Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userMassive MIMO Full-Duplex Relaying with Optimal Power Allocation for Independent Multipairs
137
0
0.0
(
0
)
Added by
Francisco Monteiro
Publication date
2015
fields
Informatics Engineering
and research's language is
English
Ask ChatGPT about the research
No Arabic abstract
With the help of an in-band full-duplex relay station, it is possible to simultaneously transmit and receive signals from multiple users. The performance of such system can be greatly increased when the relay station is equipped with a large number of antennas on both transmitter and receiver sides. In this paper, we exploit the use of massive arrays to effectively suppress the loopback interference (LI) of a decode-and-forward relay (DF) and evaluate the performance of the end-to-end (e2e) transmission. This paper assumes imperfect channel state information is available at the relay and designs a minimum mean-square error (MMSE) filter to mitigate the interference. Subsequently, we adopt zero-forcing (ZF) filters for both detection and beamforming. The performance of such system is evaluated in terms of bit error rate (BER) at both relay and destinations, and an optimal choice for the transmission power at the relay is shown. We then propose a complexity efficient optimal power allocation (OPA) algorithm that, using the channel statistics, computes the minimum power that satisfies the rate constraints of each pair. The results obtained via simulation show that when both MMSE filtering and OPA method are used, better values for the energy efficiency are attained.
rate research
Read More
This paper considers a multipair amplify-and-forward massive MIMO relaying system with low-resolution ADCs at both the relay and destinations. The channel state information (CSI) at the relay is obtained via pilot training, which is then utilized to perform simple maximum-ratio combining/maximum-ratio transmission processing by the relay. Also, it is assumed that the destinations use statistical CSI to decode the transmitted signals. Exact and approximated closed-form expressions for the achievable sum rate are presented, which enable the efficient evaluation of the impact of key system parameters on the system performance. In addition, optimal relay power allocation scheme is studied, and power scaling law is characterized. It is found that, with only low-resolution ADCs at the relay, increasing the number of relay antennas is an effective method to compensate for the rate loss caused by coarse quantization. However, it becomes ineffective to handle the detrimental effect of low-resolution ADCs at the destination. Moreover, it is shown that deploying massive relay antenna arrays can still bring significant power savings, i.e., the transmit power of each source can be cut down proportional to $1/M$ to maintain a constant rate, where $M$ is the number of relay antennas.
In-band full-duplex transmission allows a relay station to theoretically double its spectral efficiency by simultaneously receiving and transmitting in the same frequency band, when compared to the traditional half-duplex or out-of-band full-duplex counterpart. Consequently, the induced self-interference suffered by the relay may reach considerable power levels, which decreases the signal-to-interference-plus-noise ratio (SINR) in a decode-and-forward (DF) relay, leading to a degradation of the relay performance. This paper presents a technique to cope with the problem of self-interference in broadband multiple-input multiple-output (MIMO) relays. The proposed method uses a time-domain cancellation in a DF relay, where a replica of the interfering signal is created with the help of a recursive least squares (RLS) algorithm that estimates the interference frequency-selective channel. Its convergence mean time is shown to be negligible by simulation results, when compared to the length of a typical orthogonal-frequency division multiplexing (OFDM) sequences. Moreover, the bit-error-rate (BER) and the SINR in a OFDM transmission are evaluated, confirming that the proposed method extends significantly the range of self-interference power to which the relay is resilient to, when compared with other mitigation schemes.
We consider a full-duplex decode-and-forward system, where the wirelessly powered relay employs the time-switching protocol to receive power from the source and then transmit information to the destination. It is assumed that the relay node is equipped with two sets of antennas to enable full-duplex communications. Three different interference mitigation schemes are studied, namely, 1) optimal 2) zero-forcing and 3) maximum ratio combining/maximum ratio transmission. We develop new outage probability expressions to investigate delay-constrained transmission throughput of these schemes. Our analysis show interesting performance comparisons of the considered precoding schemes for different system and link parameters.
The hybrid half-duplex/full-duplex (HD/FD) relaying scheme is an effective paradigm to overcome the negative effects of the self-interference incurred by the full-duplex (FD) mode. However, traditional hybrid HD/FD scheme does not consider the diversity gain incurred by the multiple antennas of the FD node when the system works in the HD mode, leading to the waste of the system resources. In this paper, we propose a new hybrid HD/FD relaying scheme, which utilizes both the antennas of the FD relay node for reception and transmission when the system works in the HD mode. With multiple antennas, the maximum ratio combining/maximum ratio transmission is adopted to process the signals at the relay node. Based on this scheme, we derive the exact closed-form system outage probability and conduct various numerical simulations. The results show that the proposed scheme remarkably improves the system outage performance over the traditional scheme, and demonstrate that the proposed scheme can more effectively alleviate the adverse effects of the residual self-interference.
In this paper, we deal with the performance analysis of full-duplex relaying in decode-&-forward cooperative networks with multiple-antenna terminals. More specifically, by analyzing the end-to-end statistics, we derive the accurate closed-form expressions of the end-to-end outage probability for both transmit and receive ZFBF scheme over Rayleigh fading environments. Some selected results show some interesting observations useful for system designers. Specifically, we observe that the outage performance can be improved by adopting the joint ZF-based precoding with different antenna configurations.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
