اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدBulk topological insulators as inborn spintronics detectors
297
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Detection and manipulation of electrons spins are key prerequisites for spin-based electronics or spintronics. This is usually achieved by contacting ferromagnets with metals or semiconductors, in which the relaxation of spins due to spin-orbit coupling limits both the efficiency and the length scale. In topological insulator materials, on the contrary, the spin-orbit coupling is so strong that the spin direction uniquely determines the current direction, which allows us to conceive a whole new scheme for spin detection and manipulation. Nevertheless, even the most basic process, the spin injection into a topological insulator from a ferromagnet, has not yet been demonstrated. Here we report successful spin injection into the surface states of topological insulators by using a spin pumping technique. By measuring the voltage that shows up across the samples as a result of spin pumping, we demonstrate that a spin-electricity conversion effect takes place in the surface states of bulk-insulating topological insulators Bi1.5Sb0.5Te1.7Se1.3 and Sn-doped Bi2Te2Se. In this process, due to the two-dimensional nature of the surface state, there is no spin current along the perpendicular direction. Hence, the mechanism of this phenomenon is different from the inverse spin Hall effect and even predicts perfect conversion between spin and electricity at room temperature. The present results reveal a great advantage of topological insulators as inborn spintronics devices.
قيم البحث
اقرأ أيضاً
Non-invasive local probes are needed to characterize bulk defects in binary and ternary chalcogenides. These defects contribute to the non-ideal behavior of topological insulators. We have studied bulk electronic properties via $^{125}$Te NMR in Bi$_
2$Te$_3$, Sb$_2$Te$_3$, Bi$_{0.5}$Sb$_{1.5}$Te$_3$, Bi$_2$Te$_2$Se and Bi$_2$Te$_2$S. A distribution of defects gives rise to asymmetry in the powder lineshapes. We show how the Knight shift, line shape and spin-lattice relaxation report on carrier density, spin-orbit coupling and phase separation in the bulk. The present study confirms that the ordered ternary compound Bi$_2$Te$_2$Se is the best TI candidate material at the present time. Our results, which are in good agreement with transport and ARPES studies, help establish the NMR probe as a valuable method to characterize the bulk properties of these materials.
Granular conductors form an artificially engineered class of solid state materials wherein the microstructure can be tuned to mimic a wide range of otherwise inaccessible physical systems. At the same time, topological insulators (TIs) have become a
cornerstone of modern condensed matter physics as materials hosting metallic states on the surface and insulating in the bulk. However it remains to be understood how granularity affects this new and exotic phase of matter. We perform electrical transport experiments on highly granular topological insulator thin films of Bi$_2$Se$_3$ and reveal remarkable properties. We observe clear signatures of topological surface states despite granularity with distinctly different properties from conventional bulk TI systems including sharp surface state coupling-decoupling transitions, large surface state penetration depths and exotic Berry phase effects. We present a model which explains these results. Our findings illustrate that granularity can be used to engineer designer TIs, at the same time allowing easy access to the Dirac-fermion physics that is inaccessible in single crystal systems.
We derive the spin texture of a weak topological insulator via a supersymmetric approach that includes the roles of the bulk gap edge states and surface band bending. We find the spin texture can take one of four forms: (i) helical, (ii) hyperbolic,
(iii) hedgehog, with spins normal to the Dirac-Weyl cone of the surface state, and (iv) hyperbolic hedgehog. Band bending determines the winding number in the case of a helical texture, and for all textures can be used to tune the spin texture polarization to zero. For the weak topological insulator SnTe, we show that inclusion of band bending is crucial to obtain the correct texture winding number for the (111) surface facet $Gamma$-point Dirac-Weyl cone. We argue that hedgehogs will be found only in low symmetry situations.
In this article, we will give a brief introduction to the topological insulators. We will briefly review some of the recent progresses, from both theoretical and experimental sides. In particular, we will emphasize the recent progresses achieved in China.
Topological crystalline insulators (TCIs) are insulating materials whose topological property relies on generic crystalline symmetries. Based on first-principles calculations, we study a three-dimensional (3D) crystal constructed by stacking two-dime
nsional TCI layers. Depending on the inter-layer interaction, the layered crystal can realize diverse 3D topological phases characterized by two mirror Chern numbers (MCNs) ($mu_1,mu_2$) defined on inequivalent mirror-invariant planes in the Brillouin zone. As an example, we demonstrate that new TCI phases can be realized in layered materials such as a PbSe (001) monolayer/h-BN heterostructure and can be tuned by mechanical strain. Our results shed light on the role of the MCNs on inequivalent mirror-symmetric planes in reciprocal space and open new possibilities for finding new topological materials.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
