Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userStatistical Analysis of Thermal Conductivity Experimentally Measured in Water-Based Nanofluids
92
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
Nanofluids are suspensions of nanoparticles in a base heat-transfer liquid. They have been widely investigated to boost heat transfer since they were proposed in the 1990s. We present a statistical correlation analysis of experimentally measured thermal conductivity of water-based nanofluids available in the literature. The influences of particle concentration, particle size, temperature and surfactants are investigated. For specific materials (alumina, titania, copper oxide, copper, silica and silicon carbide), separate analyses are performed. The conductivity increases with the concentration in qualitative agreement with Maxwells theory of homogeneous media. The conductivity also increases with the temperature (in addition to the improvement due to the increased conductivity with water). Surprisingly, only silica nanofluids exhibit a statistically significant effect of particle size, whereby smaller particles lead to faster heat transfer. Overall, the large scatter in the experimental data prevents a compelling, unambiguous assessment of these effects. Taken together, the results of our analysis suggest that more comprehensive experimental characterizations of nanofluids are necessary to estimate their practical potential.
rate research
Read More
Single GaN nanowires formed spontaneously on a given substrate represent nanoscopic single crystals free of any extended defects. However, due to the high area density of thus formed GaN nanowire ensembles, individual nanowires coalesce with others in their immediate vicinity. This coalescence process may introduce strain and structural defects, foiling the idea of defect-free material due to the nanowire geometry. To investigate the consequences of this process, a quantitative measure of the coalescence of nanowire ensembles is required. We derive objective criteria to determine the coalescence degree of GaN nanowire ensembles. These criteria are based on the area-perimeter relationship of the cross-sectional shapes observed, and in particular on their circularity. Employing these criteria, we distinguish single nanowires from coalesced aggregates in an ensemble, determine the diameter distribution of both, and finally analyze the coalescence degree of nanowire ensembles with increasing fill factor.
In recent years, nanostructuring of dielectric and semiconducting crystals has enhanced controllability of their thermal conductivity. To carry out computational material search for nanostructured materials with desirable thermal conductivity, a key property is the thermal conductivity spectrum of the original single crystal, which determines the appropriate length scale of nanostructures and mutual adaptability of different kinds of nanostructures. Although the first-principles phonon transport calculations have become accessible, the anharmonic lattice dynamics calculations are still heavy to scan many materials. To this end, we have developed an empirical model that describes the thermal conductivity spectrum in terms only of harmonic phonon properties and bulk thermal conductivity. The model was tested for several crystals with different structures and thermal conductivities, and was confirmed to reproduce the overall profiles of thermal conductivity spectra and their anharmonic calculations.
Water management in a hydrogen polymer electrolyte membrane (PEM) fuel cell is critical for performance. The impact of thermal conductivity and water vapor diffusion coefficients in a gas diffusion layer (GDL) has been studied by a mathematical model. The fraction of product water that is removed in the vapour phase through the GDL as a function of GDL properties and operating conditions has been calculated and discussed. Furthermore, the current model enables identification of conditions when condensation occurs in each GDL component and calculation of temperature gradient across the interface between different layers, providing insight into the overall mechanism of water transport in a given cell design. Water transport mode and condensation conditions in the GDL components depend on the combination of water vapor diffusion coefficients and thermal conductivities of the GDL components. Different types of GDL and water removal scenarios have been identified and related to experimentally-determined GDL properties.
96 -
Yujin Tong
, Tobias Kampfrath
, R. Kramer Campen (Fritz Habern Institute of the Max Planck Society
2017
Most properties of liquid water are determined by its hydrogen-bond network. Because forming an aqueous interface requires termination of this network, one might expect the molecular level properties of interfacial water to markedly differ from water in bulk. Intriguingly, much prior experimental and theoretical work has found that, from the perspective of their time-averaged structure and picosecond structural dynamics, hydrogen-bonded OH groups at an air/water interface behave the same as hydrogen-bonded OH groups in bulk liquid water. Here we report the first experimental observation of interfacial waters libration (i.e. frustrated rotation) using the laser-based technique vibrational sum frequency spectroscopy. We find this mode has a frequency of 834 cm$^{-1}$, $approx 165$ cm$^{-1}$ higher than in bulk liquid water at the same temperature and similar to bulk ice. Because libration frequency is proportional to the stiffness of waters rotational potential, this increase suggests that one effect of terminating bulk waters hydrogen bonding network at the air/water interface is retarding rotation of water around intact hydrogen bonds. Because in bulk liquid water the libration plays a key role in stabilizing reaction intermediates and dissipating excess vibrational energy, we expect the ability to probe this mode in interfacial water to open new perspectives on the kinetics of heterogeneous reactions at aqueous interfaces.
Phonon engineering focuses on heat transport modulation on atomic-scale. Different from reported methods, it is shown that electric field can also modulate heat transport in ferroelectric polymers, poly(vinylidene fluoride), by both simulation and measurement. Interestingly, thermal conductivities of poly(vinylidene fluoride) array can be enhanced by a factor of 3.25 along the polarization direction by simulation. The semi-crystalline poly(vinylidene fluoride) film can be also enhanced by a factor of 1.5 which is found by both simulation and measurement. The morphology and phonon property analysis reveal that the enhancement arises from the higher inter-chain lattice order, stronger inter-chain interaction, higher phonon group velocity and suppressed phonon scattering. This study offers a new modulation strategy with quick response and without fillers.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
