Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userStrain Modulation of Graphene by Nanoscale Substrate Curvatures: A Molecular View
204
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
Spatially nonuniform strain is important for engineering the pseudomagnetic field and band structure of graphene. Despite the wide interest in strain engineering, there is still a lack of control on device-compatible strain patterns due to the limited understanding of the structure-strain relationship. Here, we study the effect of substrate corrugation and curvature on the strain profiles of graphene via combined experimental and theoretical studies of a model system: graphene on closely packed SiO2 nanospheres with different diameters (20-200 nm). Experimentally, via quantitative Raman analysis, we observe partial adhesion and wrinkle features and find that smaller nanospheres induce larger tensile strain in graphene, theoretically, molecular dynamics simulations confirm the same microscopic structure and size dependence of strain and reveal that a larger strain is caused by a stronger, inhomogeneous interaction force between smaller nanospheres and graphene. This molecular-level understanding of the strain mechanism is important for strain engineering of graphene and other two-dimensional materials.
rate research
Read More
Strain engineering offers unique control to manipulate the electronic band structure of two-dimensional materials (2DMs) resulting in an effective and continuous tuning of the physical properties. Ad-hoc straining 2D materials has demonstrated novel devices including efficient photodetectors at telecommunication frequencies, enhanced-mobility transistors, and on-chip single photon source, for example. However, in order to gain insights into the underlying mechanism required to enhance the performance of the next-generation devices with strain(op)tronics, it is imperative to understand the nano- and microscopic properties as a function of a strong non-homogeneous strain. Here, we study the strain-induced variation of local conductivity of a few-layer transition-metal-dichalcogenide using a conductive atomic force microscopy. We report a novel strain characterization technique by capturing the electrical conductivity variations induced by local strain originating from surface topography at the nanoscale, which allows overcoming limitations of existing optical spectroscopy techniques. We show that the conductivity variations parallel the strain deviations across the geometry predicted by molecular dynamics simulation. These results substantiate a variation of the effective mass and surface charge density by .026 me/% and .03e/% of uniaxial strain, respectively. Furthermore, we show and quantify how a gradual reduction of the conduction band minima as a function of tensile strain explains the observed reduced effective Schottky barrier height. Such spatially-textured electronic behavior via surface topography induced strain variations in atomistic-layered materials at the nanoscale opens up new opportunities to control fundamental material properties and offers a myriad of design and functional device possibilities for electronics, nanophotonics, flextronics, or smart cloths.
Engineering of cooling mechanisms is a bottleneck in nanoelectronics. Whereas thermal exchanges in diffusive graphene are mostly driven by defect assisted acoustic phonon scattering, the case of high-mobility graphene on hexagonal Boron Nitride (hBN) is radically different with a prominent contribution of remote phonons from the substrate. A bi-layer graphene on hBN transistor with local gate is driven in a regime where almost perfect current saturation is achieved by compensation of the decrease of the carrier density and Zener-Klein tunneling (ZKT) at high bias. Using noise thermometry, we show that this Zener-Klein tunneling triggers a new cooling pathway due to the emission of hyperbolic phonon polaritons (HPP) in hBN by out-of-equilibrium electron-hole pairs beyond the super-Planckian regime. The combination of ZKT-transport and HPP-cooling promotes graphene on BN transistors as a valuable nanotechnology for power devices and RF electronics.
The modulation of the transmitted (reflected) radiation due to change of interband transitions under variation of carriers concentration by the gate voltage is studied theoretically. The calculations were performed for strongly doped graphene on high-K (Al_2O_3, HfO_2, AlN, and ZrO_2) or SiO_2 substrates under normal propagation of radiation. We have obtained the modulation depth above 10% depending on wavelength, gate voltage (i.e. carriers concentration), and parameters of substrate. The graphene - dielectric substrate - doped Si (as gate) structures can be used as an effective electrooptical modulator of near-IR and mid-IR radiation for the cases of high-K and SiO_2 substrates, respectively.
We computationally study the effect of uniaxial strain in modulating the spontaneous emission of photons in silicon nanowires. Our main finding is that a one to two orders of magnitude change in spontaneous emission time occurs due to two distinct mechanisms: (A) Change in wave function symmetry, where within the direct bandgap regime, strain changes the symmetry of wave functions, which in turn leads to a large change of optical dipole matrix element. (B) Direct to indirect bandgap transition which makes the spontaneous photon emission to be of a slow second order process mediated by phonons. This feature uniquely occurs in silicon nanowires while in bulk silicon there is no change of optical properties under any reasonable amount of strain. These results promise new applications of silicon nanowires as optoelectronic devices including a mechanism for lasing. Our results are verifiable using existing experimental techniques of applying strain to nanowires.
The strain engineering technique allows us to alter the electronic properties of graphene in various ways. Within the continuum approximation, the influences of strain result in the appearance of a pseudo-gauge field and modulated Fermi velocity. In this study, we investigate theoretically the effect of linear uniaxial tensile strain and/or stress, which makes the Fermi velocity anisotropic, on a magnetized graphene sheet in the presence of an applied electrostatic voltage. More specifically, we analyze the consequences of the anisotropic nature of the Fermi velocity on the structure Landau levels and de Haas - van Alphen (dHvA) quantum oscillation in the magnetized graphene sheet. The effect of the direction of the applied strain has also been discussed.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
