اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدHydrogen Dissociation and Diffusion on Ni and Ti -doped Mg(0001) Surfaces
236
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
It is well known, both theoretically and experimentally, that alloying MgH$_2$ with transition elements can significantly improve the thermodynamic and kinetic properties for H$_2$ desorption, as well as the H$_2$ intake by Mg bulk. Here we present a density functional theory investigation of hydrogen dissociation and surface diffusion over Ni-doped surface, and compare the findings to previously investigated Ti-doped Mg(0001) and pure Mg(0001) surfaces. Our results show that the energy barrier for hydrogen dissociation on the pure Mg(0001) surface is high, while it is small/null when Ni/Ti are added to the surface as dopants. We find that the binding energy of the two H atoms near the dissociation site is high on Ti, effectively impeding diffusion away from the Ti site. By contrast, we find that on Ni the energy barrier for diffusion is much reduced. Therefore, although both Ti and Ni promote H$_2$ dissociation, only Ni appears to be a good catalyst for Mg hydrogenation, allowing diffusion away from the catalytic sites. Experimental results corroborate these theoretical findings, i.e. faster hydrogenation of the Ni doped Mg sample as opposed to the reference Mg or Ti doped Mg.
قيم البحث
اقرأ أيضاً
The kinetics of hydrogen absorption by magnesium bulk is affected by two main activated processes: the dissociation of the H$_2$ molecule and the diffusion of atomic H into the bulk. In order to have fast absorption kinetics both activated processed
need to have a low barrier. Here we report a systematic ab-initio density functional theory investigation of H$_2$ dissociation and subsequent atomic H diffusion on TM(=Ti,V,Zr,Fe,Ru,Co,Rh,Ni,Pd,Cu,Ag)-doped Mg(0001) surfaces. The calculations show that doping the surface with TMs on the left of the periodic table eliminates the barrier for the dissociation of the molecule, but the H atoms bind very strongly to the TM, therefore hindering diffusion. Conversely, TMs on the right of the periodic table dont bind H, however, they do not reduce the barrier to dissociate H$_2$ significantly. Our results show that Fe, Ni and Rh, and to some extent Co and Pd, are all exceptions, combining low activation barriers for both processes, with Ni being the best possible choice.
We have used diffusion Monte Carlo (DMC) simulations to calculate the energy barrier for H$_2$ dissociation on the Mg(0001) surface. The calculations employ pseudopotentials and systematically improvable B-spline basis sets to expand the single parti
cle orbitals used to construct the trial wavefunctions. Extensive tests on system size, time step, and other sources of errors, performed on periodically repeated systems of up to 550 atoms, show that all these errors together can be reduced to $sim 0.03$ eV. The DMC dissociation barrier is calculated to be $1.18 pm 0.03$ eV, and is compared to those obtained with density functional theory using various exchange-correlation functionals, with values ranging between 0.44 and 1.07 eV.
Mg-Ti alloys have uncommon optical and hydrogen absorbing properties, originating from a spinodal-like microstructure with a small degree of chemical short-range order in the atoms distribution. In the present study we artificially engineer short-ran
ge order by depositing Pd-capped Mg/Ti multilayers with different periodicities and characterize them both structurally and optically. Notwithstanding the large lattice parameter mismatch between Mg and Ti, the as-deposited metallic multilayers show good structural coherence. Upon exposure to H2 gas a two-step hydrogenation process occurs, with the Ti layers forming the hydride before Mg. From in-situ measurements of the bilayer thickness L at different hydrogen pressures, we observe large out-of-plane expansions of the Mg and Ti layers upon hydrogenation, indicating strong plastic deformations in the films and a consequent shortening of the coherence length. Upon unloading at room temperature in air, hydrogen atoms remain trapped in the Ti layers due to kinetic constraints. Such loading/unloading sequence can be explained in terms of the different thermodynamic properties of hydrogen in Mg and Ti, as shown by diffusion calculations on a model multilayered systems. Absorption isotherms measured by hydrogenography can be interpreted as a result of the elastic clamping arising from strongly bonded Mg/Pd and broken Mg/Ti interfaces.
We report a first-principles study of the energetics of hydrogen absorption and desorption (i.e. H-vacancy formation) on pure and Ti-doped sodium alanate (NaAlH4) surfaces. We find that the Ti atom facilitates the dissociation of H2 molecules as well
as the adsorption of H atoms. In addition, the dopant makes it energetically more favorable to creat H vacancies by saturating Al dangling bonds. Interestingly, our results show that the Ti dopant brings close in energy all the steps presumably involved in the absorption and desorption of hydrogen, thus facilitating both and enhancing the reaction kinetics of the alanates. We also discuss the possibility of using other light transition metals (Sc, V, and Cr) as dopants.
We have performed first-principles calculations of thick slabs of Ti-doped sodium alanate (NaAlH_4), which allows to study the system energetics as the dopant progresses from the surface to the bulk. Our calculations predict that Ti stays on the surf
ace, substitutes for Na, and attracts a large number of H atoms to its vicinity. Molecular dynamics simulations suggest that the most likely product of the Ti-doping is the formation of H-rich TiAl_n (n>1) compounds on the surface, and hint at the mechanism by which Ti enhances the reaction kinetics of NaAlH_4.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
