Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userTuning the intermediate reaction barriers by CuPd catalyst to improve the selectivity of electroreduction CO2 to C2 products
82
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
Electrochemical CO2 reduction is a promising strategy for utilization of CO2 and intermittent excess electricity. Cu is the only single-metal catalyst that can electrochemically convert CO2 to multi-carbon products. However, Cu has an undesirable selectivity and activity for C2 products, due to its insufficient amount of CO* for C-C coupling. Considering the strong CO2 adsorption and ultra-fast reaction kinetics of CO* formation on Pd, an intimate CuPd(100) interface was designed to lower the intermediate reaction barriers and then improve the efficiency of C2 products. Density functional theory (DFT) calculations showed that the CuPd(100) interface has enhanced CO2 adsorption and decreased CO2* hydrogenation energy barrier, which are beneficial for C-C coupling. The potential-determining step (PDS) barrier of CO2 to C2 products on CuPd(100) interface is 0.61 eV, which is lower than that on Cu(100) (0.72 eV). Motivated by the DFT calculation, the CuPd(100) interface catalyst was prepared by a facile chemical solution method and demonstrated by transmission electron microscope (TEM). The CO2 temperature programmed desorption (CO2-TPD) and gas sensor experiments proved the enhancements of CO2 adsorption and CO2* hydrogenation abilities on CuPd(100) interface catalyst. As a result, the obtained CuPd(100) interface catalyst exhibits a C2 Faradaic efficiency of 50.3 (+/-) 1.2% at -1.4 VRHE in 0.1 M KHCO3, which is 2.1 times higher than 23.6(+/-) 1.5% of Cu catalyst. This work provides a rational design of Cu-based electrocatalyst for multi-carbon products by fine-tuning the intermediate reaction barriers.
rate research
Read More
The CO_{2} electro-reduction reaction (CORR) is a promising avenue to convert greenhouse gases into high-value fuels and chemicals, in addition to being an attractive method for storing intermittent renewable energy. Although polycrystalline Cu surfaces have long known to be unique in their capabilities of catalyzing the conversion of CO_{2} to higher-order C1 and C2 fuels, such as hydrocarbons (CH_{4}, C_{2}H_{4} etc.) and alcohols (CH_{3}OH, C_{2}H_{5}OH), product selectivity remains a challenge. In this study, we select three metal catalysts (Pt, Au, Cu) and apply in situ surface enhanced infrared absorption spectroscopy (SEIRAS) and ambient-pressure X-ray photoelectron spectroscopy (APXPS), coupled to density-functional theory (DFT) calculations, to get insight into the reaction pathway for the CORR. We present a comprehensive reaction mechanism for the CORR, and show that the preferential reaction pathway can be rationalized in terms of metal-carbon (M-C) and metal-oxygen (M-O) affinity. We show that the final products are determined by the configuration of the initial intermediates, C-bound and O-bound, which can be obtained from CO_{2} and (H)CO_{3}, respectively. C1 hydrocarbons are produced via OCH_{3, ad} intermediates obtained from O-bound CO_{3, ad} and require a catalyst with relatively high affinity for O-bound intermediates. Additionally, C2 hydrocarbon formation is suggested to result from the C-C coupling between C-bound CO_{ad} and (H)CO_{ad}, which requires an optimal affinity for the C-bound species, so that (H)CO_{ad} can be further reduced without poisoning the catalyst surface. Our findings pave the way towards a design strategy for CORR catalysts with improved selectivity, based on this experimental/theoretical reaction mechanisms that have been identified.
