Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userStructural and electronic properties of ultrathin FeSe films grown on Bi$_2$Se$_3$(0001) studied by STM/STS
165
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
We report scanning tunnelling microscopy and spectroscopy (STM/STS) studies on one and two unit cell (UC) high FeSe thin films grown on Bi$_2$Se$_3$(0001). In our thin films, we find the tetragonal phase of FeSe and dumb-bell shaped defects oriented along Se-Se bond directions. In addition, we observe striped moire patterns with a periodicity of ($7.3pm 0.1$) nm generated by the mismatch between the FeSe lattice and the Bi$_2$Se$_3$ lattice. We could not find any signature of a superconducting gap in the tunneling spectra measured on the surface of one and two UC thick islands of FeSe down to 6.5 K. The spectra rather show an asymmetric behavior across and a finite density of states at the Fermi level ($E_F$) resembling those taken in the normal state of bulk FeSe.
rate research
Read More
In this paper we present detailed study of the density of states near defects in Bi$_2$Se$_3$. In particular, we present data on the commonly found triangular defects in this system. While we do not find any measurable quasiparticle scattering interference effects, we do find localized resonances, which can be well fitted by theory once the potential is taken to be extended to properly account for the observed defects. The data together with the fits confirm that while the local density of states around the Dirac point of the electronic spectrum at the surface is significantly disrupted near the impurity by the creation of low-energy resonance state, the Dirac point is not locally destroyed. We discuss our results in terms of the expected protected surface state of topological insulators.
Our recent years studies of the prototypal FeSe and molecule-intercalated (Li,Fe)OHFeSe superconductor systems are briefly reviewed here, with emphasis on experimental observations of the link between the superconductivity and normal-state electronic property in the single crystals and films. These samples were successfully synthesized by our recently developed soft-chemical hydrothermal methods, which are also briefly described. Particularly in the Mn-doped high-Tc (Li,Fe)OHFeSe film, a strong enhancement of the superconducting critical current density was achieved, which is promising for practical application of the superconductivity.
Structural, magnetic and magnetotransport properties of (Bi$_{1-x}$Eu$_x$)$_2$Se$_3$ thin films have been studied experimentally as a function of Eu content. The films were synthesized by MBE. It is demonstrated that Eu distribution is not uniform, it enter quint-layers forming inside them plain (pancake-like) areas containing Eu atoms, which sizes and concentration increase with the growth of Eu content. Positive magnetoresistance related to the weak antilocalization was observed up to 15K. The antilocalization was not followed by weak localization as theory predicts for nontrivial topological states. Surprisingly, the features of antilocalization were seen even at Eu content $x$ $=$ 0.21. With the increase of Eu content the transition to ferromagnetic state occurs at $x$ about 0.1 and with the Curie temperature $approx$ 8K, that rises up to 64K for $x$ $=$ 0.21. At temperatures above 1-2 K, the dephasing length is proportional to $T^{-1/2}$ indicating the dominant contribution of inelastic $e-e$ scattering into electron phase breaking. However, at low temperatures the dephasing length saturates, that could be due to the scattering on magnetic ions.
An archetypical layered topological insulator Bi$_2$Se$_3$ becomes superconductive upon doping with Sr, Nb or Cu. Superconducting properties of these materials in the presence of in-plane magnetic field demonstrate spontaneous symmetry breaking: 180$^circ$-rotation symmetry of superconductivity versus 120$^circ$-rotation symmetry of the crystal. Such behavior brilliantly confirms nematic topological superconductivity. To what extent this nematicity is due to superconducting pairing in these materials, rather than due to crystal structure distortions? This question remained unanswered, because so far no visible deviations from the 3-fold crystal symmetry were resolved in these materials. To address this question we grow high quality single crystals of Sr$_x$Bi$_2$Se$_3$, perform detailed X-ray diffraction and magnetotransport studies and reveal that the observed superconducting nematicity direction correlates with the direction of small structural distortions in these samples( $sim 0.02$% elongation in one crystallographic direction). Additional anisotropy comes from orientation of the crystallite axes. 2-fold symmetry of magnetoresistance observed in the most uniform crystals well above critical temperature demonstrates that these structural distortions are nevertheless strong enough. Our data in combination with strong sample-to-sample variation of the superconductive anisotropy parameter are indicative for significance of the structural factor in the apparent nematic superconductivity in Sr$_x$Bi$_2$Se$_3$.
In the present work we study the growth by pulsed laser deposition of YBa$_2$Cu$_3$O$_{7-delta}$ (YBCO) films on the r-cut sapphire substrates. To improve the matching of the lattice parameters between the substrate and the film we use CeO$_{2}$ buffer layer, recrystallized prior to the deposition of YBCO. The optimal thickness and temperature of recrystallization of the buffer layer is first determined using atomic force microscopy (AFM) and X-ray diffraction. Next, we use the AFM to examine the dependence of YBCO film roughness on the film thickness, and we study the homogeneity of magnetic flux penetration into the films by magneto-optical imaging. We find that the superconducting critical temperature and critical current density of these films are very similar to those of YBCO films grown on well-matched substrates. It appears that the microstructure of YBCO films is affected by structural defects in the buffer layer as well as variations in oxygen deficiency, which results in high values of critical current density suitable for application.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
