اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدMobility Enhancement by Sb-mediated Minimisation of Stacking Fault Density in InAs Nanowires Grown on Silicon
97
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We report the growth of InAs$_{1-x}$Sb$_{x}$ nanowires ($0leq x leq 0.15$) grown by catalyst-free molecular beam epitaxy on silicon (111) substrates. We observed a sharp decrease of stacking fault density in the InAs$_{1-x}$Sb$_{x}$ nanowire crystal structure with increasing antimony content. This decrease leads to a significant increase in the field-effect mobility, this being more than three times greater at room temperature for InAs$_{0.85}$Sb$_{0.15}$ nanowires than InAs nanowires.
قيم البحث
اقرأ أيضاً
We have investigated in-situ Si doping of InAs nanowires grown by molecular beam epitaxy from gold seeds. The effectiveness of n-type doping is confirmed by electrical measurements showing an increase of the electron density with the Si flux. We also
observe an increase of the electron density along the nanowires from the tip to the base, attributed to the dopant incorporation on the nanowire facets whereas no detectable incorporation occurs through the seed. Furthermore the Si incorporation strongly influences the lateral growth of the nanowires without giving rise to significant tapering, revealing the complex interplay between axial and lateral growth.
We report a significant and persistent enhancement of the conductivity in free-standing non intentionnaly doped InAs nanowires upon irradiation in ultra high vacuum. Combining four-point probe transport measurements performed on nanowires with differ
ent surface chemistries, field-effect based measurements and numerical simulations of the electron density, the change of the conductivity is found to be caused by the increase of the surface free carrier concentration. Although an electron beam of a few keV, typically used for the inspection and the processing of materials, propagates through the entire nanowire cross-section, we demonstrate that the nanowire electrical properties are predominantly affected by radiation-induced defects occuring at the nanowire surface and not in the bulk.
We realize growth of self-catalyzed core-shell GaAs/GaAsP nanowires (NWs) on Si substrates using molecular-beam epitaxy. Transmission electron microscopy (TEM) of single GaAs/GaAsP NWs confirms their high crystal quality and shows domination of the z
inc-blende phase. This is further confirmed in optics of single NWs, studied using cw and time-resolved photoluminescence (PL). A detailed comparison with uncapped GaAs NWs emphasizes the effect of the GaAsP capping in suppressing the non-radiative surface states: significant PL enhancement in the core-shell structures exceeding 2000 times at 10K is observed; in uncapped NWs PL is quenched at 60K whereas single core-shell GaAs/GaAsP NWs exhibit bright emission even at room temperature. From analysis of the PL temperature dependence in both types of NW we are able to determine the main carrier escape mechanisms leading to the PL quench.
InAs-based two-dimensional electron systems grown on lattice mismatched InP substrates offer a robust platform for the pursuit of topologically protected quantum computing. We investigated strained composite quantum wells of In$_{0.75}$Ga$_{0.25}$As/
InAs/In$_{0.75}$Ga$_{0.25}$As with In$_{0.75}$Al$_{0.25}$As barriers. By optimizing the widths of the In$_{0.75}$Ga$_{0.25}$As layers, the In$_{0.75}$Al$_{0.25}$As barrier, and the InAs quantum well we demonstrate mobility in excess of $1 times 10^{6},$cm$^{2}/$Vs. Mobility vs. density data indicates that scattering is dominated by a residual three dimensional distribution of charged impurities. We extract the Rashba parameter and spin-orbit length as important material parameters for investigations involving Majorana zero modes.
The generalized stacking fault (SFE) energy curves of pure gold (Au) and its binary alloys with transition metals are determined from density functional theory (DFT). Alloy elements Ag, Al, Cu, Ni, Ti, Zr, Zn, In, Ga, Sn, Mn, Cd, Sn, Ta and Cr are su
bstituted into Au at concentrations up to 4%. A comparison of various proposed methodologies to calculate SFEs is given. The intrinsic SFE decreases for all alloying elements from its value for pure Au, but SFE energies (both stable and unstable) vary strongly with the distance of the alloying element from the stacking fault region, and with alloy concentration. The compositional dependence of the SFE on the volume change associated with alloying element is determined. This work demonstrates that the SFE is strongly influenced by misfit strain caused by the alloying elements. Moreover, the computed generalized SFE curves provide information valuable to developing an understanding of the deformation behavior of Au and Au-alloys.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
