Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userATLASGAL-selected massive clumps in the inner Galaxy: VI. Kinetic temperature and spatial density measured with formaldehyde
81
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
We aim to directly determine the kinetic temperature and spatial density with formaldehyde for the $sim$100 brightest ATLASGAL-selected clumps at 870 $mu$m representing various evolutionary stages of high-mass star formation. Ten transitions ($J$ = 3-2 and 4-3) of ortho- and para-H$_2$CO near 211, 218, 225, and 291 GHz were observed with the APEX 12 m telescope. Using non-LTE models with RADEX, we derive the gas kinetic temperature and spatial density using the measured p-H$_2$CO 3$_{21}$-2$_{20}$/3$_{03}$-2$_{02}$, 4$_{22}$-3$_{21}$/4$_{04}$-3$_{03}$, and 4$_{04}$-3$_{03}$/3$_{03}$-2$_{02}$ ratios. The gas kinetic temperatures derived from the p-H$_2$CO 3$_{21}$-2$_{20}$/3$_{03}$-2$_{02}$ and 4$_{22}$-3$_{21}$/4$_{04}$-3$_{03}$ line ratios are high, ranging from 43 to $>$300 K with an unweighted average of 91 $pm$ 4 K. Deduced $T_{rm kin}$ values from the $J$ = 3-2 and 4-3 transitions are similar. Spatial densities of the gas derived from the p-H$_2$CO 4$_{04}$-3$_{03}$/3$_{03}$-2$_{02}$ line ratios yield 0.6-8.3 $times$ 10$^6$ cm$^{-3}$ with an unweighted average of 1.5 ($pm$0.1) $times$ 10$^6$ cm$^{-3}$. A comparison of kinetic temperatures derived from p-H$_2$CO, NH$_3$, and the dust emission indicates that p-H$_2$CO traces a distinctly higher temperature than the NH$_3$ (2,2)/(1,1) transitions and the dust, tracing heated gas more directly associated with the star formation process. The H$_2$CO linewidths are found to be correlated with bolometric luminosity and increase with the evolutionary stage of the clumps, which suggests that higher luminosities tend to be associated with a more turbulent molecular medium. It seems that the spatial densities measured with H$_2$CO do not vary significantly with the evolutionary stage of the clumps. However, averaged gas kinetic temperatures derived from H$_2$CO increase with time through the evolution of the clumps.
rate research
Read More
For a general understanding of the physics involved in the star formation process, measurements of physical parameters such as temperature and density are indispensable. The chemical and physical properties of dense clumps of molecular clouds are strongly affected by the kinetic temperature. Therefore, this parameter is essential for a better understanding of the interstellar medium. Formaldehyde, a molecule which traces the entire dense molecular gas, appears to be the most reliable tracer to directly measure the gas kinetic temperature.We aim to determine the kinetic temperature with spectral lines from formaldehyde and to compare the results with those obtained from ammonia lines for a large number of massive clumps.Three 218 GHz transitions (JKAKC=303-202, 322-221, and 321-220) of para-H2CO were observed with the 15m James Clerk Maxwell Telescope (JCMT) toward 30 massive clumps of the Galactic disk at various stages of high-mass star formation. Using the RADEX non-LTE model, we derive the gas kinetic temperature modeling the measured para-H2CO 322-221/303-202and 321-220/303-202 ratios. The gas kinetic temperatures derived from the para-H2CO (321-220/303-202) line ratios range from 30 to 61 K with an average of 46 K. A comparison of kinetic temperature derived from para-H2CO, NH3, and the dust emission indicates that in many cases para-H2CO traces a similar kinetic temperature to the NH3 (2,2)/(1,1) transitions and the dust associated with the HII regions. Distinctly higher temperatures are probed by para-H2CO in the clumps associated with outflows/shocks. Kinetic temperatures obtained from para-H2CO trace turbulence to a higher degree than NH3 (2,2)/(1,1) in the massive clumps. The non-thermal velocity dispersions of para-H2CO lines are positively correlated with the gas kinetic temperature. The massive clumps are significantly influenced by supersonic non-thermal motions.
Deuteration has been used as a tracer of the evolutionary phases of low- and high-mass star formation. The APEX Telescope Large Area Survey (ATLASGAL) provides an important repository for a detailed statistical study of massive star-forming clumps in the inner Galactic disc at different evolutionary phases. We study the amount of deuteration using NH2D in a representative sample of high-mass clumps discovered by the ATLASGAL survey covering various evolutionary phases of massive star formation. Unbiased spectral line surveys at 3 mm were thus conducted towards ATLASGAL clumps between 85 and 93 GHz with the Mopra telescope and from 84 to 115 GHz using the IRAM 30m telescope. A subsample was followed up in the NH2D transition at 74 GHz with the IRAM 30m telescope. We determined the deuterium fractionation from the column density ratio of NH2D and NH3 and measured the NH2D excitation temperature for the first time from the simultaneous modelling of the 74 and 110 GHz line using MCWeeds. We find a large range of the NH2D to NH3 column density ratio up to 1.6+/-0.7 indicating a high degree of NH3 deuteration in a subsample of the clumps. Our analysis yields a clear difference between NH3 and NH2D rotational temperatures for a fraction of the sources. We therefore advocate observation of the NH2D transitions at 74 and 110 GHz simultaneously to determine the NH2D temperature directly. We determine a median ortho-to-para column density ratio of 3.7+/-1.2. The high detection rate of NH2D confirms a high deuteration previously found in massive star-forming clumps. Using the excitation temperature of NH2D instead of NH3 is needed to avoid an overestimation of deuteration. We measure a higher detection rate of NH2D in sources at early evolutionary stages. The deuterium fractionation shows no correlation with evolutionary tracers such as the NH3 (1,1) line width, or rotational temperature.
