اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدNew limit of pion form factor at very large $Q^2$
143
0
0.0
(
0
)
تأليف
Bing An Li
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
A new limit of pion form factor at very large $Q^2$ is obtained by using a pion wave function determined from an effective chiral field theory of mesons. It shows that when $Q^2>>(1.8GeV)^2$ the pion form factor reaches the asymptotic limit ${alpha_s(Q^2)over Q^2}$.
قيم البحث
اقرأ أيضاً
The update of the e^+e^-topi^+pi^- process cross section, measured in the energy region sqrt{s}<1 GeV with SND detector at VEPP-2M collider is presented.
The electromagnetic form factor of the pion in the space-like region, and at finite temperature, $F_{pi}(Q^{2},T)$, is obtained from a QCD Finite Energy Sum Rule. The form factor decreases with increasing T, and vanishes at some critical temperature,
where the pion radius diverges. This divergence may be interpreted as a signal for quark deconfinement.
The pion electromagnetic form factor and two-pion production in electron-positron collisions are simultaneously fitted by a vector dominance model evolving to perturbative QCD at large momentum transfer. This model was previously successful in simult
aneously fitting the nucleon electromagnetic form factors (spacelike region) and the electromagnetic production of nucleon-antinucleon pairs (timelike region). For this pion case dispersion relations are used to produce the analytic connection of the spacelike and timelike regions. The fit to all the data is good, especially for the newer sets of time-like data. The description of high-$q^2$ data, in the time-like region, requires one more meson with $rho$ quantum numbers than listed in the 2014 Particle Data Group review.
The charged pion form factor, Fpi(Q^2), is an important quantity which can be used to advance our knowledge of hadronic structure. However, the extraction of Fpi from data requires a model of the 1H(e,epi+)n reaction, and thus is inherently model dep
endent. Therefore, a detailed description of the extraction of the charged pion form factor from electroproduction data obtained recently at Jefferson Lab is presented, with particular focus given to the dominant uncertainties in this procedure. Results for Fpi are presented for Q^2=0.60-2.45 GeV^2. Above Q^2=1.5 GeV^2, the Fpi values are systematically below the monopole parameterization that describes the low Q^2 data used to determine the pion charge radius. The pion form factor can be calculated in a wide variety of theoretical approaches, and the experimental results are compared to a number of calculations. This comparison is helpful in understanding the role of soft versus hard contributions to hadronic structure in the intermediate Q^2 regime.
The data analysis for the reaction H(e,e pi^+)n, which was used to determine values for the charged pion form factor Fpi for values of Q^2=0.6-1.6 GeV^2, has been repeated with careful inspection of all steps and special attention to systematic uncer
tainties. Also the method used to extract Fpi from the measured longitudinal cross section was critically reconsidered. Final values for the separated longitudinal and transverse cross sections and the extracted values of Fpi are presented.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
