Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userLaboratory study of the torus instability threshold in solar-relevant, line-tied magnetic flux ropes
88
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
Coronal mass ejections (CME) occur when long-lived magnetic flux ropes (MFR) anchored to the solar surface destabilize and erupt away from the Sun. This destabilization is often described in terms of an ideal magnetohydrodynamic (MHD) instability called the torus instability. It occurs when the external magnetic field decreases sufficiently fast such that its decay index, $n=-z,partial,(ln B)/partial z$ is larger than a critical value, $n>n_{rm cr}$, where $n_{rm cr}=1.5$ for a full, large aspect ratio torus. However, when this is applied to solar MFRs, a range of conflicting values for $n_{rm cr}$ is found in the literature. To investigate this discrepancy, we have conducted laboratory experiments on arched, line-tied flux ropes and have applied a theoretical model of the torus instability. Our model describes an MFR as a partial torus with footpoints anchored in a conducting surface and numerically calculates various magnetic forces on it. This calculation yields a better prediction of $n_{rm cr}$ which takes into account the specific parameters of the MFR. We describe a systematic methodology to properly translate laboratory results to their solar counterparts, provided that the MFRs have sufficiently small edge safety factor, or equivalently, large enough twist. After this translation, our model predicts that $n_{rm cr}$ in solar conditions often falls near $n_{rm cr}^{rm Sol}sim0.9$ and within a larger range of $n_{rm cr}^{rm Sol}sim(0.7,1.2)$ depending on the parameters. The methodology of translating laboratory MFRs to their solar counterparts enables quantitative investigations of the initiation of CMEs through laboratory experiments. These experiments allow for new physics insights that are required for better predictions of space weather events but are difficult to obtain otherwise.
rate research
Read More
Magnetic flux ropes (MFRs) are thought to be the central structure of solar eruptions, and their ideal MHD instabilities can trigger the eruption. Here we performed a study of all the MFR configurations that lead to major solar flares, either eruptive or confined, from 2011 to 2017 near the solar disk center. The coronal magnetic field is reconstructed from observed magnetograms, and based on magnetic twist distribution, we identified the MFR, which is defined as a coherent group of magnetic field lines winding an axis with more than one turn. It is found that 90% of the events possess pre-flare MFRs, and their three-dimensional structures are much more complex in details than theoretical MFR models. We further constructed a diagram based on two parameters, the magnetic twist number which controls the kink instability (KI), and the decay index which controls the torus instability (TI). It clearly shows lower limits for TI and KI thresholds, which are $n_{rm crit} = 1.3$ and $|T_w|_{rm crit} = 2$, respectively, as all the events above $n_{rm crit}$ and nearly 90% of the events above $|T_w|_{rm crit}$ erupted. Furthermore, by such criterion, over 70% of the events can be discriminated between eruptive and confined flares, and KI seems to play a nearly equally important role as TI in discriminating between the two types of flare. There are more than half of events with both parameters below the lower limits, and 29% are eruptive. These events might be triggered by magnetic reconnection rather than MHD instabilities.
We report on the detailed and systematic study of field-line twist and length distributions within magnetic flux ropes embedded in Interplanetary Coronal Mass Ejections (ICMEs). The Grad-Shafranov reconstruction method is utilized together with a constant-twist nonlinear force-free (Gold-Hoyle) flux rope model to reveal the close relation between the field-line twist and length in cylindrical flux ropes, based on in-situ Wind spacecraft measurements. We show that the field-line twist distributions within interplanetary flux ropes are inconsistent with the Lundquist model. In particular we utilize the unique measurements of magnetic field-line lengths within selected ICME events as provided by Kahler et al. (2011) based on energetic electron burst observations at 1 AU and the associated type III radio emissions detected by the Wind spacecraft. These direct measurements are compared with our model calculations to help assess the flux-rope interpretation of the embedded magnetic structures. By using the different flux-rope models, we show that the in-situ direct measurements of field-line lengths are consistent with a flux-rope structure with spiral field lines of constant and low twist, largely different from that of the Lundquist model, especially for relatively large-scale flux ropes.
