We present a new and simple synthetic route to control size and shape of PbS nanoparticles. Increasing concentrations of explicitly added acetic acid are used to tune the shape of PbS nanoparticles from quasi-spherical particles via octahedrons to six-armed stars. The presence of acetate changes the intrinsic surface energies of the different crystal facets and enables the growth along the <100> direction. Furthermore, the presence of 1,2-dichloroethane alters the reaction kinetics, which results in smaller nanoparticles with a narrower size distribution.
قيم البحث
اقرأ أيضاً
We report on the effect of organic acid capping on the behavior of magnetite nanoparticles. The nanoparticles of magnetite were obtained using microwave activated process, and the magnetic properties as well as the electron magnetic resonance behavio
r were studied for the Fe3O4 nanoparticles capped with alginic acid. The capped nanoparticles exhibit improved crystalline structure of the surface which leads to an enhanced magnetization. The saturation magnetization Ms increases to ~75% of the bulk magnetization. The improved structure also facilitates quantization of spin-wave spectrum in the finite size nanoparticles and this in turn is responsible for unconventional behavior at low temperatures. In magnetic resonance these anomalies are manifested as an unusual increase in the resonant field Hr(T) and also as a maximum of the spectroscopic splitting geff parameter at low temperatures. The unconventional behavior of the nanoparticles also leads to pronounced upturn of magnetization at low temperatures and a deviation from the Bloch law M(T) T^3/2.
We report the first detection and high angular resolution (1.8 $times$ 1.1) imaging of acetic acid (CH$_3$COOH) and gGg$^{prime}$--ethylene glycol (gGg$^{prime}$(CH$_2$OH)$_2$) towards the Orion Kleinmann--Low nebula. The observations were carried ou
t at $sim$1.3mm with ALMA during the Cycle~2. A notable result is that the spatial distribution of the acetic acid and ethylene glycol emission differs from that of the other O-bearing molecules within Orion-KL. Indeed, while the typical emission of O-bearing species harbors a morphology associated with a V-shape linking the Hot Core region to the Compact Ridge (with an extension towards the BN object), that of acetic acid and ethylene glycol mainly peaks at about 2 southwest from the hot core region (near sources I and n). We find that the measured CH$_3$COOH:aGg$^{prime}$(CH$_2$OH)$_2$ and CH$_3$COOH:gGg$^{prime}$(CH$_2$OH)$_2$ ratios differ from the ones measured towards the low-mass protostar IRAS 16293--2422 by more than one order of magnitude. Our best hypothesis to explain these findings is that CH$_3$COOH, aGg$^{prime}$(CH$_2$OH)$_2$ and gGg$^{prime}$(CH$_2$OH)$_2$ are formed on the icy-surface of grains and then released into the gas-phase, via co-desorption with water, due to a bullet of matter ejected during the explosive event that occurred in the heart of the Nebula about 500-700 years ago.
Here we report successful growth of mm scale single crystals of stoichiometric FeSc2S4. Single crystal X-ray diffraction yields a cubic structure, spacegroup Fd-3m, with a=10.5097(2) angstroms at T=110(2) K consistent with previous literature on poly
crystallin samples. Models fit to the data reveal no detectable antisite mixing or deviations from the ideal stoichiometry. Heat capacity and dc magnetization measurements on the single crystals match those of high quality powder specimens. The novel traveling solvent growth method presented in this work opens the door to studies requiring sizable single crystals of the candidate spin-orbital liquid FeSc2S4.
We use the diffusion quantum Monte Carlo to revisit the enthalpy-pressure phase diagram of the various products from the different proposed decompositions of H$_2$S at pressures above 150~GPa. Our results entails a revision of the ground-state enthal
py-pressure phase diagram. Specifically, we find that the C2/c HS$_2$ structure is persistent up to 440~GPa before undergoing a phase transition into the C2/m phase. Contrary to density functional theory, our calculations suggest that the C2/m phase of HS is more stable than the I4$_1$/amd HS structure over the whole pressure range from 150 to 400 GPa. Moreover, we predict that the Im-3m phase is the most likely candidate for H$_3$S, which is consistent with recent experimental x-ray diffraction measurements.
A suite measurements of the electrical, thermal, and vibrational properties are conducted on palladium sulfide (PdS) in order to investigate its thermoelectric performance. The tetragonal structure with the space group $P$42/$m$ for PdS is determined
from X-ray diffraction measurement. The unique temperature dependence of mobility suggests that acoustic phonons and ion impurity scattering are two dominant scattering mechanisms within the compound. The obtained power factor of $27$ $mu$Wcm$^{-1}$K$^{-2}$ at 800 K is the largest value in the remaining transition-metal sulfides studied so far. The maximum value of the dimensionless figure of merit is 0.33 at 800 K. The observed phonon softening with temperature indicates that the reduction of the lattice thermal conductivity is mainly controlled by the enhanced lattice anharmonicity. These results indicate that the binary bulk PdS has promising potential to have good thermoelectrical performance.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
