اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدBulk Superconductivity in Fe1+yTe0.6Se0.4 Induced by Removal of Excess Fe
135
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Experimental evidences from transport, magnetic, and magneto-optical (MO) image measurements confirmed that arsenic (As) vapor annealing was another effective way to induce bulk superconductivity with isotropic, large, and homogenous superconducting critical current density (Jc) in Fe1+yTe0.6Se0.4 single crystal. Since As is an exotic and easily detectable heavy element to Fe1+yTe0.6Se0.4 single crystal, As vapor annealing is very advantageous for the study of annealing mechanism. Detailed micro-structural and elemental analyses exclude the possibility that intercalating or doping effect may happen in the other post-annealing methods, proving that Fe reacts with As on the surface of the crystal and the reaction itself acts as a driving force to drag excess Fe out. The removal of excess Fe results in the good superconductivity performance.
قيم البحث
اقرأ أيضاً
We have investigated the effect of Fe nonstoichiometry on properties of the Fe1+y(Te, Se) superconductor system by means of resistivity, Hall coefficient, magnetic susceptibility, and specific heat measurements. We find that the excess Fe at intersti
tial sites of the (Te, Se) layers not only suppresses superconductivity, but also results in a weakly localized electronic state. We argue that these effects originate from the magnetic coupling between the excess Fe and the adjacent Fe square planar sheets, which favors a short-range magnetic order.
Effects of iodine annealing to induce bulk superconductivity in Fe1+yTe0.6Se0.4 have been systematically studied by changing the molar ratio of iodine to the sample and annealing temperature. The optimal condition to induce bulk superconductivity wit
h Tc ~14.5 K and self-field Jc(2 K) ~ 5x10^5 A/cm2 is found to be a molar ratio of iodine of 5-7 % at the annealing temperature of 400 C. Furthermore, the fact that no compounds containing iodine are detected in the crystal and a significant amount of FeTe2 is produced after the iodine annealing strongly indicate that the excess iron is consumed to form FeTe2 and iodine works as a catalyst in this process.
We have systematically investigated and compared different methods to induce superconductivity in iron chalcogenide Fe1+yTe0.6Se0.4 including annealing in vacuum, N2, O2, I2 atmosphere, and immersing samples into acid and alcoholic beverages. Vacuum
and N2 annealing are proved to be ineffective to induce superconductivity in Fe1+yTe0.6Se0.4 single crystal. O2 and I2 annealing, acid and alcoholic beverages can induce superconductivity by oxidizing the excess Fe in the sample. Superconductivity in O2 annealed sample is in bulk nature, while I2, acid and alcoholic beverages can only induce superconductivity near the surface. By comparing different effects of O2, I2, acid and alcoholic beverages, we propose a scenario to explain how the superconductivity is induced in the non-superconducting as-grown Fe1+yTe0.6Se0.4.
We have investigated Se substitution effect to superconductivity of an optimally-doped BiS2-based superconductor Eu0.5La0.5FBiS2. Eu0.5La0.5FBiS2-xSex samples with x = 0-1 were synthesized. With increasing x, in-plane chemical pressure is enhanced. F
or x = 0.6, 0.8, and 1, superconducting transitions with a large shielding volume fraction are observed in magnetic susceptibility measurements, and the highest Tc is 3.8 K for x = 0.8. From low-temperature electrical resistivity measurements, a zero-resistivity state is observed for all the samples, and the highest Tc is observed for x = 0.8. With increasing Se concentration, characteristics of electrical resistivity changes from semiconducting-like to metallic, suggesting that the emergence of bulk superconductivity is linked with the enhanced metallicity. A superconductivity phase diagram of the Eu0.5La0.5FBiS2-xSex superconductor is established. Temperature dependences of electrical resistivity show an anomalous two-step transition under high magnetic fields. Hence, the resistivity data are analyzed with assuming in-plane anisotropy of upper critical field.
Several superconducting transition temperatures in the range of 30-40 K were reported in the recently discovered intercalated FeSe sytem (A1-xFe2-ySe2, A = K, Rb, Cs, Tl). Although the superconducting phases were not yet conclusively decided, more th
an one magnetic phase with particular orders of iron vacancy and/or potassium vacancy were identified, and some were argued to be the parent phase. Here we show the discovery of the presence and ordering of iron vacancy in nonintercalated FeSe (PbO-type tetragonal {beta}-Fe1-xSe). Three types of iron-vacancy order were found through analytical electron microscopy, and one was identified to be nonsuperconducting and magnetic at low temperature. This discovery suggests that the rich-phases found in A1-xFe2-ySe2 are not exclusive in Fe-Se related superconductors. In addition, the magnetic {beta}-Fe1-xSe phases with particular iron-vacancy orders are more likely to be the parent phase of FeSe superconducting system, instead of the previously assigned {beta}-Fe1+{delta}Te.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
