اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدA microscopic description of light induced defects in amorphous silicon solar cells
180
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Using a combination of quantum and classical computational approaches, we model the electronic structure in amorphous silicon in order gain understanding of the microscopic atomic configurations responsible for light induced degradation of solar cells. We demonstrate that regions of strained silicon bonds could be as important as dangling bonds for creating traps for charge carriers. Further, our results show that defects are preferentially formed when a region in the amorphous silicon contains a hole and a light-induced excitation. These results agree with the puzzling dependencies on temperature, time, and pressure observed experimentally.
قيم البحث
اقرأ أيضاً
We report on very high enhancement of thin layers absorption through band-engineering of a photonic crystal structure. We realized amorphous silicon (aSi) photonic crystals, where slow light modes improve absorption efficiency. We show through simula
tion that an increase of the absorption by a factor of 1.5 is expected for a film of aSi. The proposal is then validated by an experimental demonstration, showing an important increase of the absorption of a layer of aSi over a spectral range of 0.32-0.76 microns.
The low energy structures of irradiation-induced defects have been studied in detail, as these determine the available modes by which a defect can diffuse or relax. As a result, there are many studies concerning the relative energies of possible defe
ct structures, and empirical potentials are commonly fitted to or evaluated with respect to these energies. But recently [Dudarev et al Nuclear Fusion 2018], we have shown how to determine the stresses, strains and swelling of reactor components under irradiation from the elastic properties of ensembles of irradiation-induced defects. These elastic properties have received comparatively little attention. Here we evaluate relaxation volumes of irradiation-induced defects in tungsten computed with empirical potentials, and compare to density functional theory results where available. Different empirical potentials give different results, but some potential-independent trends in relaxation volumes can be identified. We show that the relaxation volume of small defects can be predicted to within 10% from their point-defect count. For larger defects we provide empirical fits for the relaxation volume of as a function of size. We demonstrate that the relaxation volume associated with a single primary-damage cascade can be estimated from the primary knock-on atom (PKA) energy. We conclude that while annihilation of vacancy- and interstitial- character defects will invariably reduce the total relaxation volume of the cascade debris, empirical potentials disagree whether coalescence of defects will reduce or increase the total relaxation volume.
Historically, the design of hybrid solar photovoltaic thermal (PVT) systems has focused on cooling crystalline silicon (c-Si)-based photovoltaic (PV) devices to avoid temperature-related losses. This approach neglects the associated performance losse
s in the thermal system and leads to a decrease in the overall exergy of the system. Consequently, this paper explores the use of hydrogenated amorphous silicon (a-Si:H) as an absorber material for PVT in an effort to maintain higher and more favourable operating temperatures for the thermal system. Amorphous silicon not only has a smaller temperature coefficient than c-Si, but also can display improved PV performance over extended periods of higher temperatures by annealing out defect states from the Staebler-Wronski effect. In order to determine the potential improvements in a-Si:H PV performance associated with increased thicknesses of the i-layers made possible by higher operating temperatures, a-Si:H PV cells were tested under 1 sun illumination (AM1.5) at temperatures of 25oC (STC), 50oC (representative PV operating conditions), and 90 oC (representative PVT operating conditions). PV cells with an i-layer thicknesses of 420, 630 and 840 nm were evaluated at each temperature. Results show that operating a-Si:H-based PV at 90 oC, with thicker i-layers than the cells currently used in commercial production, provided a greater power output compared to the thinner cells operating at either PV or PVT operating temperatures. These results indicate that incorporating a-Si:H as the absorber material in a PVT system can improve the thermal performance, while simultaneously improving the electrical performance of a-Si:H-based PV.
Here we describe a new high frequency/high field continuous wave and pulsed electrically detected magnetic resonance (CW EDMR and pEDMR) setup, operating at 263 GHz and resonance fields between 0 and 12 T. Spin dependent transport in illuminated hydr
ogenated amorphous silicon p-i-n solar cells at 5 K and 90 K was studied by in operando 263 GHz CW and pEDMR alongside with complementary X-band CW EDMR. Benefiting from the superior resolution at 263 GHz, we were able to better resolve EDMR signals originating from spin dependent hopping and recombination processes. 5 K EDMR spectra were found to be dominated by conduction and valence band tale states involved in spin dependent hopping, with additional contributions from triplet exciton states. 90 K EDMR spectra could be assigned to spin pair recombination involving conduction band tail states and dangling bonds as dominating spin dependent transport process, with additional contributions from valence band tail and triplet exciton states.
Specific heat measurements from 2 to 300 K of hydrogenated amorphous silicon prepared by hot-wire chemical vapor deposition show a large excess specific heat at low temperature, significantly larger than the Debye specific heat calculated from the so
und velocity. The as-prepared films have a Schottky anomaly that is associated with metastable hydrogen in the amorphous network, as well as large linear and excess cubic term commonly associated with tunneling two-level systems in amorphous solids. Annealing at 200 {deg}C, a temperature that enables hydrogen mobility but not evaporation, irreversibly reduces the heat capacity, eliminating the Schottky anomaly and leaving a reduced linear heat capacity. A non-monotonic dependence on growth temperature and H content is observed in all effects, except for sound velocity, which suggests that the tunneling two-level systems and the Schottky anomaly are associated with atomic hydrogen and require low density regions to form, while sound velocity is associated with the silicon network and improves with increasing growth temperature.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
