اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدPhase stability of hafnium oxide and zirconium oxide on silicon substrate
139
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Phase stabilities of Hf-Si-O and Zr-Si-O have been studied with first-principles and thermodynamic modeling. From the obtained thermodynamic descriptions, phase diagrams pertinent to thin film processing were calculated. We found that the relative stability of the metal silicates with respect to their binary oxides plays a critical role in silicide formation. It was observed that both the HfO$_2$/Si and ZrO$_2$/Si interfaces are stable in a wide temperature range and silicide may form at low temperatures, partially at the HfO$_2$/Si interface.
قيم البحث
اقرأ أيضاً
On highly oxygen deficient thin films of hafnium oxide (hafnia, HfO$_{2-x}$) contaminated with adsorbates of carbon oxides, the formation of hafnium carbide (HfC$_x$) at the surface during vacuum annealing at temperatures as low as 600 {deg}C is repo
rted. Using X-ray photoelectron spectroscopy the evolution of the HfC$_x$ surface layer related to a transformation from insulating into metallic state is monitored in situ. In contrast, for fully stoichiometric HfO$_2$ thin films prepared and measured under identical conditions, the formation of HfC$_x$ was not detectable suggesting that the enhanced adsorption of carbon oxides on oxygen deficient films provides a carbon source for the carbide formation. This shows that a high concentration of oxygen vacancies in carbon contaminated hafnia lowers considerably the formation energy of hafnium carbide. Thus, the presence of a sufficient amount of residual carbon in resistive random access memory devices might lead to a similar carbide formation within the conducting filaments due to Joule heating.
The ferroelectric polarization switching in ferroelectric hafnium zirconium oxide (Hf0.5Zr0.5O2, HZO) in the HZO/Al2O3 ferroelectric/dielectric stack is investigated systematically by capacitance-voltage and polarization-voltage measurements. The thi
ckness of dielectric layer is found to have a determinant impact on the ferroelectric polarization switching of ferroelectric HZO. A suppression of ferroelectricity is observed with thick dielectric layer. In the gate stacks with thin dielectric layers, a full polarization switching of the ferroelectric layer is found possible by the proposed leakage-current-assist mechanism through the ultrathin dielectric layer. Theoretical simulation results agree well with experimental data. This work clarifies some of the critical parts of the long-standing confusions and debating related to negative capacitance field-effect transistors (NC-FETs) concepts and experiments.
We report a correlation between structural phase stability and magnetic properties of Co2FeO4 spinel oxide. We employed mechanical alloying and subsequent annealing to obtain the desired samples. The particle size of the samples changes from 25 nm to
45 nm. The structural phase separation of samples, except sample annealed at 9000C, into Co rich and Fe rich spinel phase has been examined from XRD spectrum, SEM picture, along with EDAX spectrum, and magnetic measurements. The present study indicated the ferrimagnetic character of Co2FeO4, irrespective of structural phase stability. The observation of mixed ferrimagnetic phases, associated with two Curie temperatures at TC1 and TC2 (>TC1), respectively, provides the additional support of the splitting of single cubic spinel phase in Co2FeO4 spinel oxide.
While the recent establishment of the role of thermophoresis/diffusion-driven oxygen migration during resistance switching in metal oxide memristors provided critical insights required for memristor modeling, extended investigations of the role of ox
ygen migration during ageing and failure remain to be detailed. Such detailing will enable failure-tolerant design, which can lead to enhanced performance of memristor-based next-generation storage-class memory. Here we directly observed lateral oxygen migration using in-situ synchrotron x-ray absorption spectromicroscopy of HfOx memristors during initial resistance switching, wear over millions of switching cycles, and eventual failure, through which we determined potential physical causes of failure. Using this information, we reengineered devices to mitigate three failure mechanisms, and demonstrated an improvement in endurance of about three orders of magnitude.
The integration of two-dimensional (2D) materials with functional non-2D materials such as metal oxides is of key importance for many applications, but underlying mechanisms for such non-2D/2D interfacing remain largely elusive at the atomic scale. T
o address this, we here investigate the nucleation stage in atomic layer deposition (ALD) of the important metal oxide HfO2 on chemical vapor deposited graphene using atomically resolved and element specific scanning transmission electron microscopy (STEM). To avoid any deleterious influence of polymer residues from pre-ALD graphene transfers we employ a substrate-assisted ALD process directly on the as grown graphene still remaining on its Cu growth catalyst support. Thereby we resolve at the atomic scale key factors governing the integration of non-2D metal oxides with 2D materials by ALD: Particular to our substrate-assisted ALD process we find a graphene-layer-dependent catalytic participation of the supporting Cu catalyst in the ALD process. We further confirm at high resolution the role of surface irregularities such as steps between graphene layers on oxide nucleation. Employing the energy transfer from the scanning electron beam to in situ crystallize the initially amorphous ALD HfO2 on graphene, we observe HfO2 crystallization to non-equilibrium HfO2 polymorphs (cubic/tetragonal). Finally our data indicates a critical role of the graphenes atmospheric adventitious carbon contamination on the ALD process whereby this contamination acts as an unintentional seeding layer for metal oxide ALD nucleation on graphene under our conditions. As atmospheric adventitious carbon contamination is hard to avoid in any scalable 2D materials processing, this is a critical factor in ALD recipe development for 2D materials coating. Combined our work highlights several key mechanisms underlying scalable ALD oxide growth on 2D materials.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
