اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدValence and spin states in perovskites LaCo0.95M0.05O3 (M = Mg, Ga, Ti)
369
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
The samples LaCoO3 with dilute substitutions on cobalt sites have been studied using the resistivity, thermopower and magnetic susceptibility measurements over the temperature range up to ~900 K. The Co-site substitution does not affect the magnetic transition at ~100 K and the onset of massive population of hole carriers at ~500 K, characteristic for undoped LaCoO3. On the other hand, the low-temperature transport and magnetism is markedly distinct for samples with extra charge on cobalt ions introduced by the heterovalent dopants (Mg2+, Ti4+) compared to samples with minor non-stoichiometry (LaCoO3, Ga3+ doped sample). Magnetic properties suggest that these extra charges create thermally stable magnetic polarons of total S ~ 2-3. Common features of Co-site doped and La-site doped samples (La1-xSrxCoO3) are discussed
قيم البحث
اقرأ أيضاً
The quasiparticle band structures of nonmagnetic monoxides, MO (M=Mg, Ca, Ti, and V), are calculated by the GW approximation. The band gap and the width of occupied oxygen 2p states in insulating MgO and CaO agree with experimental observation. In me
tallic TiO and VO, conduction bands originated from metal 3d states become narrower. Then the partial densities of transition metal e_g and t_2g states show an enhanced dip between the two. The effects of static screening and dynamical correlation are discussed in detail in comparison with the results of the Hartree-Fock approximation and the static Coulomb hole plus screened exchange approximation. The d-d Coulomb interaction is shown to be very much reduced by on-site and off-site d-electron screening in TiO and VO. The dielectric function and the energy loss spectrum are also presented and discussed in detail.
Mg-Ti alloys have uncommon optical and hydrogen absorbing properties, originating from a spinodal-like microstructure with a small degree of chemical short-range order in the atoms distribution. In the present study we artificially engineer short-ran
ge order by depositing Pd-capped Mg/Ti multilayers with different periodicities and characterize them both structurally and optically. Notwithstanding the large lattice parameter mismatch between Mg and Ti, the as-deposited metallic multilayers show good structural coherence. Upon exposure to H2 gas a two-step hydrogenation process occurs, with the Ti layers forming the hydride before Mg. From in-situ measurements of the bilayer thickness L at different hydrogen pressures, we observe large out-of-plane expansions of the Mg and Ti layers upon hydrogenation, indicating strong plastic deformations in the films and a consequent shortening of the coherence length. Upon unloading at room temperature in air, hydrogen atoms remain trapped in the Ti layers due to kinetic constraints. Such loading/unloading sequence can be explained in terms of the different thermodynamic properties of hydrogen in Mg and Ti, as shown by diffusion calculations on a model multilayered systems. Absorption isotherms measured by hydrogenography can be interpreted as a result of the elastic clamping arising from strongly bonded Mg/Pd and broken Mg/Ti interfaces.
After more than a century of studies on the optical properties of Bi3+ ions, the assignment of the nature of the emissions and the bands of the absorption spectra remain ambiguous. Here, we report an insight into the spectroscopy of Bi3+-activated Ca
MO3 perovskites (M = Zr, Sn, and Ti), discussing the factors driving the metal-to-metal charge transfer and sp -> s2 transitions. With the aim to figure out the whole scenario, a combined experimental and theoretical approach is employed. The comparison between the temperature dependence of the photoluminescence emissions with the temperature dependence of the exciton energy of the systems has led to an unprecedented evidence of the chargetransfer character of the emitting states in Bi3+-activated phosphors. Low-temperature vacuum ultraviolet spectroscopy together with the design of the vacuum-referred binding energy diagram of the luminescent center is exploited to shed light on the origin of the absorption bands. In addition, the X-ray absorption near the edge structure unambiguously confirmed the stabilization of Bi3+ in the Ca2+ site in both CaSnO3 and CaZrO3 perovskites. This breakthrough into the understanding of the excited-state origin of Bi3+ could pave the way toward the design of a new generation of effective Bi3+-activated phosphors.
Combining crystal structure search and first-principles calculations, we report a series of two-dimensional (2D) metal borides including orthorhombic (ort-) MB6 (M=Mg, Ca) and hexagonal (hex-) MB6 (M=Mg, Ca, Sc, Ti, Sr, Y). Then, we investigate their
geometrical structures, bonding properties, electronic structures, mechanical properties, phonon dispersions, thermal stability, dynamic stability, electron-phonon coupling (EPC), superconducting properties and so on. Our ab initio molecular dynamics simulation results show that these MB6 can maintain their original configurations up to 700/1000 K, indicating their excellent thermal stability. All their elastic constants satisfy the Born mechanically stable criteria and no visible imaginary frequencies are observed in their phonon dispersions. The EPC results show that these 2D MB6 are all intrinsic phonon-mediated superconductors with the superconducting transition temperature (Tc??) in the range of 2.2-21.3 K. Among them, the highest Tc (21.3 K) appears in hex-CaB6, whose EPC constant () is 0.94. By applying tensile/compressive strains on ort-/hex-CaB6, we find that the compressive strain can obviously soften the acoustic phonon branch and enhance the EPC as well as Tc. The Tc of the hex-CaB6 can be increased from 21.3 K to 28 K under compressive strain of 3%. These findings enrich the database of 2D superconductors and should stimulate experimental synthesizing and characterizing of 2D superconducting metal borides.
It is well known, both theoretically and experimentally, that alloying MgH$_2$ with transition elements can significantly improve the thermodynamic and kinetic properties for H$_2$ desorption, as well as the H$_2$ intake by Mg bulk. Here we present a
density functional theory investigation of hydrogen dissociation and surface diffusion over Ni-doped surface, and compare the findings to previously investigated Ti-doped Mg(0001) and pure Mg(0001) surfaces. Our results show that the energy barrier for hydrogen dissociation on the pure Mg(0001) surface is high, while it is small/null when Ni/Ti are added to the surface as dopants. We find that the binding energy of the two H atoms near the dissociation site is high on Ti, effectively impeding diffusion away from the Ti site. By contrast, we find that on Ni the energy barrier for diffusion is much reduced. Therefore, although both Ti and Ni promote H$_2$ dissociation, only Ni appears to be a good catalyst for Mg hydrogenation, allowing diffusion away from the catalytic sites. Experimental results corroborate these theoretical findings, i.e. faster hydrogenation of the Ni doped Mg sample as opposed to the reference Mg or Ti doped Mg.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
