اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدEpitaxial thin films of the multiferroic double perovskite Bi2FeCrO6 grown on (100)-oriented SrTiO3 substrates: Growth, characterization, and optimization
135
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
The influence of the deposition pressure PO2 and substrate temperature TS during the growth of Bi2FeCrO6 thin films grown by pulsed laser deposition has been investigated. It is found that the high volatility of Bi makes the deposition very difficult and that the growth of pure Bi2FeCrO6 thin films on SrTiO3 substrates is possible only in a narrow deposition parameter window. We find that the pure Bi2FeCrO6 phase is formed within a narrow window around an oxygen pressure PO2 =1.210-2 mbar and around a substrate temperature TS=680 degC. At lower temperature or higher pressure, Bi7.38Cr0.62O12+x_also called (b*Bi2O3)and Bi2Fe4O9 /Bi2(Fe,Cr)4O9+x phases are detected, while at lower pressure or higher temperature a (Fe,Cr)3O4 phase forms. Some of these secondary phases are not well known and have not been previously studied. We previously reported Fe/Cr cation ordering as the probable origin of the tenfold improvement in magnetization at saturation of our Bi2FeCrO6 film, compared to BiFeO3. Here, we address the effect of the degree of cationic ordering on the magnetic properties of the Bi2FeCrO6 single phase. Polarization measurements at room temperature reveal that our Bi2FeCrO6 films have excellent ferroelectric properties with ferroelectric hysteresis loops exhibiting a remanent polarization as high as 55-60 miroC/cm2 along the pseudocubic (001) direction.
قيم البحث
اقرأ أيضاً
We report the structural and physical properties of epitaxial Bi2FeCrO6 thin films on epitaxial SrRuO3 grown on (100)-oriented SrTiO3 substrates by pulsed laser ablation. The 300 nm thick films exhibit both ferroelectricity and magnetism at room temp
erature with a maximum dielectric polarization of 2.8 microC/cm2 at Emax = 82 kV/cm and a saturated magnetization of 20 emu/cc (corresponding to ~ 0.26 Bohr magneton per rhombohedral unit cell), with coercive fields below 100 Oe. Our results confirm the predictions made using ab-initio calculations about the existence of multiferroic properties in Bi2FeCrO6.
TbMnO$_{3}$ films have been grown under compressive strain on (001)-oriented SrTiO$_{3}$ crystals. They have an orthorhombic structure and display the (001) orientation. With increasing thickness, the structure evolves from a more symmetric (tetragon
al) to a less symmetric (bulk-like orthorhombic) structure, while keeping constant the in-plane compression thereby leaving the out-of-plane lattice spacing unchanged. The domain microstructure of the films is also revealed, showing an increasing number of orthorhombic domains as the thickness is decreased: we directly observe ferroelastic domains as narrow as 4nm. The high density of domain walls may explain the induced ferromagnetism observed in the films, while both the decreased anisotropy and the small size of the domains could account for the absence of a ferroelectric spin spiral phase.
Magnetite thin fims have been grown epitaxially on ZnO and MgO substrates using molecular beam epitaxy. The film quality was found to be strongly dependent on the oxygen partial pressure during growth. Structural, electronic, and magnetic properties
were analyzed utilizing Low Energy Electron Diffraction (LEED), HArd X-ray PhotoElectron Spectroscopy (HAXPES), Magneto Optical Kerr Effect (MOKE), and X-ray Magnetic Circular Dichroism (XMCD). Diffraction patterns show clear indication for growth in the (111) direction on ZnO. Vertical structure analysis by HAXPES depth profiling revealed uniform magnetite thin films on both type of substrates. Both, MOKE and XMCD measurements show in-plane easy magnetization with a reduced magnetic moment in case of the films on ZnO.
We have grown epitaxial thin films of multiferroic BiMnO$_3$ using pulsed laser deposition. The films were grown on SrTiO$_3$ (001) substrates by ablating a Bi-rich target. Using x-ray diffraction we confirmed that the films were epitaxial and the st
oichiometry of the films was confirmed using Auger electron spectroscopy. The films have a ferromagnetic Curie temperature ($T_C$) of 85$pm$5 K and a saturation magnetization of 1 $mu_B$/Mn. The electric polarization as a function of electric field ($P-E$) was measured using an interdigital capacitance geometry. The $P-E$ plot shows a clear hysteresis that confirms the multiferroic nature of the thin films.
The growth and characterization of epitaxial Co3O4(111) films grown by oxygen plasma-assisted molecular beam epitaxy on single crystalline a-Al2O3(0001) is reported. The Co3O4(111) grows single crystalline with the epitaxial relation Co3O4(111)[-12-1
]||a-Al2O3(0001)[10-10], as determined from in situ electron diffraction. Film stoichiometry is confirmed by x-ray photoelectron spectroscopy, while ex situ x-ray diffraction measurements show that the Co3O4 films are fully relaxed. Post-growth annealing induces significant modifications in the film morphology, including a sharper Co3O4/a-Al2O3 interface and improved surface crystallinity, as shown by x-ray reflectometry, atomic force microscopy and electron diffraction measurements. Despite being polar, the surface of both as-grown and annealed Co3O4(111) films are (1 * 1), which can be explained in terms of inversion in the surface spinel structure.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
