Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userREX: X-ray experiment on the Water Recovery Rocket
111
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
This paper presents Rocket Experiment (REX) that was part of a dual payload rocket campaign for NASAs sounding rocket Black Brant IX with water recovery technology. This mission was a suborbital sounding rocket flight that was launched and recovered on April 4, 2018 and targeted the Vela supernova remnant. The purpose of REX was to classify the Technology Readiness Level of onboard devices designed for space applications. The devices were two wide-field X-ray telescopes consisting of a combination of Lobster-Eye (LE) optics with an uncooled Timepix detector (256 x 256 px @ 55 um), and additional sensors. The first telescope uses a two-dimensional combination of LE modules with a focal length of 1 m and a Field of View (FOV) of 1.0 x 1.2 deg and operates in the energy range of 3 - 60 keV. The second telescope was a one-dimensional LE with a focal length of 250 mm and a FOV of 2.7 x 8.0 deg for the energy range 3 - 40 keV. The X-ray telescopes were supplemented by a camera in the visible spectrum with 1,280 x 1,024 px resolution, which was used to obtain images of the observed sources and to verify the resulting pointing of the rocket carrier. Other devices also include infrared array sensors and inertial measurement units tested for future small satellite missions. The data handler and communication system were built using the Robot Operating System, and both the system and the electronics were deployed and operated in flight. The hardware was successfully recovered after the launch and the data were extracted.
rate research
Read More
Imaging X-rays by direct focusing offers greater sensitivity and a higher dynamic range compared to techniques based on indirect imaging. The Focusing Optics X-ray Solar Imager (FOXSI) is a sounding rocket payload that uses seven sets of nested Wolter-I figured mirrors to observe the Sun in hard X-rays through direct focusing. Characterizing the performance of these optics is critical to optimize their performance and to understand their resulting data. In this paper, we present a ray-tracing simulation we created and developed to study Wolter-I X-ray mirrors. We validated the accuracy of the ray-tracing simulation by modeling the FOXSI rocket optics. We found satisfactory agreements between the simulation predictions and laboratory data measured on the optics. We used the ray-tracing simulation to characterize a background pattern of singly reflected rays (i.e., ghost rays) generated by photons at certain incident angles reflecting on only one of a two-segment Wolter-I figure and still reaching the focal plane. We used the results of the ray-tracing simulation to understand, and to formulate a set of strategies that can be used to mitigate, the impact of ghost rays on the FOXSI optical modules. These strategies include the optimization of aperture plates placed at the entrance and exit of the smallest Wolter-I mirror used in FOXSI, a honeycomb type collimator, and a wedge absorber placed at the telescope aperture. The ray-tracing simulation proved to be a reliable set of tools to study Wolter-I X-ray optics. It can be used in many applications, including astrophysics, material sciences, and medical imaging.
A sounding-rocket program called the Chromospheric Lyman-Alpha Spectro-Polarimeter (CLASP) is proposed to be launched in the summer of 2014. CLASP will observe the solar chromosphere in Ly-alpha (121.567 nm), aiming to detect the linear polarization signal produced by scattering processes and the Hanle effect for the first time. The polarimeter of CLASP consists of a rotating half-waveplate, a beam splitter, and a polarization analyzer. Magnesium Fluoride (MgF2) is used for these optical components, because MgF2 exhibits birefringent property and high transparency at ultraviolet wavelength.
The Marshall Grazing Incidence Spectrometer {it MaGIXS} is a sounding rocket experiment that will observe the soft X-ray spectrum of the Sun from 24 - 6.0 AA (0.5 - 2.0 keV) and is scheduled for launch in 2021. Component and instrument level calibrations for the {it MaGIXS} instrument are carried out using the X-ray and Cryogenic Facility (XRCF) at NASA Marshall Space Flight Center. In this paper, we present the calibration of the incident X-ray flux from the electron impact source with different targets at the XRCF using a CCD camera; the photon flux at the CCD was low enough to enable its use as a photon counter i.e. the ability to identify individual photon hits and calculate their energy. The goal of this paper is two-fold: 1) to confirm that the flux measured by the XRCF beam normalization detectors is consistent with the values reported in the literature and therefore reliable for {it MaGIXS} calibration and 2) to develop a method of counting photons in CCD images that best captures their number and energy
Micro-X is a sounding rocket-borne instrument that uses a microcalorimeter array to perform high-resolution X-ray spectroscopy. This instrument flew for the first time on July 22nd, 2018 from the White Sands Missile Range, USA. This flight marks the first successful operation of a Transition-Edge Sensor array and its time division multiplexing read-out system in space. This launch was dedicated to the observation of the supernova remnant Cassiopeia A. A failure in the attitude control system prevented the rocket from pointing and led to no time on target. The on-board calibration source provided X-rays in flight, and it is used to compare detector performance during pre-flight integration, flight, and after the successful post-flight recovery. This calibration data demonstrates the capabilities of the detector in a space environment as well as its potential for future flights.
The Cosmic Infrared Background Experiment (CIBER) is a suite of four instruments designed to study the near infrared (IR) background light from above the Earths atmosphere. The instrument package comprises two imaging telescopes designed to characterize spatial anisotropy in the extragalactic IR background caused by cosmological structure during the epoch of reionization, a low resolution spectrometer to measure the absolute spectrum of the extragalactic IR background, and a narrow band spectrometer optimized to measure the absolute brightness of the Zodiacal light foreground. In this paper we describe the design and characterization of the CIBER payload. The detailed mechanical, cryogenic, and electrical design of the system are presented, including all system components common to the four instruments. We present the methods and equipment used to characterize the instruments before and after flight, and give a detailed description of CIBERs flight profile and configurations. CIBER is designed to be recoverable and has flown twice, with modifications to the payload having been informed by analysis of the first flight data. All four instruments performed to specifications during the second flight, and the scientific data from this flight are currently being analyzed.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
