اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدThe influence of oxygen and hydrogen adsorption on the magnetic structure of the ultrathin iron film on the Ir(001) surface
131
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We present a detailed ab initio study of the electronic structure and magnetic order of an Fe monolayer on the Ir(001) surface covered by adsorbed oxygen and hydrogen. The results are compared to the clean Fe/Ir(001) system, where recent intensive studies indicated a strong tendency towards an antiferromagnetic order and complex magnetic structures. The adsorption of an oxygen overlayer significantly increases interlayer distance between the Fe layer and the Ir substrate, while the effect of hydrogen is much weaker. We show that the adsorption of oxygen (and also of hydrogen) leads to a p(2$times $1) antiferromagnetic order of the Fe moments, which is also supported by an investigation based on a disordered local moment state. Simulated scanning tunneling images using the simple Tersoff-Hamann model hint that the proposed p(2$times $1) antiferromagnetic order could be detected even by non-magnetic tips.
قيم البحث
اقرأ أيضاً
The interaction of CO with the Fe3O4(001)-(rt2xrt2)R45{deg} surface was studied using temperature programmed desorption (TPD), scanning tunneling microscopy (STM) and x-ray photoelectron spectroscopy (XPS), the latter both under ultrahigh vacuum (UHV
) conditions and in CO pressures up to 1 mbar. In general, the CO-Fe3O4 interaction is found to be weak. The strongest adsorption occurs at surface defects, leading to small TPD peaks at 115 K, 130 K and 190 K. Desorption from the regular surface occurs in two distinct regimes. For coverages up to 2 CO molecules per (rt2xrt2)R45{deg} unit cell, the desorption maximum shows a large shift with increasing coverage, from initially 105 K to 70 K. For coverages between 2 and 4 molecules per (rt2xrt2)R45{deg} unit cell, a much sharper desorption feature emerges at 50 K. Thermodynamic analysis of the TPD data suggests a phase transition from a dilute 2D gas into an ordered overlayer with CO molecules bound to surface Fe3+ sites. XPS data acquired at 45 K in UHV are consistent with physisorption. Some carbon-containing species are observed in the near-ambient-pressure XPS experiments at room temperature, but are attributed to contamination and/or reaction with CO with water from the residual gas. No evidence was found for surface reduction or carburization by CO molecules.
We investigated the unoccupied part of the electronic structure of the oxygen-deficient hafnium oxide (HfO$_{sim1.8}$) using soft x-ray absorption spectroscopy at O $K$ and Hf $N_3$ edges. Band-tail states beneath the unoccupied Hf 5$d$ band are obse
rved in the O $K$-edge spectra; combined with ultraviolet photoemission spectrum, this indicates the non-negligible occupation of Hf 5$d$ state. However, Hf $N_3$-edge magnetic circular dichroism spectrum reveals the absence of a long-range ferromagnetic spin order in the oxide. Thus the small amount of $d$ electron gained by the vacancy formation does not show inter-site correlation, contrary to a recent report [M. Venkatesan {it et al.}, Nature {bf 430}, 630 (2004)].
The structural and magnetic properties of Fe octaethylporphyrin (OEP) molecules on Cu(001) have been investigated by means of density functional theory (DFT) methods and X-ray absorption spectroscopy. The molecules have been adsorbed on the bare meta
l surface and on an oxygen-covered surface, which shows a $sqrt{2}times2sqrt{2}R45^{circ}$ reconstruction. In order to allow for a direct comparison between magnetic moments obtained from sum-rule analysis and DFT we calculate the dipolar term $7< T_z>$, which is also important in view of the magnetic anisotropy of the molecule. The measured X-ray magnetic circular dichroism shows a strong dependence on the photon incidence angle, which we could relate to a huge value of $7< T_z>$, e.g. on Cu(001) $7< T_z>$ amounts to -2.07,mbo{} for normal incidence leading to a reduction of the effective spin moment $m_s + 7< T_z>$. Calculations have also been performed to study the influence of possible ligands such as Cl and O atoms on the magnetic properties of the molecule and the interaction between molecule and surface, because the experimental spectra display a clear dependence on the ligand, which is used to stabilize the molecule in the gas phase. Both types of ligands weaken the hybridization between surface and porphyrin molecule and change the magnetic spin state of the molecule, but the changes in the X-ray absorption are clearly related to residual Cl ligands.
The ability of atomic hydrogen to chemisorb on graphene makes the latter a promising material for hydrogen storage. Based on scanning tunneling microscopy techniques, we report on site-selective adsorption of atomic hydrogen on convexly curved region
s of monolayer graphene grown on SiC(0001). This system exhibits an intrinsic curvature owing to the interaction with the substrate. We show that at low coverage hydrogen is found on convex areas of the graphene lattice. No hydrogen is detected on concave regions. These findings are in agreement with theoretical models which suggest that both binding energy and adsorption barrier can be tuned by controlling the local curvature of the graphene lattice. This curvature-dependence combined with the known graphene flexibility may be exploited for storage and controlled release of hydrogen at room temperature making it a valuable candidate for the implementation of hydrogen-storage devices.
The effect of oxygen adsorption on the local structure and electronic properties of monolayer graphene grown on SiC(0001) has been studied by means of Low Energy Electron Microscopy (LEEM), microprobe Low Energy Electron Diffraction (muLEED) and micr
oprobe Angle Resolved Photoemission (muARPES). We show that the buffer layer of epitaxial graphene on SiC(0001) is partially decoupled after oxidation. The monitoring of the oxidation process demonstrates that the oxygen saturates the Si dangling bonds, breaks some Si-C bonds at the interface and intercalates the graphene layer. Accurate control over the oxidation parameters enables us to tune the charge density modulation in the layer.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
