اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدStellar Granulation as the Source of High-Frequency Flicker in Kepler Light Curves
109
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
A large fraction of cool, low-mass stars exhibit brightness fluctuations that arise from a combination of convective granulation, acoustic oscillations, magnetic activity, and stellar rotation. Much of the short-timescale variability takes the form of stochastic noise, whose presence may limit the progress of extrasolar planet detection and characterization. In order to lay the groundwork for extracting useful information from these quasi-random signals, we focus on the origin of the granulation-driven component of the variability. We apply existing theoretical scaling relations to predict the star-integrated variability amplitudes for 508 stars with photometric light curves measured by the Kepler mission. We also derive an empirical correction factor that aims to account for the suppression of convection in F-dwarf stars with magnetic activity and shallow convection zones. So that we can make predictions of specific observational quantities, we performed Monte Carlo simulations of granulation light curves using a Lorentzian power spectrum. These simulations allowed us to reproduce the so-called flicker floor (i.e., a lower bound in the relationship between the full light-curve range and power in short-timescale fluctuations) that was found in the Kepler data. The Monte Carlo model also enabled us to convert the modeled fluctuation variance into a flicker amplitude directly comparable with observations. When the magnetic suppression factor described above is applied, the model reproduces the observed correlation between stellar surface gravity and flicker amplitude. Observationally validated models like these provide new and complementary evidence for a possible impact of magnetic activity on the properties of near-surface convection.
قيم البحث
اقرأ أيضاً
In Bastien et al. (2013) we found that high quality light curves, such as those obtained by Kepler, may be used to measure stellar surface gravity via granulation-driven light curve flicker. Here, we update and extend the relation originally presente
d in Bastien et al. (2013) after calibrating flicker against a more robust set of asteroseismically derived surface gravities. We describe in detail how we extract the flicker signal from the light curves, including how we treat phenomena, such as exoplanet transits and shot noise, that adversely affect the measurement of flicker. We examine the limitations of the technique, and, as a result, we now provide an updated treatment of the flicker-based logg error. We briefly highlight further applications of the technique, such as astrodensity profiling or its use in other types of stars with convective outer layers. We discuss potential uses in current and upcoming space-based photometric missions. Finally, we supply flicker-based logg values, and their uncertainties, for 27 628 Kepler stars not identified as transiting-planet hosts, with 4500<teff<7150 K, 2.5<logg<4.6, Kepler magnitude <13.5, and overall photometric amplitudes <10 parts per thousand.
We present a detailed analysis of the bright Cepheid-type variable star V1154 Cygni using 4 years of continuous observations by the Kepler space telescope. We detected 28 frequencies using standard Fourier transform method.We identified modulation of
the main pulsation frequency and its harmonics with a period of ~159 d. This modulation is also present in the Fourier parameters of the light curve and the O-C diagram. We detected another modulation with a period of about 1160 d. The star also shows significant power in the low-frequency region that we identified as granulation noise. The effective timescale of the granulation agrees with the extrapolated scalings of red giant stars. Non-detection of solar-like oscillations indicates that the pulsation inhibits other oscillations. We obtained new radial velocity observations which are in a perfect agreement with previous years data, suggesting that there is no high mass star companion of V1154 Cygni. Finally, we discuss the possible origin of the detected frequency modulations.
We have modified the graphical user interfaced close binary system analysis program CurveFit to the form WinKepler and applied it to 16 representative planetary candidate light curves found in the NASA Exoplanet Archive (NEA) at the Caltech website h
ttp://exoplanetarchive.ipac.caltech.edu, with an aim to compare different analytical approaches. WinKepler has parameter options for a realistic physical model, including gravity-brightening and structural parameters derived from the relevant Radau equation. We tested our best-fitting parameter-sets for formal determinacy and adequacy. A primary aim is to compare our parameters with those listed in the NEA. Although there are trends of agreement, small differences in the main parameter values are found in some cases, and there may be some relative bias towards a 90 degrees value for the NEA inclinations. These are assessed against realistic error estimates. Photometric variability from causes other than planetary transits affects at least 6 of the data-sets studied; with small pulsational behaviour found in 3 of those. For the false positive KOI 4.01, we found that the eclipses could be modelled by a faint background classical Algol as effectively as by a transiting exoplanet. Our empirical checks of limb-darkening, in the cases of KOI 1.01 and 12.01, revealed that the assigned stellar temperatures are probably incorrect. For KOI 13.01, our empirical mass-ratio differs by about 7% from that of Mislis and Hodgkin (2012), who neglected structural effects and higher order terms in the tidal distortion. Such detailed parameter evaluation, additional to the usual main geometric ones, provides an additional objective for this work.
We present the results of a blind exercise to test the recoverability of stellar rotation and differential rotation in Kepler light curves. The simulated light curves lasted 1000 days and included activity cycles, Sun-like butterfly patterns, differe
ntial rotation and spot evolution. The range of rotation periods, activity levels and spot lifetime were chosen to be representative of the Kepler data of solar like stars. Of the 1000 simulated light curves, 770 were injected into actual quiescent Kepler light curves to simulate Kepler noise. The test also included five 1000-day segments of the Suns total irradiance variations at different points in the Suns activity cycle. Five teams took part in the blind exercise, plus two teams who participated after the content of the light curves had been released. The methods used included Lomb-Scargle periodograms and variants thereof, auto-correlation function, and wavelet-based analyses, plus spot modelling to search for differential rotation. The results show that the `overall period is well recovered for stars exhibiting low and moderate activity levels. Most teams reported values within 10% of the true value in 70% of the cases. There was, however, little correlation between the reported and simulated values of the differential rotation shear, suggesting that differential rotation studies based on full-disk light curves alone need to be treated with caution, at least for solar-type stars. The simulated light curves and associated parameters are available online for the community to test their own methods.
The solar granulation is known for a long time to be a surface manifestation of convection. Thanks to the current space-borne missions CoRoT and Kepler, it is now possible to observe in disk-integrated intensity the signature of this phenomena in a g
rowing number of stars. The space-based photometric measurements show that the global brightness fluctuations and the lifetime associated with granulation obeys characteristic scaling relations. We thus aim at providing a simple theoretical modeling to reproduce these scaling relations and subsequently at inferring the physical properties of granulation properties across the HR diagram. We develop a simple 1D theoretical model that enable us to test any prescription concerning the time-correlation between granules. The input parameters of the model are extracted from 3D hydrodynamical models of the surface layers of stars, and the free parameters involved in the model are calibrated with solar observations. Two different prescriptions for representing the eddy time-correlation in the Fourier space are compared: a Lorentzian and an exponential form. Finally, we compare our theoretical prediction with a 3D radiative hydrodynamical (RHD) numerical modeling of stellar granulation (ab-initio approach). Provided that the free parameters are appropriately adjusted, our theoretical model satisfactorily reproduces the shape and the amplitude of the observed solar granulation spectrum. The best agreement is obtained with an exponential form. Furthermore, our theoretical model results in granulation spectra that consistently agree with the these calculated on the basis of the ab-initio approach with two 3D RHD models. Comparison between theoretical granulation spectra calculated with the present model and high precision photometry measurements of stellar granulation is undertaken in a companion paper.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
