اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدAnalytical Device-Physics Framework for Non-Planar Solar Cells
458
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Non-planar solar-cell devices have been promoted as a means to enhance current collection in absorber materials with charge-transport limitations. This work presents an analytical framework for assessing the ultimate performance of non-planar solar-cells based on materials and geometry. Herein, the physics of the p-n junction is analyzed for low-injection conditions, when the junction can be considered spatially separable into quasi-neutral and space-charge regions. For the conventional planar solar cell architecture, previously established one-dimensional expressions governing charge carrier transport are recovered from the framework established herein. Space-charge region recombination statistics are compared for planar and non-planar geometries, showing variations in recombination current produced from the space-charge region. In addition, planar and non-planar solar cell performance are simulated, based on a semi-empirical expression for short-circuit current, detailing variations in charge carrier transport and efficiency as a function of geometry, thereby yielding insights into design criteria for solar cell architectures. For the conditions considered here, the expressions for generation rate and total current are shown to universally govern any solar cell geometry, while recombination within the space-charge region is shown to be directly dependent on the geometrical orientation of the p-n junction.
قيم البحث
اقرأ أيضاً
We report on very high enhancement of thin layers absorption through band-engineering of a photonic crystal structure. We realized amorphous silicon (aSi) photonic crystals, where slow light modes improve absorption efficiency. We show through simula
tion that an increase of the absorption by a factor of 1.5 is expected for a film of aSi. The proposal is then validated by an experimental demonstration, showing an important increase of the absorption of a layer of aSi over a spectral range of 0.32-0.76 microns.
Heterostructures based on atomically thin semiconductors are considered a promising emerging technology for the realization of ultrathin and ultralight photovoltaic solar cells on flexible substrates. Much progress has been made in recent years on a
technological level, but a clear picture of the physical processes that govern the photovoltaic response remains elusive. Here, we present a device model that is able to fully reproduce the current-voltage characteristics of type-II van der Waals heterojunctions under optical illumination, including some peculiar behaviors such as exceedingly high ideality factors or bias-dependent photocurrents. While we find the spatial charge transfer across the junction to be very efficient, we also find a considerable accumulation of photogenerated carriers in the active device region due to poor electrical transport properties, giving rise to significant carrier recombination losses. Our results are important to optimize future device architectures and increase power conversion efficiencies of atomically thin solar cells.
The performance of organometallic perovskite solar cells has rapidly surpassed that of both conventional dye-sensitised and organic photovoltaics. High power conversion efficiency can be realised in both mesoporous and thin-film device architectures.
We address the origin of this success in the context of the materials chemistry and physics of the bulk perovskite as described by electronic structure calculations. In addition to the basic optoelectronic properties essential for an efficient photovoltaic device (spectrally suitable band gap, high optical absorption, low carrier effective masses), the materials are structurally and compositionally flexible. As we show, hybrid perovskites exhibit spontaneous electric polarisation; we also suggest ways in which this can be tuned through judicious choice of the organic cation. The presence of ferroelectric domains will result in internal junctions that may aid separation of photoexcited electron and hole pairs, and reduction of recombination through segregation of charge carriers. The combination of high dielectric constant and low effective mass promotes both Wannier-Mott exciton separation and effective ionisation of donor and acceptor defects. The photoferroic effect could be exploited in nanostructured films to generate a higher open circuit voltage and may contribute to the current-voltage hysteresis observed in perovskite solar cells.
Graphene has attracted increasing interests due to its remarkable properties, however, the zero band gap of monolayer graphene might limit its further electronic and optoelectronic applications. Herein, we have successfully synthesized monolayer sili
con-doped graphene (SiG) in large area by chemical vapor deposition method. Raman spectroscopy and X-ray photoelectron spectroscopy measurements evidence silicon atoms are doped into graphene lattice with the doping level of 3.4 at%. The electrical measurement based on field effect transistor indicates that the band gap of graphene has been opened by silicon doping, which is around 0. 28 eV supported by the first-principle calculations, and the ultraviolet photoelectron spectroscopy demonstrates the work function of SiG is 0.13 eV larger than that of graphene. Moreover, the SiG/GaAs heterostructure solar cells show an improved power conversion efficiency of 33.7% in average than that of graphene/GaAs solar cells, which are attributed to the increased barrier height and improved interface quality. Our results suggest silicon doping can effectively engineer the band gap of monolayer graphene and SiG has great potential in optoelectronic device applications.
Photovoltaic effect, e.g., solar cells, converts light into DC electric current. This phenomenon takes place in various setups such as in noncentrosymmetric crystals and semiconductor pn junctions. Recently, we proposed a theory for producing DC spin
current in magnets using electromagnetic waves, i.e., the spin-current counterpart of the solar cells. Our calculation shows that the nonlinear conductivity for the spin current is nonzero in a variety of noncentrosymmetric magnets, implying that the phenomenon is ubiquitous in inversion-asymmetric materials with magnetic excitations. Intuitively, this phenomenon is a bulk photovoltaic effect of magnetic excitations, where electrons and holes, visible light, and inversion-asymmetric semiconductors are replaced with magnons or spinons, THz or GHz waves, and asymmetric magnetic insulators, respectively. We also show that the photon-driven spin current is shift current type, and as a result, the current is stable against impurity scattering. This bulk photovoltaic spin current is in sharp contrast to that of well-known spin pumping that takes place at the interface between a magnet and a metal.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
