Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userPlanar Hall effect in antiferromagnetic MnTe thin films
132
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
We show that the spin-orbit coupling (SOC) in alpha-MnTe impacts the transport behavior by generating an anisotropic valence-band splitting, resulting in four spin-polarized pockets near Gamma. A minimal k-dot-p model is constructed to capture this splitting by group theory analysis, a tight-binding model and ab initio calculations. The model is shown to describe the rotation symmetry of the zero-field planer Hall effect (PHE). The upper limit of the PHE percentage is shown to be fundamentally determined by the band shape, and is quantitatively estimated to be roughly 31% by first principles.
rate research
Read More
We report on Cr doping effect in Mn3Sn polycrystalline films with both uniform and modulation doping. It is found that Cr doping with low concentration does not cause notable changes to the structural and magnetic properties of Mn3Sn, but it significantly enhances the anomalous Hall conductivity, particularly for modulation-doped samples at low temperature. A Hall conductivity as high as 184.8 {Omega}-1 cm-1 is obtained for modulation-doped samples at 50 K, in a sharp contrast to vanishingly small values for undoped samples at the same temperature. We attribute the enhancement to the change of Fermi level induced by Cr doping
Strong electronic correlations can produce remarkable phenomena such as metal-insulator transitions and greatly enhance superconductivity, thermoelectricity, or optical non-linearity. In correlated systems, spatially varying charge textures also amplify magnetoelectric effects or electroresistance in mesostructures. However, how spatially varying spin textures may influence electron transport in the presence of correlations remains unclear. Here we demonstrate a very large topological Hall effect (THE) in thin films of a lightly electron-doped charge-transfer insulator, (Ca, Ce)MnO3. Magnetic force microscopy reveals the presence of magnetic bubbles, whose density vs. magnetic field peaks near the THE maximum, as is expected to occur in skyrmion systems. The THE critically depends on carrier concentration and diverges at low doping, near the metal-insulator transition. We discuss the strong amplification of the THE by correlation effects and give perspectives for its non-volatile control by electric fields.
A common perception assumes that magnetic memories require ferromagnetic materials with a non-zero net magnetic moment. However, it has been recently proposed that compensated antiferromagnets with a zero net moment may represent a viable alternative to ferromagnets. So far, experimental research has focused on bistable memories in antiferromagnetic metals. In the present work we demonstrate a multiple-stable memory device in epitaxial manganese telluride (MnTe) which is an antiferromagnetic counterpart of common II-VI semiconductors. Favorable micromagnetic characteristics of MnTe allow us to demonstrate a smoothly varying antiferromagnetic anisotropic magnetoresistance (AMR) with a harmonic angular dependence on the applied magnetic field, analogous to ferromagnets. The continuously varying AMR provides means for the electrical read-out of multiple-stable antiferromagnetic memory states which we set by heat-assisted magneto-recording and by changing the angle of the writing field. We explore the dependence of the magnitude of the zero-field read-out signal on the strength of the writing field and demonstrate the robustness of the antiferromagnetic memory states against strong magnetic field perturbations. We ascribe the multiple-stability in our antiferromagnetic memory to different distributions of domains with the Neel vector aligned along one of the three $c$-plane magnetic easy axes in the hexagonal MnTe film. The domain redistribution is controlled during the heat-assisted recording by the strength and angle of the writing field and freezes when sufficiently below the Neel temperature.
A central theme in condensed matter physics is to create and understand the exotic states of matter by incorporating magnetism into topological materials. One prime example is the quantum anomalous Hall (QAH) state. Recently, MnBi2Te4 has been demonstrated to be an intrinsic magnetic topological insulator and the QAH effect was observed in exfoliated MnBi2Te4 flakes. Here, we used molecular beam epitaxy (MBE) to grow MnBi2Te4 films with thickness down to 1 septuple layer (SL) and performed thickness-dependent transport measurements. We observed a non-square hysteresis loop in the antiferromagnetic state for films with thickness greater than 2 SL. The hysteresis loop can be separated into two AH components. Through careful analysis, we demonstrated that one AH component with the larger coercive field is from the dominant MnBi2Te4 phase, while the other AH component with the smaller coercive field is from the minor Mn-doped Bi2Te3 phase in the samples. The extracted AH component of the MnBi2Te4 phase shows a clear even-odd layer-dependent behavior, a signature of antiferromagnetic thin films. Our studies reveal insights on how to optimize the MBE growth conditions to improve the quality of MnBi2Te4 films, in which the QAH and other exotic states are predicted.
Anomalous valley Hall (AVH) effect is a fundamental transport phenomenon in the field of condensed-matter physics. Usually, the research on AVH effect is mainly focused on 2D lattices with ferromagnetic order. Here, by means of model analysis, we present a general design principle for realizing AVH effect in antiferromagnetic monolayers, which involves the introduction of nonequilibrium potentials to break of PT symmetry. Using first-principles calculations, we further demonstrate this design principle by stacking antiferromagnetic monolayer MnPSe3 on ferroelectric monolayer Sc2CO2 and achieve the AVH effect. The AVH effect can be well controlled by modulating the stacking pattern. In addition, by reversing the ferroelectric polarization of Sc2CO2 via electric field, the AVH effect in monolayer MnPSe3 can be readily switched on or off. The underlying physics are revealed in detail. Our findings open up a new direction of research on exploring AVH effect.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
