اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدAdaptive-Gain Second Order Sliding Mode Observer Design for Switching Power Converters
174
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
In this paper, a novel adaptive-gain Second Order Sliding Mode (SOSM) observer is proposed for multicell converters by considering it as a class of hybrid systems. The aim is to reduce the number of voltage sensors by estimating the capacitor voltages only from the measurement of load current. The proposed observer is proven to be robust in the presence of perturbations with emph{unknown} boundary. However, the states of the system are only partially observable in the sense of observability rank condition. Due to its switching behavior, a recent concept of $Z(T_N)$ observability is used to analysis its hybrid observability, since its observability depends upon the switching control signals. Under certain condition of the switching sequences, the voltage across each capacitor becomes observable. Simulation results and comparisons with Luenberger switched observer highlight the effectiveness and robustness of the proposed observer with respect to output measurement noise and system uncertainties (load variations).
قيم البحث
اقرأ أيضاً
In this note we deal with a new observer for nonlinear systems of dimension n in canonical observability form. We follow the standard high-gain paradigm, but instead of having an observer of dimension n with a gain that grows up to power n, we design
an observer of dimension 2n-2 with a gain that grows up only to power 2.
We apply a novel data-enabled predictive control (DeePC) algorithm in grid-connected power converters to perform safe and optimal control. Rather than a model, the DeePC algorithm solely needs input/output data measured from the unknown system to pre
dict future trajectories. We show that the DeePC can eliminate undesired oscillations in a grid-connected power converter and stabilize an unstable system. However, the DeePC algorithm may suffer from poor scalability when applied in high-order systems. To this end, we present a finite-horizon output-based model predictive control (MPC) for grid-connected power converters, which uses an N-step auto-regressive-moving-average (ARMA) model for system representation. The ARMA model is identified via an N-step prediction error method (PEM) in a recursive way. We investigate the connection between the DeePC and the concatenated PEM-MPC method, and then analytically and numerically compare their closed-loop performance. Moreover, the PEM-MPC is applied in a voltage source converter based HVDC station which is connected to a two-area power system so as to eliminate low-frequency oscillations. All of our results are illustrated with high-fidelity, nonlinear, and noisy simulations.
This paper focuses on observer based fault reconstruction for a class of nonlinear uncertain systems with Lipschitz nonlinearities. An adaptive-gain Super-Twisting (STW) observer is developed for observing the system states, where the adaptive law co
mpensates the uncertainty in parameters. The inherent equivalent output error injection feature of STW algorithm is then used to reconstruct the fault signal. The performance of the proposed observer is validated through a Hardware-In-Loop (HIL) simulator which consists of a commercial twin screw compressor and a real time Polymer Electrolyte Membrane fuel cell emulation system. The simulation results illustrate the feasibility and effectiveness of the proposed approach for application to fuel cell systems.
In this paper, a full-bridge boost power converter topology is studied for power factor control, using output high order sliding mode control. The AC/DC converters are used for charging the battery and super-capacitor in hybrid electric vehicles from
the utility. The proposed control forces the input currents to track the desired values, which can controls the output voltage while keeping the power factor close to one. Super-twisting sliding mode observer is employed to estimate the input currents and load resistance only from the measurement of output voltage. Lyapunov analysis shows the asymptotic convergence of the closed loop system to zero. Simulation results show the effectiveness and robustness of the proposed controller.
The grid-forming converter is an important unit in the future power system with more inverter-interfaced generators. However, improving its performance is still a key challenge. This paper proposes a generalized architecture of the grid-forming conve
rter from the view of multivariable feedback control. As a result, many of the existing popular control strategies, i.e., droop control, power synchronization control, virtual synchronous generator control, matching control, dispatchable virtual oscillator control, and their improved forms are unified into a multivariable feedback control transfer matrix working on several linear and nonlinear error signals. Meanwhile, unlike the traditional assumptions of decoupling between AC and DC control, active power and reactive power control, the proposed configuration simultaneously takes all of them into consideration, which therefore can provide better performance. As an example, a new multi-input-multi-output-based grid-forming (MIMO-GFM) control is proposed based on the generalized configuration. To cope with the multivariable feedback, an optimal and structured $H_{infty}$ synthesis is used to design the control parameters. At last, simulation and experimental results show superior performance and robustness of the proposed configuration and control.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
