اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدObserving coronal nanoflares in active region moss
294
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
The High-resolution Coronal Imager (Hi-C) has provided Fe XII 193A images of the upper transition region moss at an unprecedented spatial (~0.3-0.4 arcsec) and temporal (5.5s) resolution. The Hi-C observations show in some moss regions variability on timescales down to ~15s, significantly shorter than the minute scale variability typically found in previous observations of moss, therefore challenging the conclusion of moss being heated in a mostly steady manner. These rapid variability moss regions are located at the footpoints of bright hot coronal loops observed by SDO/AIA in the 94A channel, and by Hinode/XRT. The configuration of these loops is highly dynamic, and suggestive of slipping reconnection. We interpret these events as signatures of heating events associated with reconnection occurring in the overlying hot coronal loops, i.e., coronal nanoflares. We estimate the order of magnitude of the energy in these events to be of at least a few $10^{23}rg, also supporting the nanoflare scenario. These Hi-C observations suggest that future observations at comparable high spatial and temporal resolution, with more extensive temperature coverage are required to determine the exact characteristics of the heating mechanism(s).
قيم البحث
اقرأ أيضاً
Studying the Doppler shifts and the temperature dependence of Doppler shifts in moss regions can help us understand the heating processes in the core of the active regions. In this paper we have used an active region observation recorded by the Extre
me-ultraviolet Imaging Spectrometer (EIS) onboard Hinode on 12-Dec-2007 to measure the Doppler shifts in the moss regions. We have distinguished the moss regions from the rest of the active region by defining a low density cut-off as derived by Tripathi et al. (2010). We have carried out a very careful analysis of the EIS wavelength calibration based on the method described in Young et al. (2012). For spectral lines having maximum sensitivity between log T = 5.85 and log T = 6.25 K, we find that the velocity distribution peaks at around 0 km/s with an estimated error of 4-5 km/s. The width of the distribution decreases with temperature. The mean of the distribution shows a blue shift which increases with increasing temperature and the distribution also shows asymmetries towards blue-shift. Comparing these results with observables predicted from different coronal heating models, we find that these results are consistent with both steady and impulsive heating scenarios. However, the fact that there are a significant number of pixels showing velocity amplitudes that exceed the uncertainty of 5 km s$^{-1}$ is suggestive of impulsive heating. Clearly, further observational constraints are needed to distinguish between these two heating scenarios.
We present a study of the physical plasma parameters such as electron temperature, electron density, column depth and filling factors in the moss regions and their variability over a short (an hour) and a long period (5 consecutive days) of time. Pri
marily, we have analyzed the spectroscopic observations recorded by the Extreme-ultraviolet Imaging Spectrometer (EIS) aboard Hinode. In addition we have used supplementary observations taken from TRACE and the X-Ray Telescope (XRT). We find that the moss emission is strongest in the Fe xii and Fe xiii lines. Based on analyses using line ratios and emission measure we found that the moss region has a characteristic temperature of log T = 6.2. The electron densities measured at different locations in the moss regions using Fe xii ratios are about 1-3times1010 cm(-3) and about 2-4times10^9 cm^(-3) using Fe xiii and Fe xiv. The electron density substantially increases (by a factor of about 3-4 or even more in some cases) when a background subtraction was performed. The density and temperature show very small variation over time. The filling factor of the moss plasma can vary between 0.1-1 and the path length along which the emission originates is from a few 100 to a few 1000 kms long. By combining the observations recorded by TRACE, EIS and XRT, we find that the moss regions correspond to the foot-points of both hot and warm loops.
The million degree plasma of the solar corona must be supplied by the underlying layers of the atmosphere. The mechanism and location of energy release, and the precise source of coronal plasma, remain unresolved. In earlier work we pursued the idea
that warm plasma is supplied to the corona via direct heating of the chromosphere by nanoflares, contrary to the prevailing belief that the corona is heated in-situ and the chromosphere is subsequently energized and ablated by thermal conduction. We found that single (low-frequency) chromospheric nanoflares could not explain the observed intensities, Doppler-shifts, and red/blue asymmetries in Fe XII and XIV emission lines. In the present work we follow up on another suggestion that the corona could be powered by chromospheric nanoflares that repeat on a timescale substantially shorter than the cooling/draining timescale. That is, a single magnetic strand is re-supplied with coronal plasma before the existing plasma has time to cool and drain. We perform a series of hydrodynamic experiments and predict the Fe XII and XIV line intensities, Doppler-shifts, and red/blue asymmetries. We find that our predicted quantities disagree dramatically with observations and fully developed loop structures cannot be created by intermediate- or high-frequency chromospheric nanoflares. We conclude that the mechanism ultimately responsible for producing coronal plasma operates above the chromosphere, but this does not preclude the possibility of a similar mechanism powering the chromosphere; extreme examples of which may be responsible for heating chromospheric plasma to transition region temperatures (e.g. type II spicules).
In this paper, we report the observed temporal correlation between extreme-violet (EUV) emission and magneto-acoustic oscillations in a EUV moss region, which is the footpoint region only connected by magnetic loops with million-degree plasma. The re
sult is obtained from a detailed multi-wavelength data analysis to the region with the purpose of resolving fine-scale mass and energy flows that come from the photosphere, pass through the chromosphere and finally heat solar transition region or the corona. The data set covers three atmospheric levels on the Sun, consisting of high-resolution broad-band imaging at TiO 7057 AA and the line of sight magnetograms for the photosphere, high-resolution narrow-band images at Helium textsc{i} 10830 AA for the chromosphere and EUV images at 171 AA for the corona. We report following new phenomena: 1) Repeated injections of chromospheric material shown as 10830 AA absorption are squirted out from inter-granular lanes with the period of $sim$ 5 minutes. 2) EUV emissions are found to be periodically modulated with the similar periods of $sim$ 5 minutes. 3) Around the injection area where 10830 AA absorption is enhanced, both EUV emissions and the strength of magnetic field are remarkably stronger. 4) The peaks on the time profile of the EUV emissions are found to be in sync with oscillatory peaks of the stronger magnetic field in the region. These findings may give a series of strong evidences supporting the scenario that coronal heating is powered by magneto-acoustic waves.
The properties expected of hot non-flaring plasmas due to nanoflare heating in active regions are investigated using hydrodynamic modeling tools, including a two-fluid development of the EBTEL code. Here we study a single nanoflare and show that whil
e simple models predict an emission measure distribution extending well above 10 MK that is consistent with cooling by thermal conduction, many other effects are likely to limit the existence and detectability of such plasmas. These include: differential heating between electrons and ions, ionization non-equilibrium and, for short nanoflares, the time taken for the coronal density to increase. The most useful temperature range to look for this plasma, often called the smoking gun of nanoflare heating, lies between $10^{6.6}$ and $10^7$ K. Signatures of the actual heating may be detectable in some instances.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
