Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userSPHERE / ZIMPOL high resolution polarimetric imager. I. System overview, PSF parameters, coronagraphy, and polarimetry
65
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
We describe the Zurich Imaging Polarimeter (ZIMPOL), the visual focal plane subsystem of the SPHERE VLT planet finder, which pushes the limits of current AO systems to shorter wavelengths, higher spatial resolution, and much improved polarimetric performance. We provide new benchmarks for the performance of high contrast instruments, in particular for polarimetric differential imaging. We have analyzed SPHERE/ZIMPOL point spread functions and measure the peak surface brightness, the encircled energy, and the full width half maximum (FWHM) for different wavelengths, atmospheric conditions, star brightness, and instrument modes. Coronagraphic images are described and analized and the performance for different coronagraphs is compared with tests for the binary alpha Hyi with a separation of 92 mas and a contrast of 6 mag. For the polarimetric mode we made the instrument calibrations using zero polarization and high polarization standard stars and here we give a recipe for the absolute calibration of polarimetric data. The data show a small <1 mas but disturbing differential polarimetric beam shifts, which can be explained as Goos-Hahnchen shifts from the inclined mirrors, and we discuss how to correct this effect. The polarimetric sensitivity is investigated with non-coronagraphic and deep, coronagraphic observations of the dust scattering around the symbiotic Mira variable R Aqr. SPHERE/ZIMPOL achieves imaging performances in the visual range with unprecedented characteristics, in particular very high spatial resolution and very high polarimetric contrast. This instrument opens up many new research opportunities for the detailed investigation of circumstellar dust, in scattered and therefore polarized light, for the investigation of faint companions, and for the mapping of circumstellar Halpha emission.
rate research
Read More
The outflows of oxygen-rich asymptotic giant branch (AGB) stars are thought to be driven by radiation pressure by photon scattering on grains with sizes of tenths of microns. The details of the formation of dust in the extended atmospheres of these stars and the mass-loss process is still not well understood. We obtained quasi-simultaneous observations of the AGB star Mira using ALMA and ZIMPOL to probe the distribution of gas and large dust grains, respectively. The polarized light images show dust around Mira~A, the companion (Mira~B) and in a trail that connects the two sources. ALMA reveals that dust around Mira~A is contained in a high-gas-density region with a significant fraction of the polarized light arising from its edge. We constrained the gas density, temperature, and velocity within a few stellar radii from the star by modelling the CO $v=1, J=3-2$ line. We find a mass $(sim 3.8 pm 1.3) times 10^{-4}~M_odot$ to be contained between the stellar millimetre photosphere, $R^{rm 338~GHz}_star$, and $4~R^{rm 338~GHz}_star$. Our best-fit models with lower masses also reproduce the $^{13}$CO $v=0, J=3-2$ line emission from this region. We find TiO$_2$ and AlO abundances corresponding to 4.5% and $< 0.1$% of the total titanium and aluminium expected for a solar-composition gas. The low abundance of AlO allows for efficient Al depletion into dust already very close to the star, as expected from thermal dust emission observations and theoretical calculations of Mira variables. We constrain the presence of aluminium oxide grains based on the scattered light observations and our gas-phase model. We find that aluminium oxide grains can account for a significant fraction of the total aluminium atoms in this region only if the grains have sizes $lesssim 0.02~mu$m. This is an order of magnitude smaller than the maximum sizes predicted by dust-formation and wind-driving models.
We present the first optical (590--890 nm) imaging polarimetry observations of the pre-transitional protoplanetary disk around the young solar analog LkCa 15, addressing a number of open questions raised by previous studies. We detect the previously unseen far side of the disk gap, confirm the highly eccentric scattered-light gap shape that was postulated from near-infrared imaging, at odds with the symmetric gap inferred from millimeter interferometry. Furthermore, we resolve the inner disk for the first time and trace it out to 30 AU. This new source of scattered light may contribute to the near-infrared interferometric signal attributed to the protoplanet candidate LkCa 15 b, which lies embedded in the outer regions of the inner disk. Finally, we present a new model for the system architecture of LkCa 15 that ties these new findings together. These observations were taken during science verification of SPHERE ZIMPOL and demonstrate this facilitys performance for faint guide stars under adverse observing conditions.
