اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدThree Schemes for Wireless Coded Broadcast to Heterogeneous Users
196
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We study and compare three coded schemes for single-server wireless broadcast of multiple description coded content to heterogeneous users. The users (sink nodes) demand different number of descriptions over links with different packet loss rates. The three coded schemes are based on the LT codes, growth codes, and randomized chunked codes. The schemes are compared on the basis of the total number of transmissions required to deliver the demands of all users, which we refer to as the server (source) delivery time. We design the degree distributions of LT codes by solving suitably defined linear optimization problems, and numerically characterize the achievable delivery time for different coding schemes. We find that including a systematic phase (uncoded transmission) is significantly beneficial for scenarios with low demands, and that coding is necessary for efficiently delivering high demands. Different demand and error rate scenarios may require very different coding schemes. Growth codes and chunked codes do not perform as well as optimized LT codes in the heterogeneous communication scenario.
قيم البحث
اقرأ أيضاً
We consider the problem of efficient packet dissemination in wireless networks with point-to-multi-point wireless broadcast channels. We propose a dynamic policy, which achieves the broadcast capacity of the network. This policy is obtained by first
transforming the original multi-hop network into a precedence-relaxed virtual single-hop network and then finding an optimal broadcast policy for the relaxed network. The resulting policy is shown to be throughput-optimal for the original wireless network using a sample-path argument. We also prove the NP-completeness of the finite-horizon broadcast problem, which is in contrast with the polynomial time solvability of the problem with point-to-point channels. Illustrative simulation results demonstrate the efficacy of the proposed broadcast policy in achieving the full broadcast capacity with low delay.
Traffic load balancing and radio resource management is key to harness the dense and increasingly heterogeneous deployment of next generation $5$G wireless infrastructure. Strategies for aggregating user traffic from across multiple radio access tech
nologies (RATs) and/or access points (APs) would be crucial in such heterogeneous networks (HetNets), but are not well investigated. In this paper, we develop a low complexity solution for maximizing an $alpha$-optimal network utility leveraging the multi-link aggregation (simultaneous connectivity to multiple RATs/APs) capability of users in the network. The network utility maximization formulation has maximization of sum rate ($alpha=0$), maximization of minimum rate ($alpha to infty$), and proportional fair ($alpha=1$) as its special cases. A closed form is also developed for the special case where a user aggregates traffic from at most two APs/RATs, and hence can be applied to practical scenarios like LTE-WLAN aggregation (LWA) and LTE dual-connectivity solutions. It is shown that the required objective may also be realized through a decentralized implementation requiring a series of message exchanges between the users and network. Using comprehensive system level simulations, it is shown that optimal leveraging of multi-link aggregation leads to substantial throughput gains over single RAT/AP selection techniques.
Traffic load balancing and resource allocation is set to play a crucial role in leveraging the dense and increasingly heterogeneous deployment of multi-radio wireless networks. Traffic aggregation across different access points (APs)/radio access tec
hnologies (RATs) has become an important feature of recently introduced cellular standards on LTE dual connectivity and LTE-WLAN aggregation (LWA). Low complexity traffic splitting solutions for scenarios where the APs are not necessarily collocated are of great interest for operators. In this paper, we consider a scenario, where traffic for each user may be split across macrocell and an LTE or WiFi small cells connected by non-ideal backhaul links, and develop a closed form solution for optimal aggregation accounting for the backhaul delay. The optimal solution lends itself to a water-filling based interpretation, where the fraction of users traffic sent over macrocell is proportional to ratio of users peak capacity on that macrocell and its throughput on the small cell. Using comprehensive system level simulations, the developed optimal solution is shown to provide substantial edge and median throughput gain over algorithms representative of current 3GPP-WLAN interworking solutions. The achievable performance benefits hold promise for operators expecting to introduce aggregation solutions with their existing WLAN deployments.
This paper proposes and experimentally demonstrates a first wireless local area network (WLAN) system that jointly exploits physical-layer network coding (PNC) and multiuser decoding (MUD) to boost system throughput. We refer to this multiple access
mode as Network-Coded Multiple Access (NCMA). Prior studies on PNC mostly focused on relay networks. NCMA is the first realized multiple access scheme that establishes the usefulness of PNC in a non-relay setting. NCMA allows multiple nodes to transmit simultaneously to the access point (AP) to boost throughput. In the non-relay setting, when two nodes A and B transmit to the AP simultaneously, the AP aims to obtain both packet A and packet B rather than their network-coded packet. An interesting question is whether network coding, specifically PNC which extracts packet (A XOR B), can still be useful in such a setting. We provide an affirmative answer to this question with a novel two-layer decoding approach amenable to real-time implementation. Our USRP prototype indicates that NCMA can boost throughput by 100% in the medium-high SNR regime (>=10dB). We believe further throughput enhancement is possible by allowing more than two users to transmit together.
For future networks (i.e., the fifth generation (5G) wireless networks and beyond), millimeter-wave (mmWave) communication with large available unlicensed spectrum is a promising technology that enables gigabit multimedia applications. Thanks to the
short wavelength of mmWave radio, massive antenna arrays can be packed into the limited dimensions of mmWave transceivers. Therefore, with directional beamforming (BF), both mmWave transmitters (MTXs) and mmWave receivers (MRXs) are capable of supporting multiple beams in 5G networks. However, for the transmission between an MTX and an MRX, most works have only considered a single beam, which means that they do not make full potential use of mmWave. Furthermore, the connectivity of single beam transmission can easily be blocked. In this context, we propose a single-user multi-beam concurrent transmission scheme for future mmWave networks with multiple reflected paths. Based on spatial spectrum reuse, the scheme can be described as a multiple-input multiple-output (MIMO) technique in beamspace (i.e., in the beam-number domain). Moreover, this study investigates the challenges and potential solutions for implementing this scheme, including multibeam selection, cooperative beam tracking, multi-beam power allocation and synchronization. The theoretical and numerical results show that the proposed beamspace SU-MIMO can largely improve the achievable rate of the transmission between an MTX and an MRX and, meanwhile, can maintain the connectivity.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