(Abridged) Aims: We aim to use the progressive heating of the gas caused by the feedback of high-mass young stellar objects (YSOs) to prove the statistical validity of the most common schemes used to define an evolutionary sequence for high-mass clumps, and characterise the sensitivity of different tracers to this process. Methods: From the spectroscopic follow-ups of the ATLASGAL TOP100 sample, we selected several multiplets of CH3CN, CH3CCH, and CH3OH emission lines to derive and compare the physical properties of the gas in the clumps along the evolutionary sequence. Our findings are compared with results obtained from CO isotopologues, dust, and NH3 from previous studies on the same sample. Results: The chemical properties of each species have a major role on the measured physical properties. Low temperatures are traced by NH3, CH3OH, and CO (in the early phases), the warm and dense envelope can be probed with CH3CN, CH3CCH, and, in evolved sources via CO isotopologues. CH3OH and CH3CN are also abundant in the hot cores, and their high-excitation transitions may be good tools to study the kinematics in the hot gas surrounding the YSOs that these clumps are hosting. All tracers show, to different degrees, progressive warming with evolution. The relation between gas temperature and L/M is reproduced by a toy model of a spherical, internally heated clump. Conclusions: The evolutionary sequence defined for the clumps is statistically valid and we could identify the processes dominating in different intervals of L/M. For L/M<2Lsun/Msun a large quantity of gas is still being accumulated and compressed at the bottom of the potential well. Between 2Lsun/Msun<L/M<40Lsun/Msun the YSOs gain mass and increase in L; the first hot cores appear around L/M=10Lsun/Msun. Finally, for L/M>40Lsun/Msun HII regions become common, showing that dissipation of the parental clump dominates.
The Large Magellanic Cloud (LMC), the closest star forming galaxy with low metallicity, provides an ideal laboratory to study star formation in such an environment. The classical dense molecular gas thermometer NH3 is rarely available in a low metallicity environment because of photoionization and a lack of nitrogen atoms. Our goal is to directly measure the gas kinetic temperature with formaldehyde toward six star-forming regions in the LMC. Three rotational transitions of para-H2CO near 218 GHz were observed with the APEX 12m telescope toward six star forming regions in the LMC. Those data are complemented by C18O 2-1 spectra. Using non-LTE modeling with RADEX, we derive the gas kinetic temperature and spatial density, using as constraints the measured para-H2CO 321-220/303-202 and para-H2CO 303-202/C18O 2-1 ratios. Excluding the quiescent cloud N159S, where only one para-H2CO line could be detected, the gas kinetic temperatures derived from the preferred para-H2CO 321-220/303-202 line ratios range from 35 to 63 K with an average of 47 K. Spatial densities of the gas derived from the paraH2CO 303-202/C18O 2-1 line ratios yield 0.4-2.9x10^5 cm^-3 with an average of 1.5x10^5 cm^-3. Temperatures derived from the para-H2CO line ratio are similar to those obtained with the same method from Galactic star forming regions and agree with results derived from CO in the dense regions of the LMC. A comparison of kinetic temperatures derived from para-H2CO with those from the dust also shows good agreement. This suggests that the dust and para-H2CO are well mixed in the studied star forming regions. A correlation between the gas kinetic temperatures derived from para-H2CO and infrared luminosity, represented by the 250um flux, suggests that the kinetic temperatures traced by para-H2CO are correlated with the ongoing massive star formation in the LMC.
We mapped the kinetic temperature structure of the Orion molecular cloud 1 with para-H2CO(303-202, 322-221, and 321-220) using the APEX 12m telescope. This is compared with the temperatures derived from the ratio of the NH3(2,2)/(1,1) inversion lines and the dust emission. Using the RADEX non-LTE model, we derive the gas kinetic temperature modeling the measured averaged line ratios of para-H2CO 322-221/303-202 and 321-220/303-202. The gas kinetic temperatures derived from the para-H2CO line ratios are warm, ranging from 30 to >200 K with an average of 62 K at a spatial density of 10$^5$ cm$^{-3}$. These temperatures are higher than those obtained from NH3(2,2)/(1,1) and CH3CCH(6-5) in the OMC-1 region. The gas kinetic temperatures derived from para-H2CO agree with those obtained from warm dust components measured in the mid infrared (MIR), which indicates that the para-H2CO(3-2) ratios trace dense and warm gas. The cold dust components measured in the far infrared (FIR) are consistent with those measured with NH3(2,2)/(1,1) and the CH3CCH(6-5) line series. With dust at MIR wavelengths and para-H2CO(3-2) on one side and dust at FIR wavelengths, NH3(2,2)/(1,1), and CH3CCH(6-5) on the other, dust and gas temperatures appear to be equivalent in the dense gas of the OMC-1 region, but provide a bimodal distribution, one more directly related to star formation than the other. The non-thermal velocity dispersions of para-H2CO are positively correlated with the gas kinetic temperatures in regions of strong non-thermal motion (Mach number >2.5) of the OMC-1, implying that the higher temperature traced by para-H2CO is related to turbulence on a 0.06 pc scale. Combining the temperature measurements with para-H2CO and NH3(2,2)/(1,1) line ratios, we find direct evidence for the dense gas along the northern part of the OMC-1 10 km s$^{-1}$ filament heated by radiation from the central Orion nebula.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
