Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userDecoupling between propagating acoustic waves and two-level systems in hydrogenated amorphous silicon
114
0
0.0
(
0
)
Authors
M. Molina-Ruiz
Ask ChatGPT about the research
No Arabic abstract
Specific heat measurements of hydrogenated amorphous silicon prepared by hot-wire chemical vapor deposition show a large density of two-level systems at low temperature. Annealing at 200 {deg}C, well below the growth temperature, does not significantly affect the already-low internal friction or the sound velocity, but irreversibly reduces the non-Debye specific heat by an order of magnitude at 2 K, indicating a large reduction of the density of two-level systems. Comparison of the specific heat to the internal friction suggests that the two-level systems are uncharacteristically decoupled from acoustic waves, both before and after annealing. Analysis yields an anomalously low value of the coupling constant, which increases upon annealing but still remains anomalously low. The results suggest that the coupling constant value is lowered by the presence of hydrogen.
rate research
Read More
Specific heat measurements from 2 to 300 K of hydrogenated amorphous silicon prepared by hot-wire chemical vapor deposition show a large excess specific heat at low temperature, significantly larger than the Debye specific heat calculated from the sound velocity. The as-prepared films have a Schottky anomaly that is associated with metastable hydrogen in the amorphous network, as well as large linear and excess cubic term commonly associated with tunneling two-level systems in amorphous solids. Annealing at 200 {deg}C, a temperature that enables hydrogen mobility but not evaporation, irreversibly reduces the heat capacity, eliminating the Schottky anomaly and leaving a reduced linear heat capacity. A non-monotonic dependence on growth temperature and H content is observed in all effects, except for sound velocity, which suggests that the tunneling two-level systems and the Schottky anomaly are associated with atomic hydrogen and require low density regions to form, while sound velocity is associated with the silicon network and improves with increasing growth temperature.
In $e$-beam evaporated amorphous silicon ($a$-Si), the densities of two-level systems (TLS), $n_{0}$ and $overline{P}$, determined from specific heat $C$ and internal friction $Q^{-1}$ measurements, respectively, have been shown to vary by over three orders of magnitude. Here we show that $n_{0}$ and $overline{P}$ are proportional to each other with a constant of proportionality that is consistent with the measurement time dependence proposed by Black and Halperin and does not require the introduction of additional anomalous TLS. However, $n_{0}$ and $overline{P}$ depend strongly on the atomic density of the film ($n_{rm Si}$) which depends on both film thickness and growth temperature suggesting that the $a$-Si structure is heterogeneous with nanovoids or other lower density regions forming in a dense amorphous network. A review of literature data shows that this atomic density dependence is not unique to $a$-Si. These findings suggest that TLS are not intrinsic to an amorphous network but require a heterogeneous structure to form.
Amorphous silicon contains tunneling two-level systems, which are the dominant energy loss mechanisms for amorphous solids at low temperatures. These two-level systems affect both mechanical and electromagnetic oscillators and are believed to produce thermal and electromagnetic noise and energy loss. However, it is unclear whether the two-level systems that dominate mechanical and dielectric losses are the same; the former relies on phonon-TLS coupling, with an elastic field coupling constant, $gamma$, while the latter depends on a TLS dipole moment, $p_0$, which couples to the electromagnetic field. Mechanical and dielectric loss measurements as well as structural characterization were performed on amorphous silicon thin films grown by electron beam deposition with a range of growth parameters. Samples grown at 425 $^{circ}$C show a large reduction of mechanical loss (34 times) and a far smaller reduction of dielectric loss (2.3 times) compared to those grown at room temperature. Additionally, mechanical loss shows lower loss per unit volume for thicker films, while dielectric loss shows lower loss per unit volume for thinner films. Analysis of these results indicate that mechanical loss correlates with atomic density, while dielectric loss correlates with dangling bond density, suggesting a different origin for these two energy dissipation processes in amorphous silicon.
The nanostructure of hydrogenated amorphous silicon (a Si:H) is studied by a combination of small-angle X-ray (SAXS) and neutron scattering (SANS) with a spatial resolution of 0.8 nm. The a-Si:H materials were deposited using a range of widely varied conditions and are representative for this class of materials. We identify two different phases which are embedded in the a-Si:H matrix and quantified both according to their scattering cross-sections. First, 1.2 nm sized voids (multivacancies with more than 10 missing atoms) which form a superlattice with 1.6 nm void-to-void distance are detected. The voids are found in concentrations as high as 6*10^19 ccm in a-Si:H material that is deposited at a high rate. Second, dense ordered domains (DOD) that are depleted of hydrogen with 1 nm average diameter are found. The DOD tend to form 10-15 nm sized aggregates and are largely found in all a-Si:H materials considered here. These quantitative findings make it possible to understand the complex correlation between structure and electronic properties of a-Si:H and directly link them to the light-induced formation of defects. Finally, a structural model is derived, which verifies theoretical predictions about the nanostructure of a-Si:H.
We implement dynamical decoupling techniques to mitigate noise and enhance the lifetime of an entangled state that is formed in a superconducting flux qubit coupled to a microscopic two-level system. By rapidly changing the qubits transition frequency relative to the two-level system, we realize a refocusing pulse that reduces dephasing due to fluctuations in the transition frequencies, thereby improving the coherence time of the entangled state. The coupling coherence is further enhanced when applying multiple refocusing pulses, in agreement with our $1/f$ noise model. The results are applicable to any two-qubit system with transverse coupling, and they highlight the potential of decoupling techniques for improving two-qubit gate fidelities, an essential prerequisite for implementing fault-tolerant quantum computing.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
