Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userSearch for a liquid-liquid critical point in models of silica
405
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
Previous research has indicated the possible existence of a liquid-liquid critical point (LLCP) in models of silica at high pressure. To clarify this interesting question we run extended molecular dynamics simulations of two different silica models (WAC and BKS) and perform a detailed analysis of the liquid at temperatures much lower than those previously simulated. We find no LLCP in either model within the accessible temperature range, although it is closely approached in the case of the WAC potential near 4000 K and 5 GPa. Comparing our results with those obtained for other tetrahedral liquids, and relating the average Si-O-Si bond angle and liquid density at the model glass temperature to those of the ice-like beta-cristobalite structure, we conclude that the absence of a critical point can be attributed to insufficient stiffness in the bond angle. We hypothesize that a modification of the potential function to mildly favor larger average bond angles will generate a LLCP in a temperature range that is accessible to simulation. The tendency to crystallize in these models is extremely weak in the pressure range studied, although this tendency will undoubtedly increase with increasing stiffness.
rate research
Read More
Recently it was shown that the WAC model for liquid silica [L. V. Woodcock, C. A. Angell, and P. Cheeseman, J. Chem. Phys. 65, 1565 (1976)] is remarkably close to having a liquid-liquid critical point (LLCP). We demonstrate that increasing the ion charge separates the global maxima of the response functions, while reducing the charge smoothly merges them into a LLCP; a phenomenon that might be experimentally observable with charged colloids. An analysis of the Si and O coordination numbers suggests that a sufficiently low Si/O coordination number ratio is needed to attain a LLCP.
The study of liquid-liquid phase transition has attracted considerable attention. One interesting example of such phenomenon is phosphorus for which the existence a first-order phase transition between a low density insulating molecular phase and a conducting polymeric phase has been experimentally established. In this paper, we model this transition by an ab-initio quality molecular dynamics simulation and explore a large portion of the liquid section of the phase diagram. We draw the liquid-liquid coexistence curve and determine that it terminates into a second-order critical point. Close to the critical point, large coupled structure and electronic structure fluctuations are observed.
Based on the method of collective variables we develop the statistical field theory for the study of a simple charge-asymmetric $1:z$ primitive model (SPM). It is shown that the well-known approximations for the free energy, in particular DHLL and ORPA, can be obtained within the framework of this theory. In order to study the gas-liquid critical point of SPM we propose the method for the calculation of chemical potential conjugate to the total number density which allows us to take into account the higher order fluctuation effects. As a result, the gas-liquid phase diagrams are calculated for $z=2-4$. The results demonstrate the qualitative agreement with MC simulation data: critical temperature decreases when $z$ increases and critical density increases rapidly with $z$.
A novel liquid-liquid phase transition has been proposed and investigated in a wide variety of pure substances recently, including water, silica and silicon. From computer simulations using the Stillinger-Weber classical empirical potential, Sastry and Angell [1] demonstrated a first order liquid-liquid transition in supercooled silicon, subsequently supported by experimental and simulation studies. Here, we report evidence for a liquid-liquid critical end point at negative pressures, from computer simulations using the SW potential. Compressibilities exhibit a growing maximum upon lowering temperature below 1500 K and isotherms exhibit density discontinuities below 1120 K, at negative pressure. Below 1120 K, isotherms obtained from constant volume-temperature simulations exhibit non-monotonic, van der Waals-like behavior signaling a first order transition. We identify Tc ~ 1120 +/- 12 K, Pc -0.60 +/- 0.15 GPa as the critical temperature and pressure for the liquid-liquid critical point. The structure of the liquid changes dramatically upon decreasing the temperature and pressure. Diffusivities vary over 4 orders of magnitude, and exhibit anomalous pressure dependence near the critical point. A strong relationship between local geometry quantified by the coordination number, and diffusivity, is seen, suggesting that atomic mobility in both low and high density liquids can usefully be analyzed in terms of defects in the tetrahedral network structure. We have constructed the phase diagram of supercooled silicon. We identify the lines of compressibility, density extrema (maxima and minima) and the spinodal which reveal the interconnection between thermodynamic anomalies and the phase behaviour of the system as suggested in previous works [2-9]
We examine the applicability of various model profiles for the liquid/vapor interface by X-ray reflectivities on water and ethanol and their mixtures at room temperature. Analysis of the X-ray reflecivities using various density profiles shows an error-function like profile is the most adequate within experimental error. Our finding, together with recent observations from simulation studies on liquid surfaces, strongly suggest that the capillary-wave dynamics shapes the interfacial density profile in terms of the error function.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
