اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدStudy and optimization of ion-irradiated High-Tc Josephson nanoJunctions by Monte Carlo simulations
297
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
High Tc Josephson nanoJunctions (HTc JnJ) made by ion irradiation have remarkable properties for technological applications. However, the spread in their electrical characteristics increases with the ion dose. We present a simple model to explain the JnJ inhomogeneities, which accounts quantitatively for experimental data. The spread in the slits width of the irradiation mask is the limiting factor.Monte Carlo simulations have been performed using different irradiation conditions to study their influence on the spread of the JnJ charcateristics. A universal behavior has been evidenced, which allows to propose new strategies to optimize JnJ reproducibility.
قيم البحث
اقرأ أيضاً
Reproducible High Tc Josephson junctions have been made in a rather simple two-step process using ion irradiation. A microbridge 1 to 5 micrometers wide is firstly designed by ion irradiating a c-axis-oriented YBa2Cu3O7 film through a gold mask such
as the unprotected part becomes insulating. A lower Tc part is then defined within the bridge by irradiating with a much lower dose through a 20 nm wide narrow slit opened in a standard electronic photoresist. These planar junctions, whose settings can be finely tuned, exhibit reproducible and nearly ideal Josephson characteristics. Non hysteretic Resistively Shunted Junction (RSJ) like behavior is observed, together with sinc Fraunhofer patterns for rectangular junctions. The IcRn product varies with temperature ; it can reach a few mV. The typical resistance ranges from 0.1 to a few ohms, and the critical current density can be as high as 30 kA/cm2. The dispersion in characteristics is very low, in the 5% to 10% range. Such nanojunctions have been used to make microSQUIDs (Superconducting Quantum Interference Device) operating at Liquid Nitrogen (LN2) temperature. They exhibit a very small asymmetry, a good sensitivity and a rather low noise. The process is easily scalable to make rather complex Josephson circuits.
Reproducible high-Tc Josephson junctions have been made in a rather simple two-step process using ion irradiation. A microbridge (1 to 5 ?m wide) is firstly designed by ion irradiating a c-axis-oriented YBa2Cu3O7-? film through a gold mask such as th
e non-protected part becomes insulating. A lower Tc part is then defined within the bridge by irradiating with a much lower fluence through a narrow slit (20 nm) opened in a standard electronic photoresist. These planar junctions, whose settings can be finely tuned, exhibit reproducible and nearly ideal Josephson characteristics. This process can be used to produce complex Josephson circuits.
We designed, fabricated and tested short one dimensional arrays of masked ion-irradiated YBa$_2$Cu$_3$O$_7$ Josephson junctions (JJ) embedded into log-periodic spiral antennas. Our arrays consist of 4 or 8 junctions separated either by 960~nm or 80~n
m long areas of undamaged YBCO. Samples with distanced junctions and with closely spaced junctions showed qualitatively different behaviors. Well separated arrays demonstrated giant Shapiro steps in the hundreds-GHz band at 66K and were tested as Josephson mixers with improved impedance matching. All closely spaced arrays behaved as one junction with a lower superconducting transition temperature, hence forming a single weak link on distances up to 880~nm. Such design opens a new way to increase the I$_{c}$R$_{N}$ product of ion-irradiated junctions and we speculate that the phenomena and physics behind it might be similar to the so-called giant Josephson coupling observed in cuprates.
We develop a model for high-Tc superconductors based on an electronic phase separation where low-and high-density domains are formed. At low temperatures this system may act as a granular superconductor forming an array of Josephson junctions. Cuprat
es are also known to have low superfluid densities and strong correlation effects. Both characteristics activate a negative Josephson coupling due to frustration that leads to spontaneous currents responsible for the weak ferromagnetic order. This original approach reproduces the observed onset of spontaneous magnetic signal and its dependence on the doping level.
Superconducting Quantum Interference Filters (SQIFs) are arrays of superconducting loops of different sizes including Josephson Junctions (JJ). For a random distribution of sizes, they present a non-periodic response to an applied magnetic field, wit
h an extended linear regime and a sizable field sensitivity. Such properties make SQIFs interesting devices to detect the magnetic component of electromagnetic waves at microwave frequencies. We have used the highly scalable technique of ion irradiation to make High Tc SQUIDs and SQIFs based on commercial YBa2Cu3O7 films, and studied their properties. Both display optimum performances as a function of temperature and bias current, that can be understood in the frame of numerical simulations that we developed. The role of asymmetries and spread in JJ characteristics (routinely found in HTSc technologies) is described : ion irradiation based devices appear robust against them. We finally present results on SQIF made with 2000 SQUID in series, showing a transfer function dV/dB ~ 1000V/T .
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
