اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدThermally populated intrinsic localized modes in pure alkali halide crystals
113
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
The possibility of thermal excitation of intrinsic localized modes (ILMs) arising from anharmonicity in ionic perfect crystals is studied numerically for realistic model systems in one and three dimensions. Implications are discussed for an interesting high-temperature feature seen in earlier inelastic neutron scattering experiments on single crystal NaI. The general conclusion is that ILM formation energies are far too large for thermal excitation of ILMs to account for the observed feature in a pure crystal.
قيم البحث
اقرأ أيضاً
Inelastic neutron measurements of the high-temperature lattice excitations in NaI show that in thermal equilibrium at 555 K an intrinsic mode, localized in three dimensions, occurs at a single frequency near the center of the spectral phonon gap, pol
arized along [111]. At higher temperatures the intrinsic localized mode gains intensity. Higher energy inelastic neutron and x-ray scattering measurements on a room-temperature NaI crystal indicate that the creation energy of the ground state of the intrinsic localized mode is 299 meV.
The organic-inorganic hybrid perovskite CH3NH3PbI3 has attracted significant interest for its high performance in converting solar light into electrical power with an efficiency exceeding 20%. Unfortunately, chemical stability is one major challenge
in the development of the CH3NH3PbI3 solar cells. It was commonly assumed that moisture or oxygen in the environment causes the poor stability of hybrid halide perovskites, however, here we show from the first-principles calculations that the room-temperature tetragonal phase of CH3NH3PbI3 is thermodynamically unstable with respect to the phase separation into CH3NH3I + PbI2, i.e., the disproportionation is exothermic, independent of the humidity or oxygen in the atmosphere. When the structure is distorted to the low-temperature orthorhombic phase, the energetic cost of separation increases, but remains small. Contributions from vibrational and configurational entropy at room temperature have been considered, but the instability of CH3NH3PbI3 is unchanged. When I is replaced by Br or Cl, Pb by Sn, or the organic cation CH3NH3 by inorganic Cs, the perovskites become more stable and do not phase-separate spontaneously. Our study highlights that the poor chemical stability is intrinsic to CH3NH3PbI3 and suggests that element-substitution may solve the chemical stability problem in hybrid halide perovskite solar cells.
In nanostructure electronic devices, it is well-known that the optical lattice waves in the constituent semiconductor crystals have to obey both mechanical and electrical boundary conditions at an interface. The theory of hybrid optical modes, establ
ished for cubic crystals, is here applied to hexagonal crystals. In general, the hybrid is a linear combination of a longitudinally-polarized (LO) mode, an interface mode (IF), and an interface TO mode. It is noted that the dielectric and elastic anisotropy of these crystals add significant complications to the assessment of the electro-phonon interaction. We point out that, where extreme accuracy is not needed, a cubic approximation is available. The crucial role of lattice dispersion is emphasised. In the extreme long-wavelength limit, where lattice dispersion is unimportant, the polar optical hybrid consists of an LO component plus an IF component only. In his case no fields are induced in the barrier, and there are no remote-phonon effects.
We investigate nonlinear localized modes at light-mass impurities in a one-dimensional, strongly-compressed chain of beads under Hertzian contacts. Focusing on the case of one or two such defects, we analyze the problems linear limit to identify the
system eigenfrequencies and the linear defect modes. We then examine the bifurcation of nonlinear defect modes from their linear counterparts and study their linear stability in detail. We identify intriguing differences between the case of impurities in contact and ones that are not in contact. We find that the former bears similarities to the single defect case, whereas the latter features symmetry-breaking bifurcations with interesting static and dynamic implications.
We present a systematic study of the existence and stability of discrete breathers that are spatially localized in the bulk of a one-dimensional chain of compressed elastic beads that interact via Hertzian contact. The chain is diatomic, consisting o
f a periodic arrangement of heavy and light spherical particles. We examine two families of discrete gap breathers: (1) an unstable discrete gap breather that is centered on a heavy particle and characterized by a symmetric spatial energy profile and (2) a potentially stable discrete gap breather that is centered on a light particle and is characterized by an asymmetric spatial energy profile. We investigate their existence, structure, and stability throughout the band gap of the linear spectrum and classify them into four regimes: a regime near the lower optical band edge of the linear spectrum, a moderately discrete regime, a strongly discrete regime that lies deep within the band gap of the linearized version of the system, and a regime near the upper acoustic band edge. We contrast discrete breathers in anharmonic FPU-type diatomic chains with those in diatomic granular crystals, which have a tensionless interaction potential between adjacent particles, and highlight in that the asymmetric nature of the latter interaction potential may lead to a form of hybrid bulk-surface localized solutions.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