This paper describes the Polarimetric and Helioseismic Imager on the Solar Orbiter mission (SO/PHI), the first magnetograph and helioseismology instrument to observe the Sun from outside the Sun-Earth line. It is the key instrument meant to address the top-level science question: How does the solar dynamo work and drive connections between the Sun and the heliosphere? SO/PHI will also play an important role in answering the other top-level science questions of Solar Orbiter, as well as hosting the potential of a rich return in further science. SO/PHI measures the Zeeman effect and the Doppler shift in the FeI 617.3nm spectral line. To this end, the instrument carries out narrow-band imaging spectro-polarimetry using a tunable LiNbO_3 Fabry-Perot etalon, while the polarisation modulation is done with liquid crystal variable retarders (LCVRs). The line and the nearby continuum are sampled at six wavelength points and the data are recorded by a 2kx2k CMOS detector. To save valuable telemetry, the raw data are reduced on board, including being inverted under the assumption of a Milne-Eddington atmosphere, although simpler reduction methods are also available on board. SO/PHI is composed of two telescopes; one, the Full Disc Telescope (FDT), covers the full solar disc at all phases of the orbit, while the other, the High Resolution Telescope (HRT), can resolve structures as small as 200km on the Sun at closest perihelion. The high heat load generated through proximity to the Sun is greatly reduced by the multilayer-coated entrance windows to the two telescopes that allow less than 4% of the total sunlight to enter the instrument, most of it in a narrow wavelength band around the chosen spectral line.
Context. Polarimetric imaging is one of the most effective techniques for high-contrast imaging and characterization of protoplanetary disks, and has the potential to be instrumental in characterizing exoplanets. VLT/SPHERE contains the InfraRed Dual-band Imager and Spectrograph (IRDIS) with a dual-beam polarimetric imaging (DPI) mode, which offers the capability to obtain linear polarization images at high contrast and resolution. Aims. We aim to provide an overview of IRDIS/DPI and study its optical design to improve observing strategies and data reduction. Methods. For H-band observations of TW Hya, we compare two data reduction methods that correct for instrumental polarization effects in different ways: a minimization of the noise image, and a polarimetric-model-based correction method that we present in Paper II of this study. Results. We use observations of TW Hya to illustrate the data reduction. In the images of the protoplanetary disk around this star we detect variability in the polarized intensity and angle of linear polarization with pointing-dependent instrument configuration. We explain these variations as instrumental polarization effects and correct for these effects using our model-based correction method. Conclusions. IRDIS/DPI has proven to be a very successful and productive high-contrast polarimetric imaging system. However, the instrument performance depends on the specific instrument configuration. We suggest adjustments to future observing strategies to optimize polarimetric efficiency in field tracking mode by avoiding unfavourable derotator angles. We recommend reducing on-sky data with the pipeline called IRDAP that includes the model-based correction method (described in Paper II) to optimally account for the remaining telescope and instrumental polarization effects and to retrieve the true polarization state of the incident light.
ERIS is a diffraction limited thermal infrared imager and spectrograph for the Very Large Telescope UT4. One of the science cases for ERIS is the detection and characterization of circumstellar structures and exoplanets around bright stars that are typically much fainter than the stellar diffraction halo. Enhanced sensitivity is provided through the combination of (i) suppression of the diffraction halo of the target star using coronagraphs, and (ii) removal of any residual diffraction structure through focal plane wavefront sensing and subsequent active correction. In this paper we present the two coronagraphs used for diffraction suppression and enabling high contrast imaging in ERIS.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
