اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدUnderstanding the nature of electronic effective mass in double-doped SrTiO$_{3}$
167
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We present an approach to tune the effective mass in an oxide semiconductor by a double doping mechanism. We demonstrate this in a model oxide system Sr$_{1-x}$La$_x$TiO$_{3-delta}$, where we can tune the effective mass ranging from 6--20$mathrm{m_e}$ as a function of filling or carrier concentration and the scattering mechanism, which are dependent on the chosen lanthanum and oxygen vacancy concentrations. The effective mass values were calculated from the Boltzmann transport equation using the measured transport properties of thin films of Sr$_{1-x}$La$_x$TiO$_{3-delta}$. Our method, which shows that the effective mass decreases with carrier concentration, provides a means for understanding the nature of transport processes in oxides, which typically have large effective mass and low electron mobility, contrary to the tradional high mobility semiconductors.
قيم البحث
اقرأ أيضاً
A magnetic field parallel to an electrical current does not produce a Lorentz force on the charge carriers. Therefore, orbital longitudinal magnetoresistance is unexpected. Here we report on the observation of a large and non saturating magnetoresist
ance in lightly doped SrTiO$_{3-x}$ independent of the relative orientation of current and magnetic field. We show that this quasi-isotropic magnetoresistance can be explained if the carrier mobility along all orientations smoothly decreases with magnetic field. This anomalous regime is restricted to low concentrations when the dipolar correlation length is longer than the distance between carriers. We identify cyclotron motion of electrons in a potential landscape tailored by polar domains as the cradle of quasi-isotropic orbital magnetoresistance. The result emerges as a challenge to theory and may be a generic feature of lightly-doped quantum paralectric materials.
SrTiO$_3$ is a promising $n$-type oxide semiconductor for thermoelectric energy conversion. Epitaxial thin films of SrTiO$_3$ doped with both La and oxygen vacancies have been synthesized by pulsed laser deposition (PLD). The thermoelectric and galva
nomagnetic properties of these films have been characterized at temperatures ranging from 300 K to 900 K and are typical of a doped semiconductor. Thermopower values of double-doped films are comparable to previous studies of La doped single crystals at similar carrier concentrations. The highest thermoelectric figure of merit ($ZT$) was measured to be 0.28 at 873 K at a carrier concentration of $2.5times10^{21}$ cm$^{-3}$.
Band gap engineering in SrTiO${}_{3}$ and related titanate perovskites has long been explored due to the intriguing properties of the materials for photocatalysis and photovoltaic applications. A popular approach in the materials chemistry community
is to substitutionally dope aliovalent transition metal ions onto the B site in the lattice to alter the valence band. However, in such a scheme there is limited control over the dopant valence, and compensating defects often form. Here we demonstrate a novel technique to controllably synthesize Fe$^{2+}$- and Fe$^{3+}$-doped SrTiO${}_{3}$ thin films without formation of compensating defects by co-doping with La$^{3+}$ ions on the A site. We stabilize Fe$^{2+}$-doped films by doping with two La ions for every Fe dopant, and find that the Fe ions exhibit a low-spin electronic configuration, producing optical transitions in the near infrared regime and degenerate doping. The novel electronic states observed here offer a new avenue for band gap engineering in perovskites for photocatalytic and photovoltaic applications.
We combined photoelemission spectroscopy with first-principle calculations to investigate structural and electronic properties of SrTiO$_{3}$ doped with Ni impurities. In SrTiO$_{3}$ polycrystalline thin films, grown by magnetron sputtering, the mean
size of the crystallites increases with the concentration of Ni. To determine the electronic band structure of SrTiO$_{3}$ films doped with Ni, high quality ordered pristine and SrTiO3:Ni$_{x}$ films with x=0.06 and 0.12 were prepared by pulsed laser deposition. Electronic band structure calculations for the ground state, as well as one-step model photoemission calculations, which were obtained by means of the Korringa-Khon-Rostoker Greenss function method, predicted the formation of localised $3d$-impurity bands in the band gap of SrTiO$_{3}$ close to the valence band maxima. The measured valence bands at the resonance Ni2p excitation and band dispersion confirm these findings.
We report the effect of $delta$-doping at LaAlO$_{3}$/SrTiO$_{3}$ interface with LaMnO$_{3}$ monolayers on the photoconducting (PC) state. The PC is realized by exposing the samples to broad band optical radiation of a quartz lamp and 325 and 441 nm
lines of a He-Cd laser. Along with the significant modification in electrical transport which drives the pure LaAlO$_{3}$/SrTiO$_{3}$ interface from metal-to-insulator with increasing LaMnO$_{3}$ sub-monolayer thickness, we also observe an enhancement in the photo-response and relaxation time constant. Possible scenario for the PC based on defect-clusters, random potential fluctuations and large lattice relaxation models have been discussed. For pure LaAlO$_{3}$/SrTiO$_{3}$, the photoconductivity appears to originate from inter-band transitions between Ti-derived $3d$ bands which are $e_{g}$ in character and O 2p - Ti $t_{2g}$ hybridized bands. The band structure changes significantly when fractional layers of LaMnO$_{3}$ are introduced. Here the Mn $e_{g}$ bands ($approx1.5$ eV above the Fermi energy) within the photo-conducting gap lead to a reduction in the photo-excitation energy and a gain in overall photoconductivity.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
