اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدEvolution Process of Wurtzite ZnO Films on Cubic MgO (001) Substrates: a Structural, Optical and Electronic Investigation of the Misfit Structures
91
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
The interface between hexagonal ZnO films and cubic MgO (001) substrates, fabricated through molecular beam epitaxy, are thoroughly investigated. X-ray diffraction and (scanning) transmission electron microscopy reveal that, at the substrate temperature above 200 degree C, the growth follows the single [0001] direction; while at the substrate below 150 degree C, the growth is initially along [0001] and then mainly changes to [0-332] variants beyond the thickness of about 10 nm. Interestingly, a double-domain feature with a rotational angle of 30 degree appears for the growth along [0001] regardless of the growth temperature, experimentally demonstrated the theoretical predictions for occurrence of double rotational domains in such a heteroepitaxy [Grundmann et al, Phys. Rev. Lett. 105, 146102 (2010)]. It is also found that, the optical transmissivity of the ZnO film is greatly influenced by the mutation of growth directions, stimulated by the bond-length modulations, as further determined by X-ray absorption Spectra (XAS) at Zn K edge. The XAS results also show the evolution of 4pxy and 4pz states in the conduction band as the growth temperature increases. The results obtained from this work can hopefully promote the applications of ZnO in advanced optoelectronics for which its integration with other materials of different phases is desirable.
قيم البحث
اقرأ أيضاً
Magnetite thin fims have been grown epitaxially on ZnO and MgO substrates using molecular beam epitaxy. The film quality was found to be strongly dependent on the oxygen partial pressure during growth. Structural, electronic, and magnetic properties
were analyzed utilizing Low Energy Electron Diffraction (LEED), HArd X-ray PhotoElectron Spectroscopy (HAXPES), Magneto Optical Kerr Effect (MOKE), and X-ray Magnetic Circular Dichroism (XMCD). Diffraction patterns show clear indication for growth in the (111) direction on ZnO. Vertical structure analysis by HAXPES depth profiling revealed uniform magnetite thin films on both type of substrates. Both, MOKE and XMCD measurements show in-plane easy magnetization with a reduced magnetic moment in case of the films on ZnO.
Co2FeAl (CFA) thin films with thickness varying from 10 nm to 115 nm have been deposited on MgO(001) substrates by magnetron sputtering and then capped by Ta or Cr layer. X-rays diffraction (XRD) revealed that the cubic $[001]$ CFA axis is normal to
the substrate and that all the CFA films exhibit full epitaxial growth. The chemical order varies from the $B2$ phase to the $A2$ phase when decreasing the thickness. Magneto-optical Kerr effect (MOKE) and vibrating sample magnetometer measurements show that, depending on the field orientation, one or two-step switchings occur. Moreover, the films present a quadratic MOKE signal increasing with the CFA thickness, due to the increasing chemical order. Ferromagnetic resonance, MOKE transverse bias initial inverse susceptibility and torque (TBIIST) measurements reveal that the in-plane anisotropy results from the superposition of a uniaxial and of a fourfold symmetry term. The fourfold anisotropy is in accord with the crystal structure of the samples and is correlated to the biaxial strain and to the chemical order present in the films. In addition, a large negative perpendicular uniaxial anisotropy is observed. Frequency and angular dependences of the FMR linewidth show two magnon scattering and mosaicity contributions, which depend on the CFA thickness. A Gilbert damping coefficient as low as 0.0011 is found.
High quality ZnO thin films were gown using the pulsed laser deposition technique on (0001) Al$_2$O$_3$ substrates in an oxidizing atmosphere, using a Zn metallic target. We varied the growth conditions such as the deposition temperature and the oxyg
en pressure. First, using a battery of techniques such as x-rays diffraction, Rutherford Backscattering spectroscopy and atomic force microscopy, we evaluated the structural quality, the stress and the degree of epitaxy of the films. Second, the relations between the deposition conditions and the structural properties, that are directly related to the nature of the thin films, are discussed qualitatively. Finally, a number of issues on how to get good-quality ZnO films are addressed.
Spintronics exploits the magnetoresistance effects to store or sense the magnetic information. Since the magnetoresistance strictly depends on the magnetic anisotropy of the system, it is fundamental to set a defined anisotropy to the system. Here, w
e investigate by means of vectorial Magneto-Optical Kerr Magnetometry (v-MOKE), half-metallic La0.67Sr0.33MnO3 (LSMO) thin films that exhibit at room temperature pure biaxial magnetic anisotropy if grown onto MgO (001) substrate with a thin SrTiO3 (STO) buffer. In this way, we can avoid unwanted uniaxial magnetic anisotropy contributions that may be detrimental for specific applications. The detailed study of the angular evolution of the magnetization reversal pathways, critical fields (coercivity and switching) allows for disclosing the origin of the magnetic anisotropy, which is magnetocrystalline in nature and shows four-fold symmetry at any temperature.
Two-dimensional (2D) compounds provide unique building blocks for novel layered devices and hybrid photonic structures. However, large surface-to-volume ratio in thin films enhances the significance of surface interactions and charging effects requir
ing new understanding. Here we use micro-photoluminescence (PL) and ultrasonic force microscopy to explore the influence of the dielectric environment on optical properties of a few monolayer MoS2 films. PL spectra for MoS2 films deposited on SiO2 substrates are found to vary widely. This film-to-film variation is suppressed by additional capping of MoS2 with SiO2 and SiN, improving mechanical coupling of MoS2 with surrounding dielectrics. We show that the observed PL non-uniformities are related to strong variation in the local electron charging of MoS2 films. In completely encapsulated films, negative charging is enhanced leading to uniform optical properties. Observed great sensitivity of optical characteristics of 2D films to surface interactions has important implications for optoelectronics applications of layered materials.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