It remains unclear how solar flares are triggered and in what conditions they can be eruptive with coronal mass ejections. Magnetic flux ropes (MFRs) has been suggested as the central magnetic structure of solar eruptions, and their ideal instabilities including mainly the kink instability (KI) and torus instability (TI) provide important candidates for triggering mechanisms. Here using magnetic field extrapolations from observed photospheric magnetograms, we systematically studied the variation of coronal magnetic fields, focusing on MFRs, through major flares including 29 eruptive and 16 confined events. We found that nearly 90% events possess MFR before flare and 70% have MFR even after flare. We calculated the controlling parameters of KI and TI, including the MFRs maximum twist number and the decay index of its strapping field. Using the KI and TI thresholds empirically derived from solely the pre-flare MFRs, two distinct different regimes are shown in the variation of the MFR controlling parameters through flares. For the events with both parameters below their thresholds before flare, we found no systematic change of the parameters after the flares, in either the eruptive or confined events. In contrast, for the events with any of the two parameters exceeding their threshold before flare (most of them are eruptive), there is systematic decrease in the parameters to below their thresholds after flares. These results provide a strong constraint for the values of the instability thresholds and also stress the necessity of exploring other eruption mechanisms in addition to the ideal instabilities.
We investigate the formation times of eruptive magnetic flux ropes relative to the onset of solar eruptions, which is important for constraining models of coronal mass ejection (CME) initiation. We inspected uninterrupted sequences of 131 AA images that spanned more than eight hours and were obtained by the Atmospheric Imaging Assembly (AIA) on board the Solar Dynamics Observatory (SDO) to identify the formation times of hot flux ropes that erupted in CMEs from locations close to the limb. The appearance of the flux ropes as well as their evolution toward eruptions were determined using morphological criteria. Two-thirds (20/30) of the flux ropes were formed well before the onset of the eruption (from 51 minutes to more than eight hours), and their formation was associated with the occurrence of a confined flare. We also found four events with preexisting hot flux ropes whose formations occurred a matter of minutes (from three to 39) prior to the eruptions without any association with distinct confined flare activity. Six flux ropes were formed once the eruptions were underway. However, in three of them, prominence material could be seen in 131 AA images, which may indicate the presence of preexisting flux ropes that were not hot. The formation patterns of the last three groups of hot flux ropes did not show significant differences. For the whole population of events, the mean and median values of the time difference between the onset of the eruptive flare and the appearance of the hot flux rope were 151 and 98 minutes, respectively. Our results provide, on average, indirect support for CME models that involve preexisting flux ropes; on the other hand, for a third of the events, models in which the ejected flux rope is formed during the eruption appear more appropriate.
Coronal magnetic flux ropes are generally considered to be the core structure of large-scale solar eruptions. Recent observations found that solar eruptions could be initiated by a sequence of flux feeding, during which chromospheric fibrils rise upward from below, and merge with a pre-existing prominence. Further theoretical study has confirmed that the flux feeding mechanism is efficient in causing the eruption of flux ropes that are wrapped by bald patch separatrix surfaces. But it is unclear how flux feeding influences coronal flux ropes that are wrapped by hyperbolic flux tubes (HFT), and whether it is able to cause the flux-rope eruption. In this paper, we use a 2.5-dimensional magnetohydrodynamic model to simulate the flux feeding processes in HFT configurations. It is found that flux feeding injects axial magnetic flux into the flux rope, whereas the poloidal flux of the rope is reduced after flux feeding. Flux feeding is able to cause the flux rope to erupt, provided that the injected axial flux is large enough so that the critical axial flux of the rope is reached. Otherwise, the flux rope system evolves to a stable equilibrium state after flux feeding, which might be even farther away from the onset of the eruption, indicating that flux feeding could stabilize the rope system with the HFT configuration in this circumstance.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