The $GW$ approximation is based on the neglect of vertex corrections, which appear in the exact self-energy and the exact polarizability. Here, we investigate the importance of vertex corrections in the polarizability only. We calculate the polarizability with equation-of-motion coupled-cluster theory with single and double excitations (EOM-CCSD), which rigorously includes a large class of diagrammatically-defined vertex corrections beyond the random phase approximation (RPA). As is well-known, the frequency-dependent polarizability predicted by EOM-CCSD is quite different and generally more accurate than that predicted by the RPA. We evaluate the effect of these vertex corrections on a test set of 20 atoms and molecules. When using a Hartree-Fock reference, ionization potentials predicted by the $GW$ approximation with the RPA polarizability are typically overestimated with a mean absolute error of 0.3 eV. However, those predicted with a vertex-corrected polarizability are typically underestimated with an increased mean absolute error of 0.5 eV. This result suggests that vertex corrections in the self-energy cannot be neglected, at least for molecules. We also assess the behavior of eigenvalue self-consistency in vertex-corrected $GW$ calculations, finding a further worsening of the predicted ionization potentials.
Manganese oxides have received much attention over the years among the wide range of electrocatalysts for the oxygen evolution reaction (OER) due to their low toxicity, high abundance and rich redox chemistry. While many previous studies focused on the activity of these materials, a better understanding of the material transformations relating to activation or degradation is highly desirable, both from a scientific perspective and for applications. We electrodeposited Na-containing MnOx without long-range order from an alkaline solution to investigate these aspects by cyclic voltammetry, scanning electron microscopy and x-ray absorption spectroscopy at the Mn-K and Mn-L edges. The pristine film was assigned to a layered edge-sharing Mn3+/4+ oxide with Mn-O bond lengths of mainly 1.87 {AA} and some at 2.30 {AA} as well as Mn-Mn bond lengths of 2.87 {AA} based on fits to the extended x-ray fine structure. The decrease of the currents at voltages before the onset of the OER followed power laws with three different exponents depending on the number of cycles and the Tafel slope decreases from 186 pm 48 to 114 pm 18 mV dec-1 after 100 cycles, which we interpret in the context of surface coverage with unreacted intermediates. Post-mortem microscopy and bulk spectroscopy at the Mn-K edge showed no change of the microstructure, bulk local structure or bulk Mn valence. Yet, the surface region of MnOx oxidized toward Mn4+, which explains the reduction of the currents in agreement with literature. Surprisingly, we find that MnOx reactivates after 30 min at open-circuit (OC), where the currents and also the Tafel slope increase. Reactivation processes during OC are crucial because OC is unavoidable when coupling the electrocatalysts to intermittent power sources such as solar energy for sustainable energy production.
The object of this study is the kinetic process of solid-liquid first-order phase transition - melting of carbon dioxide CS-I hydrate with various cavity occupation ratios. The work was done within a framework of study on the local structure of water molecules. These include the time depending change of the short-range order at temperatures close to the melting point and comparison with hexagonal ice structure. Using molecular dynamics method, dependencies of the internal energy of the studied systems on the time of heating were found. Jumps in the internal energy of solids in the range at 275-300 K indicate a phase transition. The study of oxygen-oxygen radial distribution and hydrogen-oxygen-oxygen mutual orientation angles between molecules detached at no more than 3.2 angstroms allowed to find the H-bond coordination number of all molecules and full number of H-bonds and showed the instant (less than 1 nanosecond) reorganization of short-range order of all molecules. The structure analysis of every neighbor water molecules pairs showed the ~10-15 percents decrease of H-bond number after the melting whereas all molecules form single long-range hydrogen bond network. The analysis of hydrogen bond network showed the minor changes in the H-bond interaction energy at solid-liquid phase transition.
Electrochemical reduction of CO2 to CO is a promising strategy. However, achieving high Faradaic efficiency with high current density using ILs electrolyte remains a challenge. In this study, the IL N octyltrimethyl 1,2,4 triazole ammonium shows outstanding performance for electrochemical reduction of CO2 to CO on the commercial Ag electrode, and the current density can be up to 50.8 mA cm-2 with a Faradaic efficiency of 90.6%. The current density of CO is much higher than those reported in the ILs electrolyte. In addition, the density functional theory calculation further proved that IL interacts with CO2 to form IL CO2 complex which played a key role in reducing the activation energy of CO2. According to the molecular orbital theory, the electrons obtained from ILs was filled in the anti bonding orbit of the CO2, resulting in reducing the C=O bond energy. This work provides a new strategy to design novel ILs for high efficiency electrochemical reduction of CO2 to CO.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
